Alpine TRUCK-G800 Installation Manual
Advertisement
Advertisement
TRUCK-G800
Installation Manual
Trucking Software for
INE-W987D / X800D-U / X800D-ML
English
September 2014, Version 1.0
Installation instructions for INE-W987D / X800D-U / X800D-ML:
The Software on the TRUCK-G800 SD card upgrades your INE-W987D and
X800D-U / X800D-ML unit with the trucking feature. It can also be used for mobile homes and caravans.
1) Power on the navigation device.
2) Press the hard key "Open / Tilt", then, press the soft key "SD".
3) Remove the protective cover of the SD card and remove the SD card itself.
4) Insert the SD card TRUCK-G800 and attach the protective cover.
5) Press the soft key "Close".
6) Switch off ACC and wait a minute.
The navigation device is then ready to use.
Please note:
Make sure to insert the TRUCK-G800 SD card before you access https://alpine.naviextras.com
for map and content updates. After the SD card is inserted, trucking specific map and content updates will be available at https://alpine.naviextras.com
.
How to adjust truck specific settings in the Navigation Software:
1) Press the hard key "Navigation" and touch the "Settings" symbol
from the Navigation Main Menu.
2) Touch "Route Settings", and then touch "Vehicle".
3) For mobile homes and caravans: Select "Default Car".
For trucks (heavy good vehicles): Select "Default Lorry".
4) Touch the "Settings" symbol in the "Default Car" / "Default Lorry"
selection bar to access the settings menus for the trucking feature
allowing you to customize and adjust values applicable to your vehicle.

Public link updated
The public link to your chat has been updated.
Advertisement