Modine DBP, DCP Gas-fired duct furnace Installation and service manual

The DBP and DCP series gas-fired duct furnaces are designed for indoor power vented applications. They are approved for use in California by the CEC. These furnaces are designed to provide efficient and trouble-free operation.

PDF Download
Document
Modine DBP, DCP Gas-fired duct furnace Installation and Service Manual | Manualzz

Advertisement

Advertisement

Advertisement

Key features

  • Indoor power vented
  • CEC approved
  • Efficient operation
  • Trouble-free operation

Frequently asked questions

The National Fuel Gas Code requires a minimum clearance of 6 inches from combustible materials for single wall vent pipe.

Refer to Table 7.1 for Minimum Height from Roof to Lowest Discharge Opening.

Refer to the section titled 'Additional Requirements for Horizontally Vented Category III Units' for detailed venting requirements.

Refer to Table 8.1 for Gas Pipe Capacities.

Refer to the wiring diagram provided with the unit for all electrical connections.

Observe the heat exchanger tubes through the access openings in the ductwork. If the bottom of the tubes become red while the blower and furnace are in operation, check that the blower is set to the proper RPM.
Preparing document for printing…
0%