Mr. Heater MHVFR 10NG, MHVFB 10NG unvented natural gas room heater Operating Instructions and Owner’s Manual

Mr. Heater Plaque HSVFR10LP is a powerful and versatile heating solution for various indoor and enclosed outdoor spaces. With its efficient design, it provides ample heat to keep you comfortable in chilly environments. This heater can be conveniently mounted on a wall or ceiling, making it ideal for garages, workshops, sunrooms, and other areas where additional heat is needed.

PDF Download
Document
Mr. Heater MHVFR 10NG and MHVFB 10NG Operating Instructions and Owner’s Manual | Manualzz

Advertisement

Advertisement

Advertisement

Key features

  • Piezo ignition system
  • 10,000 BTU output
  • Wall or floor mounting
  • Supplemental heating
  • Oxygen Depletion Sensor (ODS) safety shut off system

Frequently asked questions

Make sure the gas supply to the heater is on. Press in the control knob and slightly turn clockwise to the OFF position. Wait five minutes and smell for gas. If you do not smell gas, push in the control knob and turn counterclockwise to PILOT/IGN and depress for five seconds. The first time that the heater is operated after connecting the gas supply, the control knob should be depressed for about 30 seconds. Push in the control knob and rotate control knob back to OFF position then rotate counterclockwise to PILOT/IGN position. Keep control knob pressed in for ten (10) seconds after lighting pilot. After pilot is lit, turn the control knob to “LO” or “HI” to light the heater.

If the pilot does not stay lit, refer to the Troubleshooting section in the manual. You may also contact a qualified service person or gas supplier for repairs.

The minimum clearances for the heater are 36 inches from the ceiling, 6 inches from the sides and 2 inches from the floor.
Preparing document for printing…
0%