Audiovox CDM8600 Cell Phone User Manual

RF-215
PROFESSIONAL VEHICLE SECURITY SYSTEM
OPERATION MANUAL
THIS PRODUCT IS DESIGNED FOR PROFESIONAL INSTALLATION ONLY
1
TRANSMITTER OPERATION
Transmitter Button
Button
–
Button
Button
Button for 3 seconds
Button
–
Button
Button for 2 seconds
II
+
Button
+
Button for 1 seconds
System Function
Arm / Lock door
Remark
Arm
and
Delete
Optional Sensor
Car Locator
System in Armed.
Panic function
Press 3 seconds
Disarm & Unlock
Door
Two Steps Door
Unlock & Disarm
System
Pop Trunk Release
Press twice within 3
seconds.
Silent Arm / Disarm
Activate Car-Jacking
Press twice.
Press 2 seconds
Ignition
position.
Ignition
position.
in
"off"
in
"on"
Switching code For
2nd Car Operation.
ACTIVE ARMING – LOCK & ARM:
1. Press button on transmitter.
2. The siren will chirp once and the parking lights will flash once indicating
that the system is now armed. The vehicle doors will lock upon arming
when interfaced with the security system.
Note: Defective sensor reminder: If the siren sounds 3 chirps, then you
have left a door, trunk, or hood lid ajar.
SILENT ARMING / DISARMING: Press the +
button together on the
transmitter to arm or disarm your security system, No chirp sound will be
heard; arm / disarm confirmation will be through the vehicles parking lights
only.
SHOCK SENSOR / OPTIONAL SENSOR BY-PASS: Press the button
on the transmitter twice within 3 seconds will arm the security system, bypass the shock sensor. The system will chirp one additional time to confirm
the sensor bypass mode was activated. The sensor bypass feature is
programmed to activate for one arming cycle only. The security system will
return to normal operation during the next arming cycle
PASSIVE ARMING:
Active arming / disarming is controlling your security system via the remote
transmitter. This security system is equipped with an optional Passive
Arming feature, which allows the security system to arm 30 seconds after
the last door is closed. Operation is as follows.
1. Turn the ignition to the “OFF” position and exit the vehicle.
2. After all entrances are closed, the security system LED will flash fast
for 30 seconds. If you reopen any door / hood / trunk, the security
system LED will stop flashing. It will begin flashing again once all
vehicle entrances are closed.
2
3. After 30-second timer has elapsed, the security system will
automatically “ARM”. The siren will chirp [1] time and the parking lights
will flash [1] time.
PASSIVE DOOR LOCKING:
The vehicle doors will automatically lock after passive arming cycle has been
completed.
ACTIVE DISARMING – UNLOCK & DISARM:
1. Press the
button on the transmitter.
2. The siren will chirp twice and parking lights will flash twice to indicate that
the security system is now disarmed. The vehicle doors will unlock and
disarm when interfaced with the security system.
TAMPER DISARMING: If the alarm is triggered; upon disarming the
system, the siren will chirp 4 times and parking lights will flash 3 times.
TWO STEP DOOR UNLOCK: This feature will independently unlock the
driver’s door only when disarming the security system. Pushing the
button on the transmitter a second time within 3 seconds will unlock the
entire vehicle.
AUTOMATIC RE-ARM: If this feature is selected, the security system will
automatically re-arm itself 60 seconds after disarming with remote
transmitter. Automatic rearm will cancel if any door is opened before the 60
seconds timer has elapsed.
DISARMING WITHOUT A TRANSMITTER
The Override function may be used if the remote transmitter is lost or
inoperative.
1. Enter the vehicle and turn the ignition switch to 'ON’ position. (Alarm
will sound.)
2. Within 10 seconds push and release the valet switch
The alarm will stop sounding and enter the disarm mode. You can now
start and operate the vehicle normally.
VALET MODE:
The valet switch allows you to temporarily bypass all alarm function,
eliminating the need to hand your transmitter to parking attendants or
garage mechanics. When the system is in valet mode, all alarm functions
are bypassed, however, the remote panic feature and remote door locks
will remain operational.
Enter Valet Mode:
1. Turn the ignition to “ON” position.
2. Push and hold valet switch for 2 seconds or until the LED turns on.
The LED will remain on as long as the system is in 'valet mode'.
Exit Valet Mode:
1. Return to normal operation, turn ignition 'ON'.
2. Push and hold valet switch for 2 seconds; the LED will turn off
indicating the system is exiting the valet mode.
PANIC FUNCTION:
The transmitter can be used as a remote panic switch to manually trigger
the alarm in case of emergency.
1. Press and hold the
button on the transmitter for 3 seconds. The
alarm will immediately sound.
2. To stop the alarm, press and hold the button for 3 seconds on the
transmitter, the panic mode will be turned off immediately.
3. If the button is not pressed, the alarm will automatically stop after 30
seconds.
3
TRIGGER THE SYSTEM
When armed, your vehicle is protected as follows:
1. Light impacts will trigger the warn-away signal. A long chirp from
siren/horn.
2. Heavy impacts / Doors open / Hood open / Trunk open / Turning on the
ignition switch- All will trigger the programmed sequence.
The starter disable relay (if installed) prevents the vehicle’s starter from
cranking. The siren and parking lights will turn on to alert of an intrusion for
30 seconds. Then the siren will stop and automatically reset and re-arm. If
any the sensors or detectors are still active, the alarm system will sound a
maximum of six-30 second cycles.
ANTI CAR-JACKING
Warning: If you don't need the car jacking function in this alarm system, be
sure to set car jacking feature “OFF”. This system is default setting Carjacking “OFF”. (See Alarm Feature III - 3 Programming.)
1. TRANSMITTER ACTIVATE THE CAR JACKING:
Press and hold + button on the transmitter for 1 second while the
vehicle’s ignition is ON. The parking light wills turns on for 1.5” seconds
to indicate car jacking activated.
2. DOOR SWITCH ACTIVATE CAR JACKING:
1. Turn the ignition switch to “ON” position, the system is armed.
2. Once the system is armed, if you are forced from the vehicle, the system
will active the car jacking trigger when the door is opened and closed
while the ignition is “ON”.
TRIGGER THE CAR JACK MODE:
3-timer circuits will function as follows:
First timer:
a. 50 seconds after the system has been triggered. The siren will start
chirping for 15 seconds.
b. During this 15 seconds period of chirping, you will be alerting to push
the valet switch once to turn off the car-jacking feature.
c. If not, it will enter second timer car jacking.
Second timer:
65 seconds after the system has beer triggered. The siren starts
alarming and the parking light starts flashing.
Third timer:
90 seconds after the system has been triggered
a. The siren still alarming and the parking light flashing, and
b. The starter disable will activate to prevent the vehicle from starting.
c. It will remain active until the vehicle's battery power exhausted.
OVERRIDE THE SYSTEM TO TURN OFF CAR JACKING:
Turn the ignition switch from OFF to ON, and within 10 seconds push
valet switch, the siren will stop and the system disarmed
IGNITION CONTROL DOOR LOCKS.
If the vehicle’s door locks have been interfaced to the security system, the
system will automatically lock the vehicle's doors when the ignition is turned
“ON” and /or unlock the vehicle’s doors when the ignition is turned “OFF”.
TRUNK RELEASE.
Press and hold
button on transmitter for two seconds to remote control
the trunk release or other electric devices.
4
CAR LOCATOR
Press the
button on the transmitter when the vehicle is in the armed /
locked mode to active car locator function. The siren will chirp 6 times. The
parking light will flash 12 times, allowing you to easily locate your car.
ADJUST AND TEST THE SENSITIVITY LEVEL OF THE SHOCK SENSOR
1. Turn the Ignition 'switch ‘ON/OFF’ 3 TIMES and stay in OFF position.
2. Push the Valet switch 8 times and holding in on the 8th push until four
chirps with a long chirp is heard then release the valet switch. You are now
in the Alarm feature ‘Shock Sensor’ programming mode.
3. Press and hold
button for 2 seconds. One long siren chirp to indicates
the unit is ready to accept adjustments of the shock sensor.
4. Press
button on the transmitter once. This will decrease sensitivity level
by one, each time the button is pushed, a decrease is made the siren/horn
chirp will respond with [1] chirp, while 2 chirp indicates the minimum of
sensitivity.
button on the transmitter once. This will increase sensitivity level
5. Press
by one, each time an increase is made the siren/horn chirp will respond
with [1] chirp, while 2 chirp indicates the maximum sensitivity.
6. Hit the bumper or strong metal part of the vehicle to test the threshold level
of the sensor.
a). Activate the warn-away (first stage the shock sensor), the siren will
emit a short chirp.
b). Activate the full alarm (second stage the shock sensor), the siren will
emit a long chirp.
7. When you are satisfied with the setting, press
button to lock in the
adjustment. One long siren chirp will indicate the unit has locked in the
adjustment.
Note: If 20 seconds of inactivity expires, or you turn on the ignition
during of above steps, the unit will exit the program mode and return
to the disarmed mode. Three long chirps will confirm exit.
ALARM OPERATING CONDITION:
Function
Siren
Parking
Lights
1. Arm
1 Chirp 1 Flash
2. Disarm
2or4
2 or 3
Chirps
Flashes
3. Trigger Alarming Flashing
4. Panic
Alarming Flashing
LED
Doors
Slow flash Locking
Off
or Unlocking
Fast flash
Slow flash
Slow flash Locking
Starter Pager
Disable Option
On
Off
On
On
On
5
ALARM INDICATORS
CHIRP INDICATORS:
Chirp
Function
1 chirp
2 chirps
3 chirps
4 chirps
6 chirp
Arm
Disarm
Defective
reminder
Disarm/
Intrusion
Car
Locator
PARKING LIGHTS:
Parking Light Function
1 flash
Arm
2 flashes
Disarm
3 flashes
Disarm/
Intrusion
12 flashes
Car Locator
LED INDICATORS:
LED
Off
Function
Disarmed
Slow
flash
Armed
Fast
flash
Passive
arming
On
(solid)
Valet mode
LED
2
flashes...
pause
3
flashes...
pause
4
flashes...
pause
5
flashes...
pause
Function
Trigger on trunk/hood
Trigger on door switch
Trigger on Dual Zone
Shock Sensor
Trigger
switch
on
This device complies with part 15 of the FCC rules.
Operation is subject to the following two conditions.
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause
operation.
Ignition
undesired
6
LIMITED LIFETIME WARRANTY PROVISIONS
( U.S. ,Continental U.S. and Canada Only)
1.
Auto Page, Inc. WARRANTS that this new unit has been thoroughly inspected and tested at the
factory prior to delivery. Your Auto Page equipment is guaranteed for “life” to the original
purchaser/user of the equipment and the original vehicle in which it was installed by an authorized
installer under the following conditions: If the product proves defective (according to Auto Page's
testing) within the first year, the defective unit may be exchanged or repaired free of charge. “Proof
of Purchase” (dated sales receipt) must accompany all warranty returns; otherwise, your return will
be rejected and sent back. After one (1) year, the purchaser should ship the unit prepaid to Auto
Page with a money order in the amount of $30.00 to cover shipping and handling charges. Note:
The enclosed Warranty Card may be required to receive warranty services.
2.
This WARRANTY will be considered void if the equipment has been misused, neglected,
improperly serviced or installed, altered, dropped or damaged by water, contrary to the Auto Page
OPERATIONS MANUAL. Or, if used with accessories not approved by Auto Page, which may
have contributed to the defect. See note below regarding product installation**.
3.
The purchaser’s remedies under this WARRANTY shall be limited to the repair or replacement of
electronic components only. THE FOLLOWING IS NOT COVERED: Damages or deterioration
to cases, batteries, covers and cabinets; the cost of repairs, replacement and labor of which shall be
borne by the purchaser even if occurring during the WARRANTY period.
4.
Any equipment or parts which are claimed to be defective under this WARRANTY must be sent to
the Auto Page Service center with “proof of purchase” at the purchaser’s expense prior to such
return, a Return Authorization Number should be obtained. Auto Page will return the equipment,
charges prepaid. Warranty Service can be provided through the dealer where the equipment is
originally purchased.
5.
Any unexpired WARRANTY shall be applicable to equipment and parts in the possession of the
original purchaser only.
6.
THIS WARRANTY IS IN LIEU OF ANY AND ALL OTHER WARRANTIES, EXPRESSED OR
IMPLIED, INCLUDING BUT NOT LIMITED TO ANY WARRANTY OF MERCHANTABILITY
OR FITNESS FOR A PARTICULAR PURPOSE.
7.
Auto Page shall not be liable, under the foregoing WARRANTIES or otherwise, for: Any personal
injury of any kind to the purchaser, its employees or agents or anyone else whomsoever resulting
directly or indirectly from the use or presence of the equipment or parts; Consequential damages of
any kind; any inability of the purchaser to use the equipment.
The attached WARRANTY CARD is for your record. However, Auto Page reserves the right to request
you to submit this WARRANTY CARD, which must have complete information to receive warranty
service. Please keep this card in a secured place.
**IMPORTANT NOTE: Any damages to the alarm system resulting from an
installation performed by anyone other than a professional installation technician
authorized by a dealer of Auto Page will void the product’s limited lifetime
warranty.
This WARRANTY CARD is for your record. However, Autopage reserves the right to request
you to submit this WARRANTY CARD which must have complete information to receive
warranty service. Please keep this card in a secured place.
7
AUTOPAGE WARRANTY SERVICE CARD
Model: RF-215
Serial # _______________
CUSTOMER TO COMPLETE
DEALER TO COMPLETE
Mr./Mrs./Ms.
_______________________________
Your Name (Please Print)
________________________________
Company Name
_______________________________
Address
________________________________
Dealer’s Address
_______________________________
City, State, Zip Code
________________________________
City, State, Zip Code
_______________________________
Telephone Number
________________________________
Dealer’s Telephone Number
_______________________________
Year / Make / Model of Vehicle
________________________________
Date of Installation / Purchase
________________________________
Dealer’s Signature
“Proof of Purchase” which includes the store name and date of purchase must
accompany all warranty returns.
It is the purchaser’s responsibility to keep this card for any future warranty service.
Autopage Inc.
960 Knox Street Unit B
Torrance, CA 90502
310-618-2002
www.autopageusa.com
8
Download PDF

advertising