QUICK REFERENCE GUIDE
Simrad EQ60
To start the echo sounder
•
•
•
Switch power on.
Allow the software to start.
The echo sounder will automatically
resume the same operational mode as
it held when it was switched off.
Changing the settings
•
Use the trackball to move the cursor
to the required area on the display.
• Click the right button on the trackball.
• When the dialogue box appears, select
the correct setting(s) using the left
button.
• Click OK to close the dialogue box.
Depth range (4) and Gain control (3)
may also be adjusted using the “wheel” on
the trackball.
Changing the borders
•
•
•
Position the cursor on any horizontal
or vertical border line. Observe that
the cursor changes shape.
Press and hold the left button, and
move the border line with the trackball.
Release the button when the new
border position is set.
Removing display colours
Display areas
1) Output power and pulse length
2) Minimum/Maximum depth and
Bottom detection and Alarms
3) Gain control: School, Fish or
Bottom
4) Depth range setting
5) Echogram settings
1
•
•
•
Place the cursor on the colour bar (3).
Click the left button on the trackball
on a chosen colour to remove it from
the display
Click again to restore it.
3
2
4
5
4
859-164344 / Rev. B
Simrad AS
Strandpromenaden 50
P.O.Box 111
NO-3191 Horten
Norway
Telephone:
+47 33 03 40 00
Facsimile:
+47 33 04 29 87
www.simrad.com
A LWAY S AT T H E F O R E F R O N T O F T E C H N O LO GY
">
