User manual | PRODUCT DATA HARD HAT® AEROSOLS GALVA EXPRESSE 2180

PRODUCT DATA
HARD HAT® AEROSOLS GALVA EXPRESSE 2180
DESCRIPTION
RUST-OLEUM® Hard Hat Aerosol Galva Expresse 2180 is a very fast drying zinc rich primer
based on a styrene-acrylic resin. The product contains pure zinc as pigment and provides
excellent protection against corrosion.
RECOMMENDED USES
RUST-OLEUM Galva Expresse 2180 should be used on new, bare steel or galvanised steel
surfaces.
RUST-OLEUM Galva Expresse 2180 is intended to be applied on small areas or for touch-up.
RUST-OLEUM Galva Expresse 2180 can be recoated with non-saponifiable coatings.
RUST-OLEUM Galva Expresse 2180 should be used as a primer or as a single coat in light
industrial exposures, corrosive environments and high humidity areas.
TECHNICAL DATA
Appearance:
Propellant:
Recommended film thickness:
VOC-content:
Flat
Dimethyl ether
35 µm dry, equals 100 µm wet
645 g/l
Drying times
To touch:
To handle:
To recoat:
Full hardness
20°C/50% r.v.
5 minutes
10 minutes
Within 1 hour or after 48 hours
3 days
Heat resistance:
350°C (dry heat)
Coverage
Theoretical: 1.4 m² per spray can at 35 µm dry
Practical:
Practical coverage depends on many factors such as porosity and roughness of
the substrate and material losses during application.
SURFACE PREPARATION
Remove dirt, grease, oil, loose rust and all other surface contaminants by appropriate means.
The surface must be clean and dry during application.
DIRECTION FOR USE
Remove cover cap. Shake vigorously for at least one minute after the rattle of mixing ball is
heard. Shake frequently during use. Hold can approx. 25 cm from surface. Use back and forth
motion keeping can parallel with surface. Ensure that can is in motion when spray button is
pressed to avoid runs and sags. Apply a full, wet coat to achieve a close, dense coating film,
avoid dry spray. After use turn can upside down and press spray button for 2 - 3 seconds to
clean valve.
APPLICATION CONDITIONS
For good results the relative humidity shall be below 85% and the temperature of the can and
substrate above 0°C.
REMARKS
Both products are lead- and chromate free thus eliminating the danger of poisonous gases
escaping if the coated surface needs to be welded at a later date.
Page: 1/2 - Ver. 03
PDS 2180-gb
Issued: 23-12-08
The information contained herein is given in good faith. However, since application conditions are beyond our control, Rust-Oleum
Netherlands B.V. cannot assume responsibility for any risks or liabilities which may result from the use of these products. The
company reserves the right to modify data without prior notice.
PRODUCT DATA
HARD HAT® AEROSOLS GALVA EXPRESSE 2180
SAFETY
Consult Safety Data Sheet and Safety Information printed on the can.
SHELLIFE / STORAGE CONDITIONS
3 years from date of production in unopened cans, if stored in dry, well ventilated areas,
not in direct sunlight at temperatures between 5° and 35°C.
Page: 2/2 - Ver. 03
PDS 2180-gb
Issued: 23-12-08
The information contained herein is given in good faith. However, since application conditions are beyond our control, Rust-Oleum
Netherlands B.V. cannot assume responsibility for any risks or liabilities which may result from the use of these products. The
company reserves the right to modify data without prior notice.

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project