User manual | Antari Lighting and Effects 250V Printer User Manual

Antari Bubble Machine
Thank you for choosing the Antari Bubble Machine. You now own a rugged and
powerful state-of-the-art machine. Prior to use, we suggest that you carefully read all of
the instructions. By following the suggestions found in this user manual, you can look
forward to exceptional performance from your Antari Bubble Machine for years to
Please follow these operation, safety and maintenance instructions to ensure a
long and safe life for your Antari Bubble Machine.
For adult use only. The bubble machine must be installed out of the reach of
children. Never leave the unit running unattended.
Never aim the output at open flames.
Extended use will make all surfaces slippery.
Position output of bubbles away from persons.
Switch off from mains when refilling the liquid or cleaning the system.
Regular cleaning of the bubble wheel is required.
Do not transport with liquid. If the machine get wet, do not use until it is completely
Antari bubble liquid may leave permanent marks on clothing.
Pay attention to all warning labels and instructions printed on the exterior of your
Antari Bubble Machine.
Unpacking & Inspection
Power: AC 120V/60Hz (120V Model)
AC 230V/50Hz (230V Model)
Fuse: F2A/250V (120V Model)
T1A/250V (230V Model)
Dimensions (mm): 236.6 x 189.2 x 150
Weight: Net – 3.4 kg, Gross – 4.5 kg
Open the shipping carton and check that all equipment necessary to operate the
system has arrived intact. In addition to the Antari Bubble Machine, you should receive
the following items:
1. This user manual.
2. Power cord and plug.
3. A hanging bracket.
Before beginning initial setup of your Antari Bubble Machine, make sure that there
is no evident damage caused by transportation.
In the event that the unit’s housing or cable is damaged, do not plug it in and do
not attempt to use it until after contacting your dealer for assistance.
Pay attention to all warning labels and instructions printed on the exterior of your
Antari Bubble Machine
Do not overfill your bubble machine. Overfilling will cause the unit to leak.
Danger of electric shock
Keep this device dry.
Keep the bubble machine upright.
For the 110V models, use 3-prong grounded electrical outlet only. Prior to use
take care to determine that the unit is installed at the rated voltage.
Turn off or unplug when not in use.
This machine is not water-proof or splash-proof. If moisture, water, or any liquid
gets inside the housing, immediately unplug the unit and contact a service
technician or your dealer before using it again.
No user serviceable parts inside. Refer to your Antari dealer or other qualified
service personnel.
For indoor use only. Not designed for outdoor use.
This appliance must be earthed.
Remove all packing materials from the bubble machine.
Place bubble machine on a flat surface, or .
Turn on the power switch located on the back of the bubble machine. You will notice
that the internal bubble drum and fan are activated. Bubbles are now produced.
Save these instructions
User Manual
for the
Bubble Machine
Save and read these instructions ♦ Bitte lesen Sie und sichern Sie
diese Anweisungen ♦ Lisez et Gardez ces instructions
2000 Antari Lighting and Effects Ltd.
Download PDF