Avaya Remote Access Module 4 Network Card User Manual

HDMI-C5 Series
User’s Guide
© 2007 Avenview™ Inc. All rights reserved.
The contents of this document are provided in connection with Avenview Inc. (“Avenview”) products. Avenview makes no representations
or warranties with respect to the accuracy or completeness of the contents of this publication and reserves the right to make changes to
specifications and product descriptions at any time without notice. No license, whether express, implied, or otherwise, to any intellectual
property rights is granted by this publication. Except as set forth in Avenview Standard Terms and Conditions of Sale, Avenview assumes
no liability whatsoever, and disclaims any express or implied warranty, relating to its products including, but not limited to, the implied
warranty of merchantability, fitness for a particular purpose, or infringement of any intellectual property right.
Reproduction of this manual, or parts thereof, in any form, without the express written permission of Avenview Inc. is strictly
prohibited.
Disclaimer
While every precaution has been taken in the preparation of this document, Avenview Inc. assumes no liability with respect to the
operation or use of Avenview hardware, software or other products and documentation described herein, for any act or omission of
Avenview concerning such products or this documentation, for any interruption of service, loss or interruption of business, loss of
anticipatory profits, or for punitive, incidental or consequential damages in connection with the furnishing, performance, or use of the
Avenview hardware, software, or other products and documentation provided herein.
Avenview Inc. reserves the right to make changes without further notice to a product or system described herein to improve reliability,
function or design. With respect to Avenview products which this document relates, Avenview disclaims all express or implied warranties
regarding such products, including but not limited to, the implied warranties of merchantability, fitness for a particular purpose, and
non-infringement.
www.avenview.com
1
Table of Contents
Getting Started ....................................................................................................................................... 3
Key Features ........................................................................................................................................... 3
System Devices and Functions ........................................................................................................... 3
Receiver HDMI-C5-R ....................................................................................................................... 3
Panel Description ................................................................................................................................... 4
Receiver HDMI-C5-R ........................................................................................................................... 4
Installation and Operation ..................................................................................................................... 6
HDMI-C5-S Single-Port Transmitter Installation ................................................................................ 6
HDMI-C5-SR Transceiver Installation ................................................................................................. 8
HDMI-C5-4 / HDMI-C5-8 Multiport Transceiver Installation ........................................................... 10
Selection of Cable............................................................................................................................. 12
Installation of Multiple Transceivers and Displays....................................................................... 13
Specifications ....................................................................................................................................... 15
www.avenview.com
2
Getting Started
The HDMI-C5-5 Receiver can receive HDMI signals over Cat 5 / 5e / 6 cable from HDMI-C5 Series
Transmitter and Transceivers. The HDMI-C5-R receiver is a cost effective solution for digital
signage, public information display, and large scale demonstration, where crystal-clear,
high-resolution digital video needs to be shown.
Key Features






HDMI over Cat 5 / 5e / 6 cable.
Video Amplifier Bandwidth: 1.65GHz
Maximum distance between HDMI-C5-SR Transceiver and HDMI-C5-R Receiver:
a. 480p / 720p / 1080i = 30m (100 ft)
b. 1080p = 15m (50 ft)
Compatible with receiving signal from HDMI-C5-S, HDMI-C5-SR, HDMI-C5-4, HDMI-C5-8
HDMI Input / Output Connector: HDMI digital signal
Compact Size
System Devices and Functions
Receiver HDMI-C5-R
a. Built-in one HDMI input
b. Built-in one RJ45 port for system output which can be connected by Cat 5 / 5e / 6 cable and
send signal to System Receiver
www.avenview.com
3
Panel Description
Receiver HDMI-C5-R
www.avenview.com
4
www.avenview.com
5
Installation and Operation
HDMI-C5-S Single-Port Transmitter Installation
a. First Time Setup: Turn off the HDMI output device and monitors.
b. Device Connection: Connect local HDMI monitor (M1) to the “HDMI/M1 OUT” of the
transmitter. Take the HDMI cable, plug one end to “HDMI IN” port of transmitter and the
other end of the cable to “HDMI OUT” of HDMI output device. Connect the Connect the
power adapter to the “DC 5V” and plug it into the power outlet.
Installation Diagram of System Transmitter HDMI-C5-S
c. System Turn On: Turn on your HDMI Output device and monitor to confirm the functionality
of the display. The “M1 LINK” LED of the Transmitter should display orange LED to confirm
the connection of a local HDMI monitor.
d. Remote Monitors: Make sure the remote monitor(s) connected the Transceiver and
Receiver can display the broadcast video resolution.
www.avenview.com
6
e. EQ Adjustment: You can adjust the EQ control to Auto Mode by rotating the EQ control
anti-clockwise. The “EQ” and “Auto” LEDs will display blue.
If noise or an unstable image is seen on the local HDMI monitor, adjust the EQ control
for best image display quality.
f.
LINK OUT: HDMI signal can be extended/cascaded over “LINK OUT” port by Cat 5 / 5e / 6
cable. The signal can be received by:
- HDMI-C5-R: The maximum HDMI distance is: < 30m (100 ft) for 480 / 720p
/ 1080i or <15m for 1080p.
- LINK IN of HDMI-C5-SR: Maximum cascading distance is: <80m (275 ft) for
480p, 70m (230 ft) for 720p / 1080i or <30m (100 ft) for 1080p.
- HDMI IN of HDMI-C5-4/HDMI-C5-8: To connect to the HDMI connector, a
HDMI-C5-R Receiver is required. Maximum cascading distance is: <80m
(275 ft) for 480p, 70m (230 ft) for 720p / 1080i or <30m (100 ft) for 1080p.
Three ways of extending HDMI signal from Transmitter HDMI-C5-S
www.avenview.com
7
HDMI-C5-SR Transceiver Installation
a. Monitor Connection: Connect HDMI monitor’s HDMI cable to Transceiver and turn on the
monitor.
b. Device Connection: Plug power adapter to HDMI-C5-SR, the “PWR” LED and “M1 LINK” will
turn ON. The “LINK IN” LED should turn off since there is no input of video signal from “LINK
IN” port.
Connection of HDMI Transceiver
c. HDMI Cascading: The RJ45 “LINK IN” port is designed to receive the HDMI signal from
Transmitter over Cat 5 / 5e / 6 cable. Follow “HDMI-C5-S Single Port Transmitter
Installation” to install Transmitter and extend the HDMI signal.
www.avenview.com
8
d. EQ Adjustment: You can adjust the EQ control to Auto Mode by rotating the EQ control
anti-clockwise. The “EQ” and “Auto” LEDs will display blue.
After connecting the extender system, if you see dynamic dots or unclear image on the
HDMI monitor, adjust the signal on HDMI Transmitter.
e. LINK OUT: The function of “LINK OUT” port on Transceiver will act the same as
Transmitter’s. It can extend/cascade HDMI signal to HDMI-C5-R, HDMI-C5-SR, HDMI-C5-4, or
HDMI-C5-8.
Three ways of extending HDMI signal from Transmitter HDMI-C5-S
www.avenview.com
9
HDMI-C5-4 / HDMI-C5-8 Multiport Transceiver Installation
a. Monitor Connection: Connect HDMI monitor’s HDMI cable to Multi-Port Transceiver’s
“HDMI/LOCAL OUT” port and turn the monitor ON.
b. Device Connection: Plug power adapter to Multi-Port Transceiver, the Front Panel’s
“POWER” LED and “LOCAL LINK” will turn ON. The “ACTIVE” LED will turn ON till Transceiver
has received active HDMI signal.
Connection of Multi-Port Transceiver
c. HDMI Sources: The “HDMI IN” can receive HDMI signal from a Standard HDMI Output
Device or HDMI-C5-S / HDMI-C5-SR / HDMI-C5-4 / HDMI-C5-8 by using HDMI-C5-R
HDMI-RJ45 Receiver.
Connecting HDMI Sources
www.avenview.com
10
d. EQ Adjustment: You can adjust the EQ control to Auto Mode by rotating the EQ control
anti-clockwise. The “EQ” and “Auto” LEDs will display blue.
After connecting the extender system, if you see dynamic dots or unclear image on the
HDMI monitor, adjust the signal on HDMI Transmitter.
e. LINK OUT: The function of “LINK OUT” port on Multi-Port Transceiver is to cascade HDMI
signal to one-port HDMI Transceiver or another 4 / 8 port HDMI Transceiver;
Two ways of cascading HDMI signal by Multi-Port HDMI Transmitter
f.
Connecting Monitors: 4 / 8 HDMI monitors can be connected to the “RJ-45 HDMI OUT”
ports by HDMI-C5-R Receiver.
Connecting 8 HDMI Monitors
www.avenview.com
11
g. Addition System Expansion: The “RJ-45 HDMI OUT” port can also be used as link out port
for more system expansions.
Selection of Cable for HDMI-C5-Series
a. Selection: Most makes and versions of Cat 5/5e/6 cables will work with HDMII-C5-Series.
However, since the quality and characteristics of Cat 5/5e/6 cables varies it has been found
that some perform better than others. The major factor influencing the transmitting
distance is the skew property of the cables. Skew represents the difference in propagation
delay between the fastest and slowest set of wire pairs. A lower skew will mean a longer
video transmitting distance.
Cat 5/5e/6 cable with a skew of lower than 15ns/100m should enable a cascading of
HDMI-C5-Series length of:
< 80m (275ft) @ 480p
< 70m (230ft) @ 72p / 1080i
< 30m (100ft) @ 1080p
b. Skew Property: A Cat 5 / 5e / 6 cable with a skew lower than 15ns/100m should enable a
cascading length of <80m (275 ft) at 480p, <70m (230 ft) at 720p / 1080i and <30m (100 ft)
at 1080p.
c. Termination: The RJ45 terminations to the Cat 5/5e/6 cable must be made to the EIA 568B
specification.
1.
5.
Orange White
Blue White
2. Orange
3. Green White
6. Green
7. Brown White
The EIA/TIA definition of 568B in the pin assignment
4.
8.
Blue
Brown
PAIR 3
PAIR 2
PAIR 1
PAIR 4
JACK POSITION
www.avenview.com
12
f.
Connect UTP Cable: Plug one end of the cable to Transmitter’s “LINK IN/OUT” port and the
other end to the Transceiver’s RJ45 “LINK IN/OUR” port. The monitor connected to the
Transceiver should now display and the “LINK” or “ACTIVE” LED should turn Green to
indicate the HDMI signal activation. Adjust the “EQ” control for best quality HDMI display.
Installation of Multiple Transceivers and Displays
a. Multiple Transceivers: By using additional HDMI-C5-SR Transceivers, it is possible to extend
the system almost indefinitely to remote HDMI displays.
Ensure that common grounding is maintained to minimize ground loops and
interference for larger group of cascaded Transceivers.
Connection Diagram of HDMI Extender
www.avenview.com
13
g. Function Test: After above installation, you will be able to broadcast the HDMI signal to
Receiver’s connected monitor.
General Troubleshooting
Problem
Possible Solution

Screen Defects Appear

Off-Center Screen Image, Odd
Colors or No Picture


No Image
www.avenview.com

Check your current resolution, refresh rate and color depth
settings in the Settings and Monitor tabs in your Display
Properties dialog.
Try adjusting the brightness, sharpness, contrast, and color
balance controls of your monitor.
Try adjusting the centering and positioning controls of your
monitor to position the picture on the screen.
Ensure that the monitor cable is securely fastened to the
HDMI and Monitor port.
Try to connect monitor directly to a PC to ensure basic
functionality of these devices.
14
Specifications
Model
Description
Input
Output
Max Distance
and Resolution
Signal Type
www.avenview.com
HDMI-C5-R
1 Port HDMI Receiver
HDMI Female x 1
RJ45 x 1
With each cascading length:
< 30m (100ft) @ 480p / 720p / 1080i
< 15m (50ft) @ 1080p
HDMI
15
www.avenview.com
16