PS C M P

PS C M P
PSOC® MINIPROG3 PROGRAM AND DEBUG KIT
QUICK START GUIDE
1
2
Install Software
MiniProg3 Setup
1. Insert the kit CD.
1. Launch PSoC Programmer.
2. Install PSoC Programmer.
2. Connect the PC to the MiniProg3 using
the USB cable.
3. View the kit user’s guide in the
Documents folder of the PSoC
Programmer installation.
3. Connect the 10-pin ribbon cable to the
MiniProg3.
4. Observe that PSoC Programmer has
detected the connected MiniProg3.
PSOC® MINIPROG3 PROGRAM AND DEBUG KIT
QUICK START GUIDE
3
4
Program a Device
Programming Protocol and Device Family
1. Ensure that the MiniProg3 is
connected in the port window by
clicking on the programmer in the
port window. A blue dot should
appear indicating connection.
1. The MiniProg3 programmer supports
PSoC 1, PSoC 3, PSoC 4, and PSoC 5LP
devices.
2. Load the hex programming file by
clicking File > File Load.
3. Set the programming settings in the
Programmer tab.
4. Select the target device from the
drop-down menu.
2. Select the appropriate programming
protocol in the Programmer tab before
picking the device from the menu options.
3. PSoC Programmer displays only those
devices that are supported by the
programming protocol.
PSoC 1 = ISSP
PSoC 3, PSoC 5LP = JTAG
PSoC 3, PSoC 4, PSoC 5LP = SWD
5. Connect the MiniProg3 to the target
device.
6. Click the Program button (F5).
For the latest information about this kit visit
www.cypress.com/go/CY8CKIT-002
© 2011-2013 Cypress Semiconductor Corporation. All rights reserved. All trademarks or registered
trademarks referenced herein are the properties of their respective owners.
Doc #: 001-70984 Rev *C
Mouser Electronics
Authorized Distributor
Click to View Pricing, Inventory, Delivery & Lifecycle Information:
Cypress Semiconductor:
CY8CKIT-002
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising