INSTALLATION INSTRUCTION
4” Low Voltage - Gimbal Ring
HR-D417
SAFETY INSTRUCTION
IMPORTANT: NEVER attempt any work without shutting off the electricity.
• Read all instructions before installing.
• For installation by a qualified electrician.
• System is intended for installation in accordance with National Electric Code, and local regulations.
Consult with local inspector to assure compliance.
• To reduce the risk of fire, electrical shock and injuries to persons, turn off power at main switch before installing or modifying the system.
• Warning: (Risk of fire) do not install insulation within 3 inches of fixture sides, or junction box, or in a manner to entrap heat.
• Retain instructions for future maintenance reference.
OVERVIEW
Trims fit housings from the HR-8400 series. Housing type and trim selection will determine maximum wattage; consult catalog or spec sheet for compatibility.
INSTALLING LAMP AND TRIM:
1. From the front of trim, insert the MR16 lamp followed by the clear glass lens, and secure with the lens retaining ring.
2. Attach the socket from the housing by pushing gently on to the pins of the MR16 lamp.
3. Push the trim springs into the housing until the trim ring is flush against the ceiling.
WAC Lighting www.waclighting.com
Phone (800) 526.2588 • Fax (800) 526.2585
Headquarters/Eastern Distribution Center
44 Harbor Park Drive • Port Washington, NY 11050
Phone (516) 515.5000 • Fax (516) 515.5050
Western Distribution Center
1750 Archibald Ave • Ontario, CA 91761
Phone (800) 526.2588 • Fax (800) 526.2585
WAC Lighting retains the right to modify the design of our products at any time as part of the company's continuous improvement program. June, 2014