Dear Audi Driver, This quick reference guide gives you a brief introduction to the main features and controls of your vehicle. However, it cannot replace the Owner’s Manual which contains important information and safety warnings. We wish you safe and enjoyable motoring with your Audi. AUDI AG Locking and unlocking the vehicle The central locking system locks and unlocks all the doors, the boot lid and the tank flap. It can be operated with the remote control or by 4 turning the key in the lock. Opening windows with remote control key: To open the windows first press button e and then turn the key to the right in the driver’s door lock and hold it in this position (applies to RHD vehicles). Closing windows with remote control key: 3 Quick reference guide 2 1 Turn the key to the left in the driver’s door lock and hold it in this position (applies to RHD vehicles). Opening/closing soft top with remote control key: To open, press button e and briefly turn the key to the right in the driver’s door lock. Then, within 2 seconds, turn the key to the right again and hold it in Remote control keys Press the appropriate button for about 1 second. e Unlocking button: Open one of the doors within about 60 seconds, otherwise the vehicle will lock itself this position (RHD vehicles). To close, briefly turn the key to the left in the driver’s door lock. Then, within 2 seconds, turn the key to the left again and hold it in this position (RHD vehicles). again automatically. r Anti-theft alarm Unlocking button for boot lid: The alarm system is automatically set when you lock Press the button for at least 1 second. t the car, and switched off when you unlock the car Locking button: The turn signals flash once to with the remote control. If you unlock the vehicle by confirm that the doors and boot lid are properly inserting the key in the driver’s door, the ignition closed and locked. u must be switched on within 15 seconds, otherwise Folding out the master key: the alarm will be triggered. Press the release button. WARNING! Folding in the master key: Press the button and fold in the key. The doors and windows cannot be opened from inside the vehicle if it has been locked from the Variable soft top storage box outside. The storage box can be raised in order to extend the luggage compartment. To raise the storage box: Slide the operating lever to position A. To lower the storage box: Slide the operating lever to position B. Note: The lever for raising/lowering the variable soft top storage box can only be operated when the soft top is closed. Page 1 A B 1 Locking and unlocking the vehicle · Variable soft top storage box Audi A4 Cabriolet Audi S4 Cabriolet Convenience features Safety Adjust seat and sit in correct position The front seats should not be positioned too Seat belts must be worn on every journey, even on short trips in town. This close to the steering wheel or dashboard. applies to the front and rear seats. To ensure that the seat belts, belt Maintain a distance of at least 25 cm and sit in tensioners and airbags are fully effective, please note the following points: a normal upright position. The top of the head Wear the seat belt correctly restraint should be at eye level or higher. Make sure that the shoulder section of Always keep your feet in the footwell. the belt is positioned over the centre of Safety of children in the vehicle 25 cm the shoulder and move the lap section Children under 12 should travel as far down over the hips as possible. on the rear seat. They must be The belts should always be worn so protected by a child restraint that they fit tightly (see illustration). system which complies with the European standard ECE-R 44 and is Roll-over bars The roll-over bars provide a further safety system for all suitable for the child’s height and weight. vehicle occupants, in addition to the seat belts and air- The safest place for the child restraint system is behind the front passenger’s seat. bags. The roll-over bars are located behind the head restraints for the rear seats. Never store or secure any WARNING! objects in the area behind the rear head restraints. Please follow the instructions in the Owner's Manual supplied with your Audi and read the instructions Adjusting front seats provided by the child seat manufacturer. Manual adjustment Electrical adjustment Adjusting head restraints s Raising head restraint: Take hold of the sides of the head position Lowering head restraint: Press the button on the side of the down/return it to its upright position. Unlocking the backrest Press front/back end of switch A to 9 Lift the lever and fold the backrest down/ 2 return it to its upright position. t Lift the lever and fold the backrest 1 head restraint and move the head restraint as required. r move the seat forwards/backwards. d A Adjusting angle of backrest or forwards Adjusting lumbar support Press the switch in the direction Press appropriate part of the switch. i Adjusting seat height and moving seat backwards Lean forwards and turn adjuster wheel. u Folding the backrest down/ returning it to its upright restraint with both hands and move it up as required. 10 11 12 indicated by the arrows: To raise/lower the seat at the front Adjusting seat height To raise/lower the seat at the rear Lift or press the lever repeatedly until the seat reaches the desired height. To raise/lower the seat o To move the seat forwards/ Adjusting seat angle Lift or press the lever repeatedly until the seat reaches the desired height. p Adjusting seat cushion 3 7 8 5 4 backwards f Press the switch in the direction indicated by the arrows: Lift the button and move the seat cushion. a Moving seat backwards or forwards Adjusting backrest Backrest further upright/ 6 further reclined Lift the lever and move the seat into the desired position. g Then release the lever and move the seat further until the catch engages. Press the appropriate part of the switch. Page 2 Adjusting lumbar support 1 Safety · Adjusting front seats e Instruments 3 2 4 1 5 9 10 e r t u i o 8 7 6 s Display for: Coolant temperature gauge Rev counter p Driver messages (soft top etc.) Warning and indicator lamps p Warning symbols and auto-check control p Radio, CD and telephone Speedometer p Navigation system Fuel gauge p Outside temperature Reset button for trip recorder p On-board computer (with two memories) Press the button until the display is reset to zero. p Selector lever position p Button for service indicator p Service indicator Press the button briefly when the vehicle is stationary d Adjuster buttons for: and the ignition is switched on. A service reminder p Instrument lighting appears briefly if a service inspection is due in the To adjust, press button near future. + or . p Digital clock and date a Check button for: Press the p Activating mileage recorder display and clock button until the desired display MODE (e.g. hour) starts to flash. To adjust, press button + Press button with ignition switched off. or . p Calling up driver messages again Filling the tank Press button briefly when desired speed is reached. Opening the tank flap To cancel: press button for at least 1 second while Open the tank flap by pressing it in the direction vehicle is moving. indicated by the arrow. Unscrew the tank cap and hook it onto the flap (see illustration). © 2007 AUDI AG AUDI AG reserves the right to alter any part of the vehicle, its equipment and technical specifications. No legal commitment can be implied by the information, illustrations or descriptions in this publication. No part of this publication may be reprinted, reproduced or translated without the written permission of AUDI AG. All rights under the laws of copyright are expressly reserved by AUDI AG. Subject to alteration and amendment. Printed in Germany. Concept and layout: Pfriemer GmbH. Fuel grade The correct fuel grade for your vehicle is shown on the inside of the tank flap. Note: The sticker listing the tyre pressures is located on the front passenger’s door pillar. Page 3 1 Instruments · Filling the tank Press button briefly when warning symbol appears. p Setting speed warning 1 Warning and indicator lamps Instruments and controls Emission control system1) Turn signals, hazard warning lights Airbag system1) Electronic Stability Program (ESP) Cruise control system Alternator1) 8 7 18 11 9 13 Trailer turn signals Main beam headlights 1) Anti-lock brake system Engine management or 4 5 6 1) 1) Seat belt warning lamp Glow plugs (on diesel models) Soft top operation Fault in brake system or handbrake engaged 17 10 10 1) 14 15 16 19 34 20 12 3 2 33 Should one of these warning symbols or warning lamps light up when driving, please contact a qualified workshop without delay. 21 32 35 25 24 26 23 22 27 1 Warning symbols and auto-check control 7 .....Lever for turn signals and main beam headlights , 8 .....Instruments and warning/indicator lamps 9 .....Horn 10 ...Controls for multifunction steering wheel Any faults which may occur are indicated by red or yellow symbols in the instrument cluster display. 36 Fault in brake system Fault in cooling system Engine oil pressure too low Tyre pressure too low The yellow symbols are not explained in this Quick reference guide, as some symbols are automatically accompanied by a corresponding message, which is shown in the display for about 5 seconds. Please refer to the Owner’s Manual for an explanation of the symbols for which no message appears in the display. Note: If required, you can call up a message again by briefly pressing the CHECK button. Audi A4/S4 Cabriolet Kurzanleitung englisch 5.07 281.562.684.20 1 Warning and indicator lamps 5 Instruments and controls · Windbreak WARNING! If one of the red symbols lights up while you are driving, stop the car, switch off the engine and refer to the Owner’s Manual. 1 .....Electric windows Press or lift the switch and keep holding until the window has reached the desired position. 2 .....Door handle 3 .....Central locking switch Press the appropriate symbol to unlock or lock the vehicle from the inside: To unlock To lock 4 .....Electric adjuster for exterior mirrors Turn the adjuster to the position for the left or right exterior mirror. Press the adjuster to move the mirror surface in the desired direction. Note: At low outside temperatures, the mirrors are heated automatically when the rear window heating is switched on. 5 .....Light switch , 6 .....Headlight range control and coming home/leaving home switch/switch for daytime running lights Please read Owner’s Manual. 11 ...Control lever for windscreen wipers/washer and on-board computer , 12 ...Ignition lock 13 ...Switch for Electronic Stabilisation Program (ESP) 14 ...PASSENGER AIRBAG OFF display 15 ...Switch for acoustic parking system 16 ...Switch for hazard warning lights 17 ...Cup holder 18 ...Compartment for (sun)glasses 19 ...Sound system or navigation system 20 ...Glove box 21 ...Switches for air conditioner , 22 ...Thumbwheel for seat heating (front right seat) 23 ...Switch for rear window heating 24 ...Switch for windscreen heating 25 ...Thumbwheel for seat heating (front left seat) , Further information for these items is given on the following pages. Page 4 28 31 29 30 26 ...Gear lever/selector lever (on vehicles with automatic gearbox) , 27 ...Ashtray 28 ...Storage compartment 29 ...Soft top control switch , 30 ...Cigarette lighter/socket 31 ...Handbrake 32 ...Service Wallet compartment 33 ...Lever for adjustable steering column , 34 ...Control lever for cruise control system Please refer to the Owner’s Manual for operating instructions. 35 ...Bonnet release lever Please read Owner’s Manual. 36 ...Memory buttons for driver's seat Please read Owner’s Manual. 1 1 2 3 4 5 7 6 4  Switches for air conditioner e Automatic mode (set the desired temperature for the driver and passenger and press the corresponding button) r Air recirculation (circulates and filters the air in the interior of the vehicle) t u i o p ECON mode (deactivates air cooling) Temperature selection (driver’s side/front passenger’s side) Automatic air recirculation Blower speed Air flow settings Note: The air conditioner settings are stored and assigned to the remote control key, taking into account whether the soft top is open or closed. When the vehicle is started again the stored settings will automatically be recalled.  Lever for adjustable steering column Push lever down and adjust position of the steering column as required. Then push the lever back up.  Light switch e Off r 1 AUTO When the light switch is set to AUTO, the dipped beam headlights will be 5 switched on and off automatically 2 according to the outside light 3 6 4 conditions (only on vehicles with a light sensor). t u Side lights Dipped beam/main beam headlights In fog, turn switch to dipped headlights position and then pull out to 1st stop (i front fog lights) or to 2nd stop (o front and rear fog lights). Page 5  Lever for turn signals and main beam headlights e r t u  Control lever for windscreen wipers/washer and on-board computer Right turn signals (with ignition off: right parking light on) Left turn signals (with ignition off: left parking light on) Wipers off Main beam headlights e r Headlight flasher 1 Brief wipe 4 3 5 4 alter the wiper delay intervals. 3 A t u i 2 0 B 2 Slow wiper speed Fast wiper speed Automatic wash and wipe: Pull lever towards you and hold. 1 C Intermittent wipe: Move control A to Controls for on-board computer Press the top or bottom of rocker switch B repeatedly to display the various computer functions in turn. Press and hold RESET button C to return the current display to zero.  Soft top control switch RESET/selector button Opening the soft top Pull up and hold the switch until the soft top is fully open. Press the RESET button C repeatedly to switch between the informa- Closing the soft top tion supplied by the on-board computer, the navigation system and Press and hold the switch until the soft top is completely closed. the menu display. Use rocker switch B to highlight a menu function (e.g. tyre pressure). Then activate the function by pressing the RESET Notes: If the control switch is released during the opening/closing button C. operation, the soft top will stop moving. The soft top is completely open/closed when the warning lamp in the instrument cluster goes out. The soft top can only be opened or closed when the ignition is switched on. For information on how to open/close the soft top manually please refer to the Owner’s Manual. Windbreak  Selector lever for automatic gearbox Installing: Selector lever positions Take the windbreak out of the bag (in luggage P Parking lock R Reverse gear N Neutral D Drive S Sport A compartment) and fold the two side sections outwards. Pull out the two retainer pegs A To move the selector lever out of position P or N, and hold the windbreak in a or into position P or R, press the interlock button horizontal position against the on the selector lever handle and the brake pedal backrest upholstery. Slide the simultaneously. two retainer pegs A all the way Note: Use the foot brake to hold the vehicle when into the mountings. stationary with the engine running (in all selector Press the release catches B lever positions other than P). (on left and right) and slide the C WARNING! B Do not move the selector lever to positions P or R when the vehicle is moving. locking pins into the mounting holes C at the sides. Fold up the vertical section of the windbreak so that it engages in the upright Manual gear selection (tiptronic) The tiptronic program enables you to change gear manually. Move the selector lever out of position D into the tiptronic gate on the right. Press the selector lever forwards briefly to shift up a gear, or push the lever back to shift down a gear. Page 6 position. Removing: Proceed in the reverse sequence of the installation described above.