Signature Hardware Curved Shower Curtain Rod Installation Instructions

CURVED SHOWER CURTAIN ROD

INSTALLATION INSTRUCTIONS

Before installing, read entire shower curtain rod installation instructions. Observe all local building and safety codes. For the following installation instructions it is assumed that any old fixtures have been removed and any repairs to the wall have been completed.

Unpack and inspect the product for any shipping damages. If you find damages, do not install. Contact Customer Service at 1.866.855.2284. If you need assistance or have questions while installing your rod contact Customer Service.

We recommend consulting a professional if you are unfamiliar with installing bathroom fixtures. Signature Hardware accepts no liability for any damage to the wall or for personal injury during installation.

TOOLS AND MATERIALS:

Tape Measure

Level

Hammer

Hack Saw

Drill

Screwdriver

Pencil

¼" Drill Bit

For 60" Standard Tub

Mount rod approximately 3" inside the point a straight rod is normally mounted. The midpoint of the rod should extend several inches past the outside rim of the tub.

For 60" Oval Tub

Depending upon tub model, mount rod between 6" and

8" from center line of the tub. The middle portion of the rod should curve just outside the contour of the tub.

Curved Shower Curtain Rod Installation 1

INSTALLATION

1. Lay the rod sections on the floor. Connect the rod sections to assemble.

2. Verify that the rod sections are the proper length for your installation. If not, trim with a hacksaw.

3. Have someone help you measure. Hold rod up to desired position, one person at each end, to check height and location. Making sure that rod is level, use a pencil to lightly score marks at the top and bottom of the wall plate.

Set the rod down.

4. Hold the wall brackets up at the desired mounting height.

5. Mark the placement of the mounting holes. Use a tape measure and level to make sure that your pencil marks are lined up properly on each wall.

6. Drill pilot holes for the wall anchors.

Note: If there is a stud in your mounting location, use wood screws to attach the mounting bracket.

7. Gently tap the anchors into the pilot holes with a hammer.

8. Insert the ends of the rod into the wall brackets. Tighten the set screws with a Philips head screwdriver to secure.

9. Attach the wall brackets to the anchors with the mounting hardware provided.

Curved Shower Curtain Rod Installation 2