Brookstone WIRELESS BLUETOOTH SPEAKER Speaker System User Manual

LI-ION BATTERY WARNINGS
Big Blue Go™
WIRELESS BLUETOOTH SPEAKER
®
This device contains a Lithium-ion
battery. The battery must be recycled
or disposed of properly. Contact your
local waste management office for
information on battery recycling
or disposal.
FCC INFORMATION
This equipment has been tested
and found to comply with the
limits for a Class B Digital Device,
pursuant to Part 15 of the FCC
Rules. These limits are designed to
provide reasonable protection against
harmful interference in a residential
installation. This equipment generates,
uses, and can radiate radio frequency
energy and, if not installed and used
in accordance with the instructions,
may cause harmful interference to
radio communications. However, there
is no guarantee that interference will
not occur in a particular installation.
If this equipment does cause harmful
interference to radio or television
reception, which can be determined
by turning the equipment off and
on, the user is encouraged to try to
correct the interference by one or
more of the following measures:
• Reorient or relocate the
receiving antenna.
• Increase the distance between
the equipment and receiver.
• Connect the equipment to an outlet
on a circuit different from that to
which the receiver is connected.
• Consult the dealer or an
experienced radio/TV technician
for help.
This equipment complies with
Part 15 of the FCC Rules.
Operation is subject to the
following two conditions:
1. T
his equipment may not cause
harmful interference.
2. T
his equipment must accept any
interference received, including
interference that may cause
undesired operation.
Modifications not authorized by the
manufacturer may void the user’s
authority to operate this device.
This equipment complies with FCC
RF radiation exposure limits set forth
for an uncontrolled environment. This
transmitter must not be co-located or
operating in conjunction with any other
antenna or transmitter.
RSS INFORMATION
This device complies with RSS-210
of the IC Rules; Operation is subject
to the following two conditions: (1)
this device may not cause harmful
interference, and (2) this device must
accept any interference received,
including interference that may cause
undesired operation.
Cet appareil est conforme à la norme
RSS-210 de la règlementation
d'Industrie Canada ; son utilisation
est soumise aux deux conditions
suivantes :
(1) l'appareil ne doit pas produire de
brouillage, et
(2) l'utilisateur de l'appareil
doit accepter tout brouillage
radioélectrique subi, même si le
brouillage est susceptible d'en
compromettre le fonctionnement.
The device meets the exemption from
the routine evaluation limits in section
2.5 of RSS 102 and compliance with
RSS-102 RF exposure. Users can
obtain Canadian information on RF
exposure and compliance.
Le dispositif rencontre l'exemption
des limites courantes d'évaluation
dans la section 2.5 de RSS 102
et la conformité à l'exposition
de RSS-102 rf, utilisateurs peut
obtenir l'information canadienne sur
l'exposition et la conformité de rf.
This Class B digital apparatus
complies with Canadian ICES-003.
Cet appareil numérique de la classe
B est conforme à la norme NMB-003
du Canada.
LOCATION OF PARTS
AND CONTROLS
1. Charging LED Indicator (behind speaker grill)
2. LED Ring
3. Pairing/Play/Pause Button
LOCATION OF PARTS
AND CONTROLS
1
CHARGING THE SPEAKER
BLUETOOTH® DEVICES
1. Insert the included USB cable's
MICRO USB connection into the
MICRO USB CHARGING PORT
on the speaker.
he speaker pairs with devices
T
that use the Bluetooth® Hands
Free Profile (HFP) and/or the
Advanced Audio Distribution Profile
(A2DP). HFP enables hands-free
communication and the A2DP
dictates how audio is streamed
from one device to another over
a Bluetooth® connection. When
you pair devices to the speaker,
the devices operate according
to their protocols. For example,
when you pair a smartphone to the
speaker, it handles calls and plays
music since it has both the HFP
and A2DP protocols. MP3 players
with Bluetooth® and A2DP only
play music and cell phones (not
smartphones) only handle calls.
2. The speaker can be charged several ways:
2
4. Micro USB Charging Port
• Plug the USB cable's USB
connection into the included
AC/DC power adapter. Plug the AC/DC power adapter into an electrical wall outlet.
5. Power/Battery Level Switch
6. Volume Up Button
3
7. Volume Down Button
8. Call Answer/Track Forward Button
9. Call End or Ignore/Track Back Button
5
4
10.Vehicle Suction Mount
• Plug the USB cable's USB
connection into the included 12V/24V CAR ADAPTER and
plug the 12V/24V CAR
ADAPTER into your vehicle's DC socket.
11.12V/24V Car Adapter
• Plug the USB cable's USB connection into your computer’s USB port.
12.AC/DC Adapter
13.USB to Micro USB Charging Cable
6
7
8
9
12
10
11
3.
The CHARGING LED INDICATOR
is RED while the speaker is charging. When the speaker is fully charged, the CHARGING LED INDICATOR is GREEN. For first time use, charge the speaker for at least 3 hours.
4. When speaker's battery is low, the CHARGING LED INDICATOR will flash RED.
13
PAIRING YOUR DEVICE
1. P
repare your device to pair using
Bluetooth® wireless technology,
making sure you are within 33
feet of the speaker. Refer to
your device’s owner's manual for
details if necessary.
2.
Slide the POWER SWITCH to l
to turn the speaker on. A tone
will sound and the LED RING will
illuminate solid blue for 5 seconds.
Note: When the LED RING is off and
any button is pressed, the LED RING
Merrimack, New Hampshire, USA 03054
800-846-3000 • Brookstone.com
840066
will illuminate solid blue for 5 seconds
and then turn off.
3. To put the speaker into pairing
mode, press and hold the PAIRING BUTTON until the LED
RING starts flashing. The
speaker will wait for a connection in pairing mode for two minutes.
PHONE OPERATION
LISTENING TO AUDIO
SLEEP MODE
TROUBLESHOOTING
1. W
hen a call is received, a tone
sounds, the name of the caller is
announced (if the caller's number
is in the contacts of the phone
paired with the speaker), and
the voice prompt asks for the
"Answer" or "Ignore" command.
1.
Press the TRACK FORWARD BUTTON
to go to the next
track. Press and hold the TRACK FORWARD BUTTON
to forward within a track.
NO POWER
• Make sure the speaker is charged.
4.
2. To answer the call, say "Answer"
or press the CALL ANSWER
BUTTON .
2.
Press the TRACK BACK BUTTON
to go to the
previous track. Press and hold the TRACK BACK BUTTON
to move backward within a track.
If the speaker has not been
connected to a device for 30
minutes, it will enter sleep mode
to preserve battery life. Press any
button to exit sleep mode. A tone
will sound and the LED RING will
illuminate solid blue for 5 seconds.
3.
To pause audio, press the PLAY/
PAUSE BUTTON. To resume
audio, press the PLAY/PAUSE BUTTON.
Once the speaker is in pairing
mode and your device is ready to
pair, select “Big Blue Go" on your device. If prompted, use 0000 as a PIN for the pairing code. Once the
speaker is selected, the LED RING will change to solid blue and a tone will sound to confirm
pairing is complete.
Note: After the initial pairing of
your device, the speaker should
automatically pair with your device
the next time you power the speaker
on. Depending upon your device, you
may have to select “Big Blue Go” in
your device's Bluetooth menu.
3. To ignore the call, say "Ignore" or
press the CALL REJECT BUTTON .
4.
To switch a call from the
speaker to the phone for a
private conversation, press the CALL ANSWER BUTTON
twice.
5.
To switch a call from the phone back to the speaker, press the CALL ANSWER BUTTON
twice.
6. To end an active call, press the CALL END BUTTON .
7. Press the VOLUME UP BUTTON to increase the call volume.
8. Press the VOLUME DOWN BUTTON to decrease the call
volume.
4. Press the VOLUME UP BUTTON to increase audio volume.
5. Press the VOLUME DOWN
BUTTON to decrease audio volume.
Note: Incoming phone calls take
priority over audio. If a call is
received while audio is playing, the
audio will pause. After the call is
ended or ignored, the audio will
resume play.
SOUND IS NOT CLEAR OR
THERE IS NO SOUND
• Power the speaker off and then back on.
USING THE SUCTION MOUNT
• Adjust your device’s equalizer.
1. P
ush the LOCK LEVER up to
unlock the SUCTION CUP.
• Check the speaker's or your device’s volume level.
2.
Firmly press the SUCTION CUP onto your vehicle's windshield and push the LOCK LEVER down
to secure the SUCTION CUP.
3.
Place the LOCK NUT over the BALL JOINT and snap the
BRACKET onto the BALL JOINT. Secure by tightening the
LOCK NUT onto the BRACKET.
4. Snap the speaker securely into the BRACKET.
• Confirm device is paired to the speaker.
• Confirm device is in connection range to the speaker.
PHONE CALL IS NOT
ANSWERED BY SPEAKER
• Confirm device is paired to the speaker.
• Make sure your cellphone has HFP.
Bracket
BATTERY LEVEL
Lock Nut
To hear the speaker's battery level, slide the POWER SWITCH to
.
The battery life level is announced.
Ball Joint
Lock Lever
Suction Cup
• Restart the speaker to auto-
connect with your Bluetooth® device.
AUDIO DOES NOT PLAY AFTER
ENDING A CALL
• Press the PLAY/PAUSE BUTTON to resume audio.
SPEAKER DOES NOT CONTROL
DEVICE AUDIO FUNCTIONS
• Make sure your Bluetooth® device
has AVRCP.
CARE AND STORAGE
SPECIFICATIONS
ONE (1) YEAR LIMITED WARRANTY
Warning: this product contains a
lithium-ion battery. To prevent injury,
remove the unit from the vehicle when
exiting or store it out of direct sunlight.
Clean the speaker with a soft, dry
cloth.
Power Supply:
AC 100-240V~50/60Hz,
DC 5V 700mA
COMPATIBILITY
Charging Time: Approx. 3 hours
Bluetooth® 2.0 or above device with
A2DP/AVRCP/HFP/HSP.
Battery Life: Approx. 10 hours
Brookstone® warrants this product against
defects in materials and/or workmanship under
normal use for a period of ONE (1) YEAR from
the date of purchase by the original purchaser
(“Warranty Period”). If a defect arises and a
valid claim is received within the Warranty
Period, at its option, Brookstone will either
1) repair the defect at no charge, using
new or refurbished replacement parts, or
2) replace the product with a new product that
is at least functionally equivalent to the original
product, or 3) provide a store credit in the
amount of the purchase price of the original
product. A replacement product or part, including
a user-installable part installed in accordance with
instructions provided by Brookstone, assumes
the remaining warranty of the original product.
When a product or part is exchanged, any
replacement item becomes your property and the
replaced item becomes Brookstone’s property.
When a store credit is given, the original product
must be returned to Brookstone and becomes
Brookstone’s property.
Battery Type: Li-Ion,1150 mAH
Range: Up to 33 ft
Weight: Approx 0.7lbs
Dimensions: Approx 4.9" x 1.1" x 3.7"
Obtaining Service: To obtain warranty service,
call Brookstone Limited Warranty Service at
1-800-292-9819. Please be prepared to
describe the product that needs service and
the nature of the problem. A purchase receipt
is required. All repairs and replacements must
be authorized in advance. Service options, parts
availability and response times will vary. You are
responsible for delivery and the cost of delivery of
the product or any parts to the authorized service
center for replacement, per our instructions.
Limits and Exclusions: Coverage under this
Limited Warranty is limited to the United States of
America, including the District of Columbia and the
U.S. Territories of Guam, Puerto Rico, and the U.S.
Virgin Islands. This Limited Warranty applies only
to products manufactured for Brookstone that can
be identified by the “Brookstone” trademark, trade
name, or logo affixed to them or their packaging.
The Limited Warranty does not apply to any nonBrookstone products. Manufacturers or suppliers
other than Brookstone may provide their own
warranties to the purchaser, but Brookstone,
in so far as permitted by law, provides these
products “as is.” This warranty does not apply to:
a) damage caused by failure to follow instructions
relating to product’s use or the installation of
components; b) damage caused by accident,
abuse, misuse, fire, floods, earthquake or other
external causes; c) damage caused by service
performed by anyone who is not a representative
of Brookstone; d) accessories used in conjunction
with a covered product; e) a product or part
that has been modified to alter functionality or
capability; f) items intended to be periodically
replaced by the purchaser during the normal
life of the product including, without limitation,
batteries or light bulbs; g) any product sold
“as is” including, without limitation, floor
demonstration models and refurbished items;
or h) a product that is used commercially or for a
commercial purpose.
BROOKSTONE SHALL NOT BE LIABLE
FOR INCIDENTAL OR CONSEQUENTIAL
DAMAGES RESULTING FROM THE USE
OF THIS PRODUCT, OR ARISING OUT OF
ANY BREACH OF THIS WARRANTY. TO THE
EXTENT PERMITTED BY APPLICABLE LAW,
BROOKSTONE DISCLAIMS ANY AND ALL
STATUTORY OR IMPLIED WARRANTIES,
INCLUDING,
WITHOUT
LIMITATION,
WARRANTIES OF MERCHANTABILITY,
FITNESS FOR A PARTICULAR PURPOSE
AND WARRANTIES AGAINST HIDDEN
OR LATENT DEFECTS. IF BROOKSTONE
CANNOT LAWFULLY DISCLAIM STATUTORY
OR IMPLIED WARRANTIES, THEN TO THE
EXTENT PERMITTED BY LAW, ALL SUCH
WARRANTIES SHALL BE LIMITED IN
DURATION TO THE DURATION OF THIS
EXPRESS WARRANTY.
Some states disallow the exclusion or limitation of
incidental or consequential damages or how long
an implied warranty lasts, so the above exclusions
or limitations may not apply to you. This warranty
gives you specific legal rights and you may also
have other rights, which vary from state to state.