Mitsubishi Electric HC 3200 Projector Instruction manual

Below you will find brief information for Projector HC 3200. The Projector HC 3200 is a projector that can be controlled from a PC with an RS-232C terminal. The RS-232C connection allows you to control various functions of the projector, including power ON/OFF, input signal switching, button presses, and menu settings. A cross cable is required for the RS-232C connection. This guide provide detailed instructions on how to make the connection and control the projector via RS-232C.

PDF Download
Document
Projector HC 3200 Instruction Manual - Mitsubishi Electric | Manualzz

Advertisement

Advertisement

Advertisement

Key features

  • RS-232C control
  • Power ON/OFF
  • Input signal switching
  • Button presses
  • Menu settings
  • Cross cable required
  • Stand-by mode
  • Password lock
  • Splash screen

Frequently asked questions

Connect the projector to a personal computer with RS-232C terminal using a cross cable. Make sure that your computer and projector are turned off before connection. Boot up the computer first, and then plug the power cord of the projector.

You can control a number of functions such as turning the power ON or OFF, changing input signals, inputting commands by pressing the buttons on the control panel and remote control, and menu setting.

The interface settings for the connection are: Protocol: RS-232C, Baud Rate: 9600 [bps], Data Length: 8 [bits], Parity Bit: NONE, Stop Bit: 1 [bit], Flow Control: NONE. This projector uses RXD, TXD, and GND lines for RS-232C control. The cross cable should be used.

You need to send the PSLOCK command with a 4 to 8-digit password comprised of any figures 1 to 4 added to the end of the data code. For example, if the password is 123412, the command would be: '0' '0' 'P' 'S' 'L' 'O' 'C' 'K' '1' '1' '2' '3' '4' '1' '2' ' '.

After sending the command '0' '0' 'v' 'I' ' ', the projector sends back a return command with the data code indicating the current input terminal. For example, if the INPUT VIDEO is selected, the projector will send back the code '0' '0' 'v' 'I' 'v' '1' ' '.

To set the CONTRAST of the COLOR TEMP.-USER, you need to send the 'P' command with the data code for each color: R, G, and B. For example, to set the CONTRAST R to +10, the CONTRAST G to 0, and the CONTRAST B to -5, the command would be: '0' '0' 'P' '+' '1' '0' '+' '0' '0' '-' '0' '5' ' '.
Preparing document for printing…
0%