Model 71 Control Console Confi guration Guide Confi guration

Model 71 Control Console Configuration Guide
Configuration
Hold the Config button on the back of the Model 71 for two
seconds to enter the configuration mode. The Status LED will
start to blink while in configuration mode. Use the Level control
to set the device address. The current address is displayed
using the Dim and Reference Level LEDs.
Address
Dim LED
Reference Level LED
1
OFF
OFF
2
OFF
ON
3
ON
OFF
4
ON
ON
The default address is 4. Press and hold the Config button to
exit configuration mode.
Power Up
After applying power to the Model 71 each LED will light
momentarily. After the three LEDs have been lit, the device
address will be shown briefly using the Dim and Reference
Level LEDs as shown in the above table. When this is complete the Model 71 will enter the normal operating mode and
the Status LED will light if communications are established
with the Central Controller. If the Status LED does not light
check to see if there is a device address conflict among all
connected Control Consoles and that all cables are connected
properly.
© 2008 by Studio Technologies, Inc., all rights reserved
www.studio-tech.com
50234-0808, Issue 1

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project