Digitus DN-16081 Advanced 2MP WDR Full HD Indoor Dome Camera Quick Start Guide

Add to my manuals
2 Pages

advertisement

Digitus DN-16081 Advanced 2MP WDR Full HD Indoor Dome Camera Quick Start Guide | Manualzz
Screws &
Wall Plugs
Wrench
Quick Guide
Side View
 Camera Overview
DN-16081
Note: Please wipe the inner part of the dome cover against the lens for clear images.
Step 7: Replace the dome cover back to the camera.
Step 6: Pan, tilt and rotate the lens itself to adjust the position and viewing angle of the camera, and fasten the two screws on the plate to fix.
Step 5: Connect your camera to power.
Step 4: Fix the camera to the ceiling or wall with the supplied screws.
Step 3: Mark the locations of the two screw holes on the ceiling or wall, and drill a hole for each on the ceiling or wall. The distance between your camera and the location you want to monitor should be 3 ~ 4
meters.
Step 2: Make sure the screw holes on the plate are aligned with the holes on the camera base. If not, slightly loosen the two screws on the plate and rotate it.
Step 1: Separate the dome cover from the camera.
 Installation
www.digitus.info
for more product details, please go to
QUICK INSTALLATION GUIDE
DN-16081
 Optional accessories:
Camera
 Standard package:
Before starting to set up your camera, please make
sure items below are in your box:
 Package Contents
For advanced configuration of your DIGITUS camera with
DIGITUS NVR, please refer to below for the connection:
 CAMERA CONFIGURATION
Step5: Open Internet Explorer on the PC, and enter the IP address and port number in the URL column to access the camera. The
format is http://ipaddress:portnum, such as http://192.168.30.1:88 in our example.
Step4: Note down the IP address and port number of the camera you want to access, such as “192.168.30.1” and “88” in our example.
Step3: After searching, set your PC in the same network segment as the specific camera you want to access, such as
“192.168.30.xxx” (xxx could be 0~255) in our example
Step2: Install the “IPScan.exe” from the CD on your computer and use this utility to find the IP address of the camera.
Step1: Connect PC to the HUB connected to your camera(s) with RJ45 network cable.
Please follow the directions in the below graphic to insert Micro SD card properly:
The camera doesn’t support hot-swapping. Please insert or remove the micro SD card with power disconnected.
The data originally saved in the micro SD card (if any) will be removed after inserting it to the camera.
 Insert Micro SD Card

advertisement

Was this manual useful for you? Yes No
Thank you for your participation!

* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project

Related manuals

Download PDF

advertisement