Specifications | Braun 550 CC-4 Electric Shaver User Manual

Leporello, 130x175 mm, 12 pages, 2/2c = black + HKS43N
Series 5
se
ns
iittii
vv
Series 5
e
+
-
Type 5751
www.braun.com
99503133_590-550cc-4_Korea 13
590 cc-4
550 cc-4
05.07.2010 13:38:47 Uhr
3
4
5
7
Series 5
2
9
1
10
11
se
nss
iittii
vv
8
12
e
13
+
+
-
-
14
6
15
16
17
590
550
18
STOP
19
s5
Serie
STOP
+
s en
ssiittii
vv
2
99503133_590-550cc-4_Korea 2
05.07.2010 13:38:38 Uhr
A
1
2
new
low
s
B
1
2
3
se
ns
iti
v
1 2 3
e
+
iv
s it
wa
sh
ab
le
se
n
-
se
itiv
ns
90°
3
99503133_590-550cc-4_Korea 3
05.07.2010 13:38:40 Uhr
C
a
new
•••
b
+
•••
s
c
an
clenn
clcleaea
old
www
lololo
D
full
full
sensitive
sensitive
an
clenn
clcleaea
www
lololo
full
se
ns
iti
ve
sensitive
e
itiv
ns
se
on • off
on •
off
4
99503133_590-550cc-4_Korea 4
05.07.2010 13:38:41 Uhr
5
99503133_590-550cc-4_Korea 5
05.07.2010 13:38:42 Uhr
6
99503133_590-550cc-4_Korea 6
05.07.2010 13:38:43 Uhr
7
99503133_590-550cc-4_Korea 7
05.07.2010 13:38:44 Uhr
8
99503133_590-550cc-4_Korea 8
05.07.2010 13:38:45 Uhr
English
Our products are designed to meet the
highest standards of quality, functionality and
design. We hope you enjoy your new Braun
Shaver.
Warning
Your shaving system is provided with a
special cord set, which has an integrated
Safety Extra Low Voltage power supply. Do
not exchange or tamper with any part of it,
otherwise there is risk of an electric shock.
This appliance is not intended for use by
children or persons with reduced physical,
sensory or mental capabilities, unless they
are given supervision by a person responsible
for their safety. In general, we recommend
that you keep the appliance out of reach of
children. Children should be supervised to
ensure that they do not play with the
appliance.
To prevent the cleaning fluid from leaking,
ensure that the Clean&Renew station is
placed on a flat surface. When a cleaning
cartridge is installed, do not tip, move
suddenly or transport the station in any
way as cleaning fluid might spill out of the
cartridge. Do not place the station inside a
mirror cabinet, nor place it on a polished or
lacquered surface.
The cleaning cartridge contains a highly
flammable liquid so keep it away from
sources of ignition. Do not expose to direct
sunlight and cigarette smoking nor store it
over a radiator.
Do not refill the cartridge and use only
original Braun refill cartridges.
Description
Clean&Renew station
1 Level indicator
2 Lift button for cartridge exchange
3 Station-to-shaver contacts
4 Start button
5 Station power socket
6 Cleaning cartridge
Shaver
7 Shaver foil
8 Cutter block
9 Foil release buttons
10 Long hair trimmer
11 Comfort setting switch «sensitive»
12 Shaver-to-station contacts
13 On/off switch
14 Shaver display
15 Cleaning light (yellow)
16 Replacement light for shaving parts
17 Shaver power socket
18 Special cord set
19 Etui
A Before shaving
Prior to first use, you have to connect the
shaver to an electrical outlet using the special
cord set (18) or alternatively, proceed as
follows:
Installing the Clean&Renew station
• Using the special cord set (18), connect
the station power socket (5) to an electrical
outlet.
• Press the lift button (2) to open the housing.
• Hold the cleaning cartridge (6) down on a
flat, stable surface (e.g. table).
• Carefully remove the lid from the cartridge.
• Slide the cartridge into the base of the
station as far as it will go.
• Slowly close the housing by pushing it
down until it locks.
Charging the shaver in the Clean&Renew
station
Insert the shaver head down into the cleaning
station. (The contacts (12) on the back of the
shaver will align with the contacts (3) in the
cleaning station).
If required, the Clean&Renew station will start
charging the shaver now.
A full charge provides up to 45 minutes of
cordless shaving time. This may vary
according to your beard growth.
9
99503133_590-550cc-4_Korea 9
05.07.2010 13:38:46 Uhr
The best environmental temperature for
charging is between 5 °C to 35 °C. Do not
expose the shaver to temperatures higher
than 50 °C for extended periods of time.
Shaver display
The shaver display (14) shows the charge
status of the battery. During charging or
when using the shaver, the respective battery
segment will blink (green). When fully
charged, all segments will light up for
approximately one hour, provided the shaver
sits in the C&R station.
The red low-charge light flashes when the
battery is running low.
You should be able to finish your shave.
B Shaving
Press the on/off switch (13) to operate the
shaver.
Comfort setting switch «sensitive»
Setting the shaver head according to your
comfort needs.
The «sensitive» switch (11) provides three
options for comfort setting:
1 «+»:
The shaver head is in full swing, freely
follows the contours of your skin to
provide more comfort.
2 middle position:
The shaver head is semi-fixed for more
control.
3 «–»:
The shaver head is fixed for full control
and precise handling in hard to reach
areas.
Long hair trimmer
To trim sideburns, moustache or beard, slide
the long hair trimmer (10) upwards.
Tips for the perfect shave
For best results, Braun recommends you
follow 3 simple steps:
1. Always shave before washing your face.
2. At all times, hold the shaver at right
angles (90°) to your skin.
3. Stretch your skin and shave against the
direction of your beard growth.
Shaving with the cord
If the shaver has run out of power
(discharged), you may also shave with the
shaver connected to an electrical outlet via
the special cord set.
Cleaning
For best shaving results, we recommend
cleaning the shaver in the station after each
shave (see «Automatic cleaning»).
All charging and cleaning needs are then
automatically taken care of.
Cleaning indicator
Clean your shaver in the Clean&Renew
station at the latest when the yellow cleaning
light (15) shines constantly after shaving.
If this is not done, the cleaning light will go
off after some time and the counter will be
reset.
C Automatic cleaning
The Clean&Renew has been developed for
cleaning, charging and storing your shaver.
After each shave, return the shaver to the
Clean&Renew station and proceed as
follows:
• Insert the shaver head down into the
cleaning station.
• Push down the start button (4). The cleaning process will start (approx. 5 minutes
cleaning, 4 hours drying).
• Do not interrupt the cleaning process, as
it leaves the shaver wet and not fit for use.
If interruption is needed nonetheless, press
the start button (4).
10
99503133_590-550cc-4_Korea 10
05.07.2010 13:38:46 Uhr
• When cleaning is finished, the yellow
cleaning light will go off and the shaver is
ready for use.
• A cleaning cartridge should be sufficient for
about 30 cleaning cycles. When the level
indicator (1) has reached the «min» mark,
the remaining fluid in the cartridge is
sufficient for about 5 more cycles. Then the
cartridge should be replaced, when used
daily approx. every 4 weeks.
• The hygienic cleaning cartridge contains
alcohol, which once opened will naturally
evaporate slowly into the surrounding air.
Each cartridge, if not daily used, should be
replaced after approximately 8 weeks.
• The cleaning cartridge also contains
lubricates, which may leave residual marks
on the shaver head after cleaning.
However, these marks can be removed
easily by wiping gently with a cloth or soft
tissue paper.
Cleaning the housing
From time to time clean the housing of the
shaver and the Clean&Renew station with a
damp cloth, especially inside the cleaning
chamber where the shaver rests.
Replacing the cleaning cartridge
After having pressed the lift button (2) to
open the housing, wait for a few seconds
before removing the used cartridge to avoid
any dripping.
Before discarding the used cartridge, make
sure to close the openings using the lid of the
new cartridge, since the used cartridge will
contain contaminated cleaning solution.
D Manual cleaning
The shaver head is suitable for
cleaning under running tap water.
Warning: Detach the shaver from the
power supply before cleaning the
shaver head in water.
Rinsing the shaver head under running water
is an alternative way to keep the shaver
clean, especially when traveling:
• Switch the shaver on (cordless) and rinse
the shaver head under hot running water.
You may use liquid soap without abrasive
substances. Rinse off all foam and let the
shaver run for a few more seconds.
• Next, switch off the shaver, press the foil
release buttons (9) to remove the shaver
foil (7) and cutter block (8). Then leave the
disassembled shaving parts to dry.
• If you regularly clean the shaver under
water, then once a week apply a drop of
light machine oil onto the long hair trimmer
(10) and shaver foil (7).
The following quick cleaning is another
alternative cleaning method:
• Press the foil release buttons (9) to lift
the shaver foil (do not remove the foil
completely). Switch on the shaver for
approx. 5–10 seconds so that the shaved
stubbles can fall out.
• Switch off the shaver. Remove the shaver
foil and tap it out on a flat surface. Using
a brush, clean the inner area of the shaver
head. However, do not clean the shaver foil
nor the cutter block with the brush as this
will damage them.
Keeping your shaver in top
shape
Replacing the foil and cutter block / reset
To maintain 100% shaving performance,
replace the shaver foil (7) and cutter block (8),
when the replacement symbol (16) lights up
(after about 18 months) or when cassette is
worn.
The replacement symbol will remind you
during the next 7 shaves to replace the
shaver foil and cutter block. Then the shaver
will automatically reset the display.
After you have replaced the shaving parts (foil
and cutter block), press the on/off switch (13)
for at least 5 seconds to reset the counter.
While doing so, the replacement light blinks
and goes off when the reset is complete.
The manual reset can be done at any time.
11
99503133_590-550cc-4_Korea 11
05.07.2010 13:38:46 Uhr
Accessories
Available at your dealer or Braun Service
Centres:
• Shaver foil and cutter block: 51S
• Cleaning cartridge Clean&Renew: CCR
Environmental notice
This product contains rechargeable
batteries. In the interest of protecting
the environment, please do not
dispose of the product in the household waste at the end of its useful life.
Disposal can take place at a Braun Service
Centre or at appropriate collection points
provided in your country.
The cleaning cartridge can be disposed with
regular household waste.
Subject to change without notice.
For electric specifications, see printing on the
special cord set.
99503133/VII-10
Korea/GB
12
99503133_590-550cc-4_Korea 12
05.07.2010 13:38:47 Uhr
Download PDF

advertising