AudioSource SYSTEM 380 Speaker System User Manual

Owner’s Manual
System 380
Home Theater Speaker Set
This system contains: LS 300 Compact Speakers (front left, front right, back left & back right speakers);
LS 300/C Center Speaker; SW 80 Powered Subwoofer
Congratulations on your purchase and welcome to the AudioSource family of satisfied customers. Please take a few moments to read
this manual before you get started. Also, be sure to retain this document should you need to refer to it in the future.
The AudioSource System 300 Home Theater Speaker System is designed to accurately reproduce high fidelity music, including digital
signals. Movies and stereo TV broadcasts will sound more realistic, putting you in the center of the action. The LS 300/C center
channel speaker is video-shielded, allowing placement on top of your television. LS 300 speakers are provided for both the front
and surround channels, to provide a theater-like experience.
This manual is divided into two sections. The first provides information about the LS 300 speakers and the LS 300/C center speaker.
The next section concerns the SW 80 Powered Subwoofer.
LS 300 & LS 300/C
Hooking Them Up
The five-way binding posts accommodate nearly any type of connector and up to 14-gauge wire. For bare wire, press the binding post
in to reveal the eye, thread the wire into the eye, and release the spring-loaded connector. For banana plugs, simply insert the plug
into the end of the connector.
When connecting the speakers, be sure to retain the correct polarity. Attach the wire from the +, red, or positive terminal on one
component to the +, red, or positive terminal on the corresponding component's speaker output terminals. The –, black or
negative terminals must connect to the respective –, black or negative terminals. This is easy to do by observing the color, stripe,
or ribbing that appears on the wire.
Please note: If any parts of this system are missing or damaged, do not return to the store where you purchased this system. Please call AudioSource
directly at 800-HELP-115 (800-435-7115).
Speaker Placement
The center channel speaker should be placed as close as possible to the TV, preferably either directly on top of or below it. This locks the
sound to the picture. Place the front speakers near the front corners of the room, either on a bookshelf or wall-mounted. Positioning near a
corner enhances bass performance. Place the surround speakers either to the side of, or behind, your listening position. Typical placement is
on the side walls, slightly above ear level, about two-thirds of the way back from the front of the room. This allows the surround speakers to
aim directly at the listener, placing you in the middle of a five-speaker sound field.
Speaker Mounting
The LS 300 speakers include U-shaped brackets to mount the speakers to the wall. For safety, always mount these speakers on a wall
that is reinforced from behind. Never mount a speaker on a wall made of unreinforced drywall or plasterboard. If you are unsure, consult
a professional contractor. These speakers can also be placed on bookshelves and most types of speaker stands.
Set-Up Diagram
Left
Front
Speaker
+ –
Left
Surround
Speaker
Receiver
Right
Front
Speaker
Center Speaker
+ –
– +
SURROUND SPEAKERS
CENTER
REAR
FRONT
SPEAKERS
L
R
+ –
Right
Surround
Speaker
– +
C
L
R
1. Connect the left front speaker terminals (+ & -) of your receiver to the left LS 300 front speaker.
2. Connect the right front speaker terminals (+ & -) of your receiver to the right LS 300 front speaker.
3. Connect the left surround speaker terminals (+ & -) of your receiver to the left LS 300 rear surround speaker.
4. Connect the right surround speaker terminals (+ & -) of your receiver to the right LS 300 rear surround speaker.
5. Connect the center channel speaker terminals (+ & -) of your receiver to the LS 300/C center channel speaker.
Note: If you are using an outboard Dolby© Surround Processor, the speaker terminals for the center and rear/surround speakers will be found
on this component, not on your receiver.
If you need more information, we offer friendly, toll-free assistance.
1.800.HELP.115
You may also fax us 24 hours a day at 650.348.8083.
SW 80 Powered Subwoofer
Fuse
5A 250V
Level
Power
About Subwoofers
Subwoofers extend the bass response of your system beyond the limitations of most speakers. They are used with, not in place of, your existing left and right speakers. A subwoofer
can dramatically enhance a stereo TV, a stereo system, or a full fledged home theater.
Power In
18.5 VAC
On
Off
Line In
Features of the SW 80
The AudioSource SW 80 features a highly efficient ported enclosure, a rugged 8-inch reinforced driver and a eighty-watt amplifier with a passive low frequency crossover network.
A line level input is provided for fast and easy connection to virtually any system.
SW 80
Powered Subwoofer
Made in China
Using the Controls
Power
The power switch has two positions: off and on. When the power LED is lit, the power is on.
Level
The level control adjusts the volume of the SW 80. Once set, the level control should not require further adjustment. Begin with the
level control at the minimum position. Slowly increase the level until you can hear the subwoofer. A subwoofer playing too loud can
give your system a muddy sound, so be sure to balance the subwoofer carefully with your other speakers. Output level is relative and can
be different from location to location. Always return to the normal listening location to evaluate any setting changes.
Placement Guidelines
Prior to installing your new subwoofer, please consider the following guidelines. Placing the subwoofer near a wall or in a corner will
greatly increase its bass response. As frequencies reproduced by subwoofers are long and need room to propagate, a subwoofer placed
near the listening position will not sound as full as one placed farther away. Please be careful about placing anything directly on top of
your subwoofer, as the vibrations of the speaker cabinet could cause these items to shake loose or fall.
Connecting the SW 80
The following diagrams show the most common types of subwoofer connections. Note Use only the AC adapter provided with this unit.
Line In
The RCA-type jack of your SW 80 is designed to accept a line level signal from a receiver, pre-amp, surround sound decoder, television
or similar device. When using a single line level output from another unit, a Y connector should be used to send the signal to both the
left and right inputs.
Dedicated Subwoofer Connections
Many surround sound decoders, home theater processors
and audio/video receivers are equipped with a dedicated
subwoofer line output. Connect this line output to the line
inputs of the SW 80. A Y connector (not included) may be
necessary to feed this single output to both the left and the
right line inputs.
Receiver
CD
INPUT
TUNER
INPUT
PHONO
INPUT
SUB
OUT
TAPE LOOP
PREAMP
OUTPUT
POWER AMP
INPUT
LEFT
LEFT
RIGHT
RIGHT
+
–
Right Speaker
Fuse
5A 250V
Left Speaker
Level
Power
Power In
18.5 VAC
On
Off
Line In
+
-
-
+
SW 80
Powered Subwoofer
Made in China
Television Enhancement
Many newer television sets are equipped with variable stereo
outputs. The signal available at these outputs varies with the
TV volume. In this situation, these variable audio outputs can
be connected directly to the SW 80 line inputs to enhance the
bass response of the television's built-in speakers.
Fuse
5A 250V
Level
Television
Power
OUTPUT
VARIABLE
Power In
18.5 VAC
OUTPUT
FIXED
INPUT
VIDEO
On
Off
LEFT
Line In
RIGHT
SW 80
Powered Subwoofer
Made in China
Safety Instructions
CAUTION
RISK OF ELECTRIC SHOCK.
DO NOT OPEN.
Warning: To reduce the risk of fire or electric shock, do not expose this appliance to rain or moisture.
Caution: To reduce the risk of electric shock, do not remove cover (or back); no user serviceable parts inside. Refer servicing to qualified service personnel.
Caution: To prevent electric shock, match wide blade of plug to wide slot, fully insert.
Attention: Pour eviter les chocs electriques, introduire la lame la plus large de la fiche dans la borne correspondante de la prise et pousser jusqu'au fond.
The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated dangerous voltage within the product's
enclosure that may be of sufficient magnitude to constitute a risk of electrical shock to persons. The exclamation point within an equilateral triangle is intended to alert the
user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance.
Read Instructions
Power Cord Protection
All the safety and operating instructions should be read before the appliance is operated.
Power supply cords should be routed so that they are not likely to be walked on or
pinched by items placed on or against them, paying particular attention to cords at
plugs, convenience receptacles, and the point where they exit from the appliance.
Retain Instructions
The safety and operating instructions should be adhered to.
Heed Warnings
All warnings on the appliance and in the operating instructions should be adhered to.
Follow Instructions
All operating and use instructions should be followed.
Water and Moisture
The appliance should not be used near water. For example, near a bathtub, washbowl, kitchen sink, laundry tub, in a wet basement, or near a swimming pool, etc.
Ventilation
The appliance should be situated so that its location or position does not interfere
with its proper ventilation. For example, the appliance should not be situated on a
bed, sofa, rug, or similar surface that may block the ventilation openings; or, placed
in a built-in situation, such as a bookcase or cabinet that may impede the flow of
air through the ventilation openings.
Heat
The appliance should be situated away from heat sources such as radiators, heat
registers, stoves, or other appliances (including amplifiers) that produce heat.
Power Sources
The appliance should be connected to a power supply only of the type described in
the operating instructions or as marked on the appliance.
Grounding or Polarization
Precautions should be taken so that the grounding or polarization means of
an appliance is not defeated.
Cleaning
The speaker should be cleaned only as recommended by the manufacturer.
Power Lines
An outdoor antenna should be located away from power lines.
Non-Use Periods
The power cord of the appliance should be unplugged from the outlet when left
unused for a long period of time.
Object and Liquid Entry
Care should be taken so that objects do not fall and liquids are not spilled into the
enclosure through openings.
Damage Requiring Service
The appliance should be serviced by qualified service personnel when: a) the power
supply cord or the plug has been damaged; b) objects have fallen, or liquid has
been spilled into the appliance; c) the appliance has been exposed to rain; d) the
appliance does not appear to operate normally or exhibits a marked change in
performance; or e) the appliance has been dropped, or the enclosure damaged.
Servicing
The user should not attempt to service the appliance beyond that described in the
operating instructions. All other servicing should be referred to qualified service
personnel.
Product Servicing
In the event your System 380 fails to operated properly, please contact the dealer
where you purchased the unit. Or you may contact AudioSource directly for further
assistance.
SW 80 Powered Subwoofer Specifications
Amplifier Power Output . . . . . . . . . . . . . . . . . .80 Watts
Frequency Response . . . . . . . . . . . . . . .30 Hz to 250 Hz
Driver . . . . . . . . . . . . . . . . . . . . . . . . . . . . .8" Reinforced
LS 300 Front and Surround Speaker Specifications
Frequency Response . . . . . . . . . . . . . . . .80 Hz - 20 kHz
Power Handling . . . . . . . . . . . . . . . . . . . . . . . .100 watts
Impedance . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .8 ohms
Tweeter . . . . . . . . . . . . . . . . . . .3/4" polycarbonate dome
Woofer . . . . . . . . . . . . . . . . . . . . . . . . .4" polypropylene
Dimensions . . . . . . . . . . . . . . . . . . .8.5" x 5.875" x 5.5"
Functions . . . . . . . . . . . . . . . . . . . . . . . .Power (On, Off)
Inputs . . . . . . . . . . . . . . . . . . . . . . . . . .LFE Line (RCA)
LS 300/C Center Speaker Specifications
Frequency Response . . . . . . . . . . . . . . . .80 Hz - 20 kHz
Power Handling . . . . . . . . . . . . . . . . . . . . . . . .100 watts
Impedance . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .8 ohms
Tweeter . . . . . . . . . . . . . . . . . . .3/4" polycarbonate dome
Woofer . . . . . . . . . . . . . . . . . . . . .Two 4" polypropylene
Video Shielded . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .Yes
Dimensions . . . . . . . . . . . . . . . . . . . . . . .15.5" x 6" x 6"
Design and specifications are subject to change without notice.
9300 North Decatur
portland, Or 97203
Tel. 503.286.9300
Fax 503.978.3302
audiosource@phoenixgold.com
www.audiosource.net
Printed in China
© 2000 AudioSource, Inc.