ACTiSYS ACT-IR220Li Network Card User Manual

921 Corporate Way, CA 94539, USA
Tel: +1-510-490-8024
Fax: +1-510-623-7268
Web: http://www.actisys.com E-mail: irda-info@actisys.com
ACT-IR220Li / ACT-IR220LN
®
IrDA Serial Port Adapter
User’s Manual
April 22, 2008
Version 1.3.1.1
© Copyright 1999-2008 ACTiSYS Corporation
All Rights Reserved
The Wireless Connectivity Expert
ACT-IR220Li&220LN
User’s Manual
FCC & VCCI COMPLIANCE STATEMENT
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions:
(1) This device may not cause harmful interference and (2) this device must accept any
interference received, including interference that may cause undesired operation.
WARNING-FCC Regulations state that any unauthorized changes or modifications to this
equipment not expressly approved by the manufacturer could void the user authority to
operate this equipment
NOTE: This equipment has been tested and found to comply with the limits for Class B digital
device, pursuant to Part 15 of the FCC Rules. This equipment generates, uses, and can
radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference by
one or more of the following measures:
-Increase the separation between the equipment and receiver.
-Reorient or relocate the receiving antenna.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
-Consult the dealer or an experienced radio/TV technician for helps.
This equipment is in the 2nd Class category (information equipment to be used in a residential
area there to) and conforms to the standards set by the Voluntary Control Council For
Interference by Data Processing Equipment and Electronic Office Machines aimed at
preventing radio interference in such residential area.
When used near a radio or TV receiver, it may become the cause of radio interference. Read
the instructions for correct handling.
NOTE: Must be used with shielded cable only.
FOR YOU RECORDS
For your assistance in reporting this product in case of loss or theft, please record the model
and serial number, which are located on the bottom of the case. Please retain this
information.
Model Number:
Serial Number:
Date of Purchase:
Place of Purchase:
z
All indicated copyrights and trademarks in this document are copyrights and
trademarks of their respective corporations.
© Copyright 1999-2008 ACTiSYS Corp
Page 2 of 10
Apr. 22,2008
Version 1.3.1.1
The Wireless Connectivity Expert
ACT-IR220Li&220LN
User’s Manual
TABLE OF CONTENTS
FCC & VCCI COMPLIANCE STATEMENT ....................................................... 2
REVISION HISTORY ............................................................................................ 4
1. PRODUCT INTRODUCTION ............................................................................... 5
1.1.
1.2.
ACT-IR220LN....................................................................................................................... 5
ACT-IR220Li......................................................................................................................... 5
2. CONNECTOR PIN DEFINITION.......................................................................... 5
3. BAUD RATE SELECTION.................................................................................... 6
3.1.
3.2.
ACT-IR220Li - Level Mode.................................................................................................. 6
ACT-IR220LN – Preset (Hardware Jumper Setting) ............................................................ 6
4. TRANSMISSION CHARACTERISTICS .............................................................. 6
5. SPECIFICATIONS ................................................................................................. 7
6. MATERIAL COMPOSITION ................................................................................ 7
7. REGULATORY SPECIFICATIONS ..................................................................... 8
7.1
7.2
Radiated and Conducted EMC .............................................................................................. 8
Susceptibility Compliance ..................................................................................................... 8
8. WARRANTY INFORMATION ............................................................................. 9
9. CONTACT INFORMATION ............................................................................... 10
© Copyright 1999-2008 ACTiSYS Corp
Page 3 of 10
Apr. 22,2008
Version 1.3.1.1
The Wireless Connectivity Expert
ACT-IR220Li&220LN
User’s Manual
REVISION HISTORY
Revision History
Revision
1.0
Date
Comment
05/15/2003 Initial released
1.1
03/28/2005 Added current description in Electrical characteristics
1.2
1.3
03/28/2006 Modified DSR description in chapter of Connector Pin Definition
02/05/2007 Extracted technical portion
1.3.1
05/15/2007 Deleted IrReady Logo & added CRoHS logo
1.3.1.1
04/22/2008 Updated Corporate Address
ACTiSYS reserves the right to make changes without further notice to any products herein to improve reliability,
function or design. ACTiSYS does not assume any liability arising out of the application or use of any product or
circuit described herein.
All trademarks, logos, organization & company names and product model names are owned by the respective
organizations or companies.
© Copyright 1999-2008 ACTiSYS Corp
Page 4 of 10
Apr. 22,2008
Version 1.3.1.1
ACT-IR220Li&220LN
User’s Manual
The Wireless Connectivity Expert
1. PRODUCT INTRODUCTION
1.1.
ACT-IR220LN
No SW Modification required. Single IR speed. You may use exactly the same RS232 protocol
software you have now if you use it on both sides of two communicating devices. You can select one of
the optional IR speeds: 9.6k, 19.2k, 38.4k, 57.6k, 115.2k bps as a factory preset speed for your
application.
1.2.
ACT-IR220Li
Replace RS232 serial wires on embedded systems without using IrDA
®
protocol and with self-
programmable speed selection in user’s own application software. This is a direct replacement for
ESI9680 in level mode.
18.7 mm
35.6 mm
35.6 mm
61.8 mm
100 cm
2. CONNECTOR PIN DEFINITION
Signal Name
Pin Number
Signal Description
DCD
1
Not Connected
Rx
2
Data transmitted from IR dongle to PC
Tx
3
Data transmitted from PC to IR dongle
DTR
4
Supplies power and selects baud rate
GND
5
Signal Ground
DSR
6
Not Connected
RTS
7
Supplies power and selects baud rate
CTS
8
Not Connected
RI
9
Not Connected
© Copyright 1999-2008 ACTiSYS Corp
Page 5 of 10
Apr. 22,2008
Version 1.3.1.1
ACT-IR220Li&220LN
User’s Manual
The Wireless Connectivity Expert
3. BAUD RATE SELECTION
3.1.
ACT-IR220Li - Level Mode
ACT-IR220Li is a baud rate selectable adapter. It supports 3 baud rates: 9.6k, 19.2k & 115.2km bps.
3.2.
ACT-IR220LN – Preset (Hardware Jumper Setting)
ACT-IR220LN is a series product that supports 5 optional preset baud rates as below. User cannot self
change the baud rate since it is preset at factory by jumper setting.
Product No.
Baud Rate
ACT-IR220LN9.6
9.6k bps
ACT-IR220LN19
19.2k bps
ACT-IR220LN38
38.4k bps
ACT-IR220LN57
57.6k bps
ACT-IR220LN115
115.2k bps
4. TRANSMISSION CHARACTERISTICS
Parameters
Typical
Unit
IR transmit pulse width
1.63
μS
Optical cone angle
± 15
Degree
1 to 200
cm
100
μS
Transmission distance
Receiver latency
© Copyright 1999-2008 ACTiSYS Corp
Page 6 of 10
Apr. 22,2008
Version 1.3.1.1
ACT-IR220Li&220LN
User’s Manual
The Wireless Connectivity Expert
5. SPECIFICATIONS
®
Physical Layer
IrDA – 1.0 (SIR) compatible
Communication Speeds
Programmable (9.6 k, 19.2k, 38.4k, 57.6k, 115.2k bps)
Connection
Standard DB9F RS-232 Serial COM port to IrDA communication
Power Source
RS-232 port power only. No external power required
Power Consumption
0.3 W (Peak)
Dimensions (Excl. Cable)
61.8 mm (L) X 35.6 mm (W) X 18.7 mm (H) (2.4” X 1.4” X 0.74”)
Weight
77.2 g (2.85 oz)
Operating Temperature
0°C to 60°C (32°F to 140°F)
Cable Length
100 cm ± 3 cm
®
6. MATERIAL COMPOSITION
Component
Material
Part Number
UL Flame Rating
03-502-006
UL94HB
03-502-007
UL94HB
ABS:
Top Case
GE GPP 4500 /
Black /
GE GPM 5500
ABS:
Bottom
Case
GE GPP 4500/
GE GPM 5500
920A / 940A / 141L
Beige
Black /
UL USA E 121562
GE Lexan PC (IR)
Lens
Color
03-502-008
UL 94V-2 (0.061”)
UL 94V-0 (0.12”)
Beige
DYE
21051
Black /
Cable
Cable Insulation: PVC
Cable
Molding
Compound
PVC
PC Board
FR-4
© Copyright 1999-2008 ACTiSYS Corp
03-402-004
03-A03-001
Page 7 of 10
UL 2725 USB Cable
Beige
UL94HB
UL94V-O
Black
UL94V-O
Green
Apr. 22,2008
Version 1.3.1.1
The Wireless Connectivity Expert
ACT-IR220Li&220LN
User’s Manual
7. REGULATORY SPECIFICATIONS
7.1
Radiated and Conducted EMC
FCC-B
VCCI-2
EN50081-1 EN55022
7.2
(1988)
Susceptibility Compliance
EN50081-1
(1992)
EN55024
(1998)
EN61000-4-5
(1995)
EN55022
(1998)
EN61000-4-2
(1995)
EN61000-4-6
(1996)
EN61000-3-2 (1992)
EN61000-4-3
(1995)
EN61000-4-8
(1994)
EN61000-3-3 (1995)
EN61000-4-4
(1995)
EN61000-4-11 (1994)
© Copyright 1999-2008 ACTiSYS Corp
Page 8 of 10
Apr. 22,2008
Version 1.3.1.1
The Wireless Connectivity Expert
ACT-IR220Li&220LN
User’s Manual
8. WARRANTY INFORMATION
ACTiSYS Corporation warrants the first end-user purchaser, for a period of 1 year from the date of
purchase, that this wireless interface (The Product) will be free from defective workmanship and
materials, and agrees that it will, at its option, either repair the defect or replace the defective Product
or part thereof at no charge to the purchaser for parts or for labor.
This warranty does not apply to any appearance items of the Product, any consumable items
such as paper, ink ribbon, or batteries supplied with the Product, or to any equipment or any
hardware, software, firmware, or peripheral other than the Product. This warranty does not
apply to any Product the exterior of which has been damaged or defected, which has been
subjected to misuse, abnormal service or handling, or which has been altered or modified in
design, construction or interfacing. Tampering with Label Voids Warranty.
In order to enforce the rights under this limited warranty, the purchaser should mail, ship or carry the
Product, together with proof of purchase, to ACTiSYS.
The limited warranty described above is in addition to whatever implied warranties may be granted to
purchasers by law. To the extent permitted by applicable law, ALL IMPLIED WARRANTIES INCLUDE
THE WARRANTIES OF MERCHANT ABILITY AND FITNESS FOR USER ARE LIMITED TO A
PERIOD OF 1 YEAR FROM THE DATE OF PURCHASE. Some states do not allow limitations on
how long an implied warranty lasts, so the above limitation may not apply to you.
Neither the sales personnel of the seller nor any other person is authorized to make any warranties
other than those described above, nor to extend the duration of any warranties beyond the time period
described above on behalf of ACTiSYS. Corporation.
The warranties described above shall be the sole and exclusive remedy available to the purchaser.
Correction of defects, in the manner and for the period of time described above, shall constitute full
satisfaction of all claims, whether based on contract, negligence, strict liability or otherwise. In no
event shall ACTiSYS Corporation be liable or in any way responsible, for any damages or defects in
the Product which were caused by repair or attempted repairs performed by anyone other than
ACTiSYS technician. Nor shall ACTiSYS Corporation be liable or in any way responsible for any
incidental or consequential economic or property damage. Some states do not allow the exclusion of
incidental or consequential damages, so the above exclusion may not apply to you.
© Copyright 1999-2008 ACTiSYS Corp
Page 9 of 10
Apr. 22,2008
Version 1.3.1.1
The Wireless Connectivity Expert
ACT-IR220Li&220LN
User’s Manual
9. CONTACT INFORMATION
ACTiSYS Corporation
921 Corporate Way
Fremont, CA 94539, USA
TEL:+1-510-490-8024, FAX:+1-510-623-7268
E-Mail: irda-info@actisys.com
Web: http://www.actisys.com
© Copyright 1999-2008 ACTiSYS Corp
Page 10 of 10
Apr. 22,2008
Version 1.3.1.1
Download PDF

advertising