Ver. 1A Quick Installation Guide USB 2.0 Gigabit Network Adapter Model # AGIGAUSB Package Contents: • Gigabit Network Adapter • USB 2.0 Cable • Driver CD • Quick Installation Guide Step 3 Click Next at the welcome screen. Section 1 Installation The following steps and screen shots are for Windows XP. Steps for Windows 2000 are similar unless noted otherwise. Note: Do not connect the USB 2.0 Gigabit Network Adapter to your computer until you’ve reached the appointed step. If the Gigabit Adapter is connected already, Windows will detect the Adapter and request for a driver. Click Cancel to quit the wizard and remove the Gigabit Adapter from your computer. Step 1 Insert the Driver CD into your CD drive and wait for the autorun window to appear on screen. Step 2 Click on Install Driver at the autorun window. Note: If the autorun window doesn’t appear automatically go to Start, Run, and type D:\autorun.exe (where D is the letter of your CD drive) and click OK. Step 4 Click Next to accept the default destination location for the driver to be installed in or click Browse to select the desired location. Step 6 Click Continue Anyway at the Windows Logo Testing prompt. (For Windows 2000, click Yes at the Digital Signature Not Found prompt). Step 5 Click Next to accept the Program Folder for the driver. Step 7 Click Finish to complete the installation wizard. Continue on Back Continue on back... Section 3 Step 8 Connect one end of the Gigabit Network Adapter to your computer’s USB port and connect the other end to a hub/switch/router. Step 9 At the Found New Hardware Wizard window, select No, not this time and click Next. Step 10 Select Install the software automatically (Recommended) and click Next. For Windows 2000, select Search for a suitable driver for my device (Recommended) and click Next. Then check on the CD-ROM drives check box and click Next. Step 11 Click Continue Anyway at the Windows Logo Testing prompt. (For Windows 2000, click Yes at the Digital Signature Not Found prompt). Step 12 Click Finish to complete the installation. Step 13 Restart your computer to activate the Gigabit Network Adapter. Section 2 Step 3 Expand Network adapters from the list and verify that 10/100 Gigabit USB2.0 Network Adapter is listed and no yellow question mark is beside it. Verify Driver Installation To verify if the driver has been installed successfully, please perform the following steps. Step 1 Right-click on My Computer from your desktop and select Properties. Step 2 Select the Hardware tab and click on Device Manager. Congratulations! You have successfully installed the USB 2.0 Gigabit Network Adapter. Section 4 Section 3 Technical Support E-mail: [email protected] Toll Free: 1-888-746-3238 Web Site: www.airlink101.com *Actual throughput will vary. Network conditions and environmental factors lower actual throughput rate. Copyright © 2005 AirLink101. All rights reserved. AirLink101, the stylized AirLink101 logo, specific product designations, and all other words and logos that are identified as trademarks and/or service marks are, unless noted otherwise, the trademarks and service marks of AirLink101. All other product or service names are the property of their respective holders. AirLink101 products are protected under numerous U.S. and foreign patents and pending applications, mask work rights, and copyrights.
* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project
advertisement
© 2021