Proof/Hot

Cabinets

Rev. 7 (10/08)

FL-2212

Page 1 of 4

5925 Heisley Road • Mentor, OH 44060-1833

OPERATING and MAINTENANCE INSTRUCTIONS

Models: 120PH, 121PH and 126 PH Series Proof/Hot Cabinets

Model No.

120, 121PH, 126PH Series

Volts Watts Amps Hertz Phase NEMA

120 2000 16.6

60 1 5-20P

120, 121PH, 126PH Series w/240 suffi x

240

All are designed for AC service.

2000 8.6

60 1 6-15P

HOW TO INSTALL UNIT:

1. Place cabinet near warm ovens. Do NOT put in drafty areas or near ventilating systems.

2.

3.

Plug cord end into proper wall outlet.

Fill water pan (following steps a-c)

1

ON ( I )

2 5 7

PROOF

8

2

1

3

4

5 6

7

8

9

10

2

1

3

4

5 6

7

8

9

10

4.

5.

6.

7.

8.

HOW TO PROOF:

1. Fill water pan (See “How to Install”)

2.

3.

Push “POWER” switch to “ON.” The yellow light will come on.

Push “MODE SELECTION” switch to “PROOF”.

The yellow light will come on.

Turn “HUMIDITY” dial to No. 8.

Turn “AIR” dial to “OFF”.

Preheat for 30 minutes.

Put fresh or fully thawed dough into cabinet.

Turn “HUMIDITY THERMOSTAT” to No. 9.

OFF ( 0 )

POWER

OFF

HUMIDITY

OFF

AIR

HEAT

MODE SELECTION

CAUTION

Use of treated or soft water may be required for proper operation and to maintain warranty.

a. Lift off cover.

b. Fill with 3½ qts. (3.3 liters) of clean, hot water.

Replace cover.

c. Adjust vents on cover to half open.

R

3 4 6

CONTROL PANEL PARTS IDENTIFICATION

1. Switch - Power 5. Yellow Light - Proof

2. Pilot Light - Power 6. Red Light - Heat

3. Thermostat - Humidity 7. Switch - Mode Selection

4. Thermostat - Air 8. Thermometer

NOTE: No. 9-10 setting will give you an approximate temperature of 95°F (35°C), and 90-

95% humidity. Experiment with different

“HUMIDITY” and “AIR” settings to get the exact temperature and humidity you need. The thermometer shows the temperature inside the cabinet.

NOTE: The cabinet temperature will drop temperature inside cabinet if cold dough is added.

NOTE: Check water level in water pan if you are proofi ng longer than 90 minutes. Fill with clean, hot water.

Do NOT put frozen dough into cabinet

Call Toll-free: 877-CRES COR (273-7267) • Fax: 800-822-0393 • www.crescor.com

Proof/Hot

Cabinets

Rev. 7 (10/08)

FL-2212

Page 2 of 4

5925 Heisley Road • Mentor, OH 44060-1833

OPERATING and MAINTENANCE INSTRUCTIONS

Models: 120PH, 121PH and 126 PH Series Proof/Hot Cabinets

HOW TO HOLD

1. Push “POWER” switch to “ON.” The yellow light will come on.

2. Push “MODE SELECTION” switch to “HEAT.”

The red light will come on.

3. Turn “AIR” dial to temperature needed.

NOTE: No. 8 is about 175°F (79°C).

No. 6 is about 145°F (63°C).

No. 4 is about 115°F (46°C).

Proper food holding temperature is 140°F (60°C) or higher.

4. Preheat cabinet for 30 minutes.

5. Put food into cabinet.

HOW TO TURN UNIT OFF:

Push “POWER” switch to “OFF” position.

WARNING

RISK OF FIRE OR ELECTRIC SHOCK

DO NOT OPEN

WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK,

DO NOT REMOVE COVER (OR BACK)

NO USER-SERVICEABLE PARTS INSIDE

REPAIR SHOULD BE DONE BY AUTHORIZED SERVICE

PERSONNEL ONLY

MAINTENANCE:

HOT UNIT REMOVAL INSTRUCTIONS:

1. Unplug power cord from wall outlet.

2. Remove screw from back of cabinet located just above cord.

3. Pull entire unit out the front of the cabinet.

HOW TO CLEAN THE CABINET:

WARNING

BEFORE cleaning the cabinet:

1. Allow cabinet to cool.

2. Remove Hot unit from cabinet.

3. Do NOT use abrasives or harsh chemicals.

Cleaning Notes:

1. Wipe up spills as soon as possible.

2. Clean cabinet regularly to avoid heavy dirt buildup.

3. Make a test spot with cleaner.

4. Follow manufacturer’s directions on cleaner.

5. Do not mix cleaners.

6. Avoid drips and splashes.

7. Empty water pan at least once a week.

CAUTION

DELIME OR DESCALE RESERVOIR PARTS AS

REQUIRED TO PREVENT DAMAGING BUILD-UP.

WARRANTY COVERAGE MAY BE AFFECTED WITHOUT PROPER

CLEANING.

Call Toll-free: 877-CRES COR (273-7267) • Fax: 800-822-0393 • www.crescor.com

Proof/Hot

Cabinets

Rev. 7 (10/08)

FL-2212

Page 3 of 4

5925 Heisley Road • Mentor, OH 44060-1833

OPERATING and MAINTENANCE INSTRUCTIONS

Models: 120PH, 121PH and 126 PH Series Proof/Hot Cabinets

HOW TO CLEAN UNIT:

DOOR

(Polycarbonate)

CABINETS

Inside and Outside

(Aluminum)

Dirt

SOIL CLEANER

Mild detergent* and water.

METHOD

1. Wipe with soft, damp cloth.

2. Rinse well.

Grease and Oil

Weak, alcohol-type cleaner.

Mild detergent* and hot water, or mild abrasive cleaner.

1. Wipe with soft, damp cloth.

2. Rinse well.

1. Use soft, damp cloth.

2. Rinse with hot water.

3. Wipe dry.

Dirt

Fingerprints,

Grease and Oil

Steam (No strong alkaline additive).

Chemical oven cleaner for aluminum. Mild abrasive cleaner; oily or waxy cleaner.

1. Rinse after steam cleaning.

2. Wipe dry.

Follow oven cleaner manufacturer’s directions.

Apply with clean, soft cloth.

Water Spots

Mild abrasive cleaner, Oily or waxy cleaner.

Apply with soft, clean cloth.

Wipe with damp cloths.

*Mild detergents include soaps and non-abrasive cleaners.

TROUBLE-SHOOTING CHART:

FAILURE

1. Indicator lights do NOT light.

2. Unit does not heat.

3. Unit gets too hot or won’t shut off.

4. Humidity is low

POSSIBLE CAUSE

1a. Circuit breaker/fuse to wall outlet is blown.

1b. Cord is unplugged from wall outlet or cabinet.

1c. Switch is “OFF”.

2a. Thermostat set too low or is “OFF”.

2b. Switch is “OFF”.

3a. Defective electrical parts.

UNPLUG UNIT FROM WALL OUTLET.

4a. Water in pan may be low

4b. Thermostat set too low

5a. Defective blower.

5. Blower does not work or makes noise.

NOTE: Optional digital thermometer will fl ash if cabinet temperature is below 140°F or above 250°F.

Call the factory if you need different settings.

If cause is none of the above, refer to our list of Authorized Service Centers, FL-1400.

Call Toll-free: 877-CRES COR (273-7267) • Fax: 800-822-0393 • www.crescor.com

Proof/Hot

Cabinets

Rev. 7 (10/08)

FL-2212

Page 4 of 4

5925 Heisley Road • Mentor, OH 44060-1833

OPERATING and MAINTENANCE INSTRUCTIONS

Models: 120PH, 121PH and 126 PH Series Proof/Hot Cabinets

REPLACEMENT PARTS:

DESCRIPTION

Proof/Hot Unit (121PH)

Proof/Hot Unit (120PH)

Heater (Reservoir)

Pan (Reservoir)

Heater (Air)

Thermostat Kit

Thermometer Kit (Analog)

Power Cord

Proof & Heat Lights

Power Light

Switch (Power)

Switch (Mode Selection)

Blower Kit

Drip Pan Kit

120 VOLT

PHU-747-071

PHU-747-077

0811-285

1017-097

0811-214

0848-062-K

5238-030-K

0810-065-1

0766-093

0766-094

0808-116

0808-117

0769-180-K

1017-058

208 VOLT

PHU-747-072

PHU-747-078

0811-286

1017-097

0811-250

0848-062-K

5238-030-K

0810-039

0766-093-1

0766-095

0808-116

0808-117

0769-182-K

1017-058

240 VOLT

PHU-747-073

PHU-747-079

0811-287

1017-097

0811-215

0848-062-K

5238-030-K

0810-039

0766-093-1

0766-095

0808-116

0808-117

0769-182-K

1017-058

LEGEND

SLEEVING

SPLICE

50

51 51

1 2

50

3 4

5 8

FOR 120V

TRANSFORMER

110V/220V

50

51 51

1 2

52

3 4

50

FOR 220V

TRANSFORMER

110V/220V

5 8

13

12

11

10

MODE SELECTION

SWITCH

9 t°

SENSOR

DIP SWITCH (SW1)

SETTINGS

1 2 3 1 2 3

OFF

F°

OFF

C° t°

SENSOR

12

14

14 50

11 51

OPTIONAL

7

AIR

THERMOSTAT

R A

7

8

INDICATOR

LIGHTS

5

TERMINAL

BLOCK

BLOWER

9

8

AIR

HEATERS 10

15

ELECTRICAL SPECS.

MODEL# 0747-055

2000W, 120V, 60Hz, 1Ph

AC SERVICE

MODEL# 0747-056

2000W, 240V, 60Hz, 1Ph

AC SERVICE

4

3

15

HUMIDITY

THERMOSTAT

13

5

6

3 4

6

6-15P

240V, 15A

W

A PILOT

LIGHT

WATER

HEATER

2 2

TERMINAL

BLOCK

L2

G

B

5-20P

120V, 20A

W

G

G

1 1 L1

B G

POWER

SWITCH

Call Toll-free: 877-CRES COR (273-7267) • Fax: 800-822-0393 • www.crescor.com