Assembly Instructions for item : 2145 Connetix Series - Floor Lamp

Assembly Instructions for item : 2145 Connetix Series - Floor Lamp
Assembly Instructions for item : 2145
Connetix Series - Floor Lamp
Important: Always disconnect the power before installing or replacing bulb and before cleaning or other maintenance.
Assembly & Installation Instructions
1. Screw the threaded pipe into the hole at the bottom of the upper stem.
2. Remove the cover from the base by removing the screws.
3. Feed the female quick connectors (black and white) through the base,
large washer, lock washer, and hex nut.
4. Place the block at the bottom of the upper stem into the lower stem.
5. Place the block at the bottom of the lower stem into the base so that the dimmer
switch and the cord are on the same side, and use wrench (included) to tighten the hex nut.
6. Connect the female quick connectors from the fixture to the male
quick connector from the driver (black to black, white to white). The quick
connectors are polarized and will only connect in the correct position.
dimmer switch
7. Place the cover on the bottom of base, and secure with the screws.
8. Plug the cord into an outlet. The dimmer switch is located on the stem.
upper stem
CARE INSTRUCTIONS
Dusting – Use a clean, dry cloth.
Cleaning – To protect the finish,
avoid any harsh abrasives or chemicals.
block
lower stem
block
threaded pipe
base
female quick connector
male quick connector
cover
lock washer
hex nut
large washer
wrench
screw
©2012 SONNEMAN - A WAY OF LIGHT
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement