advertisement
19B07_Cover Page 1 Friday, July 2, 1999 2:33 PM
GTF374
Programming Cable
3x4.75
19B07_EN Page 1 Friday, July 2, 1999 2:41 PM
GENERAL
The GTF374 Programming Cable is a passive cable used to connect the mobile Professional
Radio to the RLN4008 Radio Interface Box (RIB) when the radio is to be tuned or programmed.
The Programming Cable has a 10-pin male Telco connector at one end, which connects to the radio microphone connector, and a 25-way female ‘D’ type connector at the other end for connection to the RIB.
OPERATION
Refer to the relevant test/ programming procedures for the radio on test and connect the radio to the RIB as directed.
!
C a u t i o n
Do not disconnect the cable in the middle of a procedure. This may leave the radio incorrectly configured and degrade the radio performance
SERVICE
The Programming Cable is not repairable. Order a replacement cable as necessary.
1
19B07_EN Page 2 Friday, July 2, 1999 2:41 PM
SCHEMATIC DIAGRAM
P1
10-way Telco
FLT A +
Hook
Ground
PTT
Bus +
10
1
2
5
6
3
4
7
8
9
1k Ohm resistor mounted inside the
DB25 body
P2
25-way ‘D’ Type
Ground
12
13
14
10
11
8
9
6
7
4
5
15
16
17
18
19
20
21
22
23
24
25
1
2
3 linked to pin 13
Switched Battery voltage + linked to pin 4
Bus +
Not Connected
Boot Control
CONNECTOR DETAIL
Pin 25 Pin 13
25-Position
DB25
Female
Connector
Pin 14
Pin 1
Pin 10
Pin 1
Pin 8
Pin 9
1,500
±
50mm
Cable
2
19B07_Cover Page 2 Friday, July 2, 1999 2:33 PM
© 1999 by Motorola, Inc.
Radio Products Group
Jays Close, Viables Industrial Estate,
Basingstoke, Hampshire RG22 4PD United Kingdom
and Motorola are registered trademarks of Motorola Inc.
Professional Radio and GP are trademarks of Motorola Inc.
All Rights Reserved.
6864119B07
advertisement
* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project