X-Line Compact Extender Beam Installation Instructions XLC-EB Extender Beam

X-Line Compact Extender Beam Installation Instructions XLC-EB Extender Beam
X-Line Compact
Extender Beam
Installation Instructions
XLC-EB Extender Beam
The X-Line Compact Extender Beam features a rigging attachment position to allow a column of X-Line Compact Grid
and Loudspeaker Array to be flown and tilted to obtain the desired sound coverage.
When using the Extender Beam never exceed the rigging rating of the XLC loudspeaker systems used
with it. These ratings account for stresses resulting from the load angles encountered in curved arrays.
These ratings are the limiting factors. Consult the XLC Rigging manual, and/or the rigging label on the
XLC loudspeaker systems for the ratings when used in curved arrays. The Extender Beam has been
designed to exceed the structural ratings for the XLC loudspeaker systems, so if the structural ratings are
not exceeded for loudspeaker system within the column, the structural rating for the Extender Beam will
not be exceeded.
Pickup Ring
Centering Ring
Extender
Beam
Quick-Release Pin
Yoke
Note: Extender Beam
shown cutaway for better
conceptualization and
clarity.
Quick-Release
Pin
Grid
Figure 1:
Attaching Grids to Extender Beam
WARNING: Suspending any object is potentially dangerous and should only be attempted by individuals who have a
thorough knowledge of the techniques and regulations of rigging objects overhead. Electro-Voice® strongly
recommends that X-Line Compact speakers be suspended taking into account all current national, federal, state and
local regulations. It is the responsibility of the installer to ensure that X-Line Compact speakers are safely installed in
accordance with all such regulations. If X-Line Compact speakers are suspended, Electro-Voice® strongly recommends
that the system be inspected at least once a year. If any sign of weakness or damage is detected, remedial action should
be taken immediately.
One Pickup
Point
Two Pickup
Points
Tilting Down
(Hole #1 at Rear)
Tilting Up
(Hole #1 at Front)
Figure 2:
Extender Beam Array Configurations
Step 1: Install Pickup Rings in Hole #18
and #22 and Install Yokes as shown
Step 2: Rotate Yokes, Then Drop Pickup Rings
(View Shown Cutaway for Clarity)
Figure 3:
Extender Beam Shipping/Transport Configuration
12000 Portland Avenue South, Burnsville, MN 55337
Phone: 952/884-4051, Fax: 952/884-0043
www.electrovoice.com
© Telex Communications, Inc. 11/2005
Part Number 38110-480 Rev A
U.S.A. and Canada only. For customer orders,
contact the Customer Service department at
800/392-3497 Fax: 800/955-6831
Europe, Africa and Middle East only. For customer orders,
contact the Customer Service department at
49 9421-706 0 Fax: 49 9421-706 265
For warranty information, contact the Service Repair department at:
616/695-6831 or 800/685-2606
For technical assistance, contact Technical Support at:
866/78AUDIO
Specifications subject to change without notice.
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising