advertisement
▼
Scroll to page 2
SPECIFICATIONS Nominal Input Level ................ -20 dBu Input Impedance...................... 1 MQ Nominal Output Level............. -20 dBu Output Impedance.................... 1kQ Equivalent Input Noise Level....-110 dBu (IHF-A Weighted, Typ.) Compression Range.................. 38 dB Controls ОВО CS-3 Compression Sustainer Pedal Switch, LEVEL Knob, TONE Knob, ATTACK Knob, SUSTAIN Knob Indicator CHECK Indicator (Serves also as battery check indicator) CONNECtOIS ….………rrrrceresercreusre INPUT Jack, OUTPUT Jack, AC Adaptor Jack (DC 9 V) Power Supply .......................... DC 9 V: Dry Battery (6F22/ 9 V), AC Adaptor (PSA Series: Optional) Current Draw ................e...em.m. 11 mA (DC 9 V) * Expected battery life under continuous use: Carbon: 24 hours | These figures will vary depending on the actual conditions of use. Dimensions ..............eemerieieeece 73 (W) x 129 (D) x 59 (H) mm 2-7/8 (W) x 5-1/8 (D) x 2-3/8 (H) inches Weight 400 g/ 15 oz (including battery) ACCESSOTrIeS coven, Owner's Manual, Dry Battery; 6F22/ 9 V(Carbon), Leaflet (“USING THE UNIT SAFELY,” “IMPORTANT NOTES,” and “Information”) Option AC Adaptor PSA-Series * 0 dBu = 0.775 Vrms * In the interest of product improvement, the specifications and/or appearance of this unit are subject to change without prior notice. VBOSS G601721302 2002-2-D3-2y BOSS Corporation INSTRUCTIONS Please read the instructions carefully. The BOSS CS-3 is a compression sustainer that produces long sustain without distorting the original sounds. The attack volume adjusts picking forth widely and provides any drive: | sound. As having the tone control function, the CS-3 allows wider variation of ‘sound creation. More- over, featuring the wide range of - maximum input level and compres- sion range, it can be used for any electronic musical instrument. In addition, the CS-3 can be used as an ordinay fimiter by turning down the sustain volume. «= AC & BATTERY E POWERED == PANEL DESCRIPTION AC Adaptor Jack e Check Indicator Level Knob This knob changes the volume of the effect sound. Rotating it clockwise increases the volume and counterclockwise decreases. Therefore, this knob can be effectively used to adjust volume balance of the effect and direct sounds. Tone Control Pedal Switch Push this pedal to turn the effect on (LED on), and push it again to turn the effect off (LED off). * The FET Switching system amazingly reduces click noise, so that studio recording and live per- formance will now be even more successffully achieved. Level Knob Sustain Knob Rotating this knob clockwise emphasizes the AC Adaptor Jack Tone Konb Attack Knob higher frequency making sharper sounds. Counter- — Connectan AC adaptor (BOSS PSA-Series) to this clockwise rotation cuts the higher frequency jack for AC operation. Output Jack Input Jack making softer sounds. Input Jack Attack Knob This 1s to connect an electric guitar, or other elec- This adjusts the intensity of the attack in the pick- tronic musical instrument. Ing. At its clockwise position, the attack sound is Plugging the power cord into this jack turns the Pedal Switch retained in each note even in fast picking, creating power to the CS-3 on. So please disconnect the drive sound. cord when the unit is not to be used. Sustain Knob Output Jack This knob adjusts the sustain time. Rotating this Connect this jack to the external device such as knob clockwise increases the sustain time. By amplifier. rotating it counterclockwise, the output level is li- Thumb Screw mited, therefore the CS-3 works as a limiter. Loosen this thumb screw to open the pedal cover Check Indicator for battery replacement. Please do not remove the This serves as an effect ON/OFF indicator as well screw from the pedal cover, or you may lose it. * Thumb Screw as battery check. This lights up when the effect is turned on and goes out when off. IMPORTANT == CONNECTION * When operating the CS-3 from the AC line, use the BOSS AC Adaptor (PSA-Series). * Avoid using the CS-3 in extreme heat, hu- midity or where it may be affected by dust. Before using this unit, carefully read "USING THE UNIT SAFELY" and "IM- PORTANT NOTES" on a different pa- per. 1 AC Adaptor (PSA-Series; Optional) OUT DC 9V / 200 mA C0000 ЭТО © © FG Amplifier € DVBOSS IM Electric Guitar ( Unplug the power cable when the CS-3 is not to be used. ) == OPERATION 1 After making all the connections, set the panel as shown 4 LEVEL Press the Pedal Switch to turn the effect on (LED on), LEVEL TONE ATTACK SUSTAIN - | | left. and adjust the volume of the effect sound using the © © © © Level Knob. Min MAX Lo m MIN MAX MIN MAX MIN MAX 2 Press the Pedal Switch. If the indicator lights up, the ef- 5 ATTACK Adjust the intensity of the attack with the Attack Knob. Ч fect is on, and if not, the effect is off. * This indicator also serves as battery check. If it becomes dimmer or does not light at all, battery replacement is re- MIN MAX quired. 3 SUSTAIN SUSTAIN Rotate the Sustain Knob to an appropriate position. 6 TONE Control the tone of the sound with the Tone Control Knob. * As you turn the Sustain Knob clockwise, you may hear noise or howling. If so, rotate it slightly counterclickwise. e . . e e e MIN MAX MIN MAX LO HI Using the CS-3 Using the CS-3 as a Compressor as a Limiter В CAUTIONS FOR REPLACING AND HANDLING BATTERY CAUTION * Inserting a plug into the INPUT Jack will automatically switch the unit on. REPLACING BATTERY * To prevent malfunction and/or damage to speakers or other devices, always turn down the volume, and USE ONE 9-VOLT BATTERY. turn off the power on all devices before making any connections. PEDAL (COVER) * If there are batteries in the unit while an AC adaptor is being used, normal operation will continue should @Loosen ‘the screw to open the pedal and SCREW the line voltage be interrupted (power blackout or power cord disconnection). take out the battery from the battery housing. * Once the connections have been completed, turn on power to your various devices in the order specified. | By turning on devices in the wrong order, you risk causing malfunction and/or damage to speakers and @Replace the battery with a new one. SPRING BASE other devices. When powering up: Turn on the power to your guitar amp last. OSet the coil spring onto the spring base on When powering down: — Turn off the power to your guitar amp first. the back of the pedal and shut the pedal COIL SPRING elo 16 DECK of the р | pedal. * Always make sure to have the volume level turned down before switching on power. Even with the volume Finally. insert the screw into the pedal guide all the way down, you may still hear some sound when the power is switched on, but this is normal, and and tighten it. PEDAL does not indicate a malfunction. At this time, о careful not о catch the bat GUIDE * When operating on battery power only, the unit's indicator will become dim when battery power gets too tery strap In the cover or coll spring. low. Replace the battery as soon as possible. | * The CHECK indicator shows whether the effect is being applied or not. It does not indicate whether the BATTERY power to the device is on or not. HOUSING CONNECTOR DAT TERY STRAP For EU Countries ( € This product complies with the requirements of European Directive 89/336/EEC. — SETTING MEMO LEVEL TONE ATTACK SUSTAIN LEVEL TONE ATTACK | SUSTAIN LEVEL TONE ATTACK SUSTAIN LEVEL TONE ATTACK SUSTAIN e . e e e . . e e e . . e e . . . e . . e . . . o . e e . . . . MIN MAX LO HI MIN MAX MIN MAX MIN MAX LO HI MIN MAX MIN MAX MIN MAX LO HI MIN MAX MIN MAX . MIN MAX LO HI MIN MAX MIN MAX LEVEL TONE ATTACK SUSTAIN LEVEL TONE ATTACK SUSTAIN LEVEL TONE ATTACK SUSTAIN LEVEL TONE ATTACK SUSTAIN . e . . e . . . . . . e . . e . . . . e . . . . e . . . . e . e MIN MAX LO HI MIN MAX MIN MAX MIN MAX LO Ht MIN MAX MIN MAX MIN MAX LO HI MIN MAX MIN MAX MIN MAX LO HI MIN MAX MIN MAX
advertisement
* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project