- No category
advertisement
◉
Touch to zoom
Warrior DVX The Vertical Co-Axial Direct Vent Gas Water Heater for Manufactured Housing Available in 40 and 50 Gallon Tall Gas Models NEW FVIR Compliant! NEW Roof Jack Flange Adjustment Range Available up to 34° (8 - 12) NEW Smaller Foot Print – No External Air Tube 1-Year Limited Tank Warranty* 1-Year Limited Parts Warranty* • Installed side mounted T&P valve • Can be installed anywhere in the home • Field convertible controls for natural gas • All models are certified for applications up to 7,700 feet above sea level. • Certified for manufactured (HUD) and modular construction or LP operation • 3/4" hot and cold top connections • Meets or exceeds National Appliance *See Residential Warranty Information Brochure for complete warranty information. Energy Conservation Act (NAECA) requirements • Piezo ignitor – easy light pilot • Easily fits into a standard drain pan DESCRIPTION T Y P E T A L L GAL. CAP. MODEL NUMBER FEATURES GAS INPUT IN THOUS. BTU/HR. NAT. LP Energy Factor and Average Annual Operating Costs based on D.O.E. (Department of Energy) test procedures. D.O.E. national average fuel rate natural gas 91¢/therm; LP $1.23/gallon. ROUGHING IN DIMENSIONS (SHOWN IN INCHES) RECOVERY IN G.P.H. 90° RISE NAT. LP FIRST HOUR DEL. G.P.H. NAT. ® ENERGY INFORMATION DIAM. TANK HEIGHT VENT SIZE A B C WATER CONNECTION SHIP. WT. (LBS) ENERGY FACTOR NAT./LP AVG. ANN. OPER. COSTS NAT. LP 40 22I40FDVX 36 30 36.4 30.3 66 19-3/4 59-3/4 5 3/4 155 0.59 $231 $342 50 22I50FDVX 36 32 36.4 32.3 80 21-3/4 59-1/2 5 3/4 165 0.58 $235 $348 THE WARRIOR DVX IS ANSI AND U.L. CERTIFIED FOR USE IN MODULAR HOME CONSTRUCTION AND MANUFACTURED HOME USE. THIS UNIT COMPLIES WITH HUD SAFETY AND CONSTRUCTION STANDARDS. TOP VIEW OF CLOSET ADJUSTABLE TILT ROOF FLANGE WATER HEATER WATER CONNECTIONS WATER CONNECTIONS 34° MAX. (8 - 12 PITCH) RELIEF VALVE GAS CONTROL (THERMOSTAT) 42° MAX. TILT IS AVAILABLE WITH OPTIONAL KIT (10-3/4 - 12 PITCH) FRONT VIEW Roof Jack (Purchased Separately) These units are designed to meet or exceed ANSI (American National Standards Institute) requirements and have been tested according to D.O.E. test procedures and meet or exceed the energy efficiency requirements of NAECA, ASHRAE standard 90, ICC Code and all state energy efficiency performance criteria for energy consuming appliances. Before purchasing this appliance, read important energy cost and efficiency information available from your supplier. CO-AXIALROOF JACK SIZING TABLE 34° MAX. (8-12 PITCH) ROOF JACK KIT PART NUMBER ROOF JACK ADJUSTMENT RANGE (SEE X) AP14363A 24 - 37 Inches AP14363B 33 - 68 Inches AP14363C 45 - 97 Inches AP14363D 60 - 130 Inches AP14363E 72 - 160 Inches Roof Jack Adjustment Range C X NOTE: 42° Max. adjustment roof jacks available. Roof Jacks must be ordered separately with this direct vent water heater and installed in accordance with the instructions furnished with the heater. No other roof jack or vertical vent kit is approved for installation with this heater. 12" Min A B In keeping with its policy of continuous progress and product improvement, Rheem reserves the right to make changes without notice. Rheem Water Heaters • 101 Bell Road, Montgomery, Alabama 36117-4305 • www.rheem.com P R I N T E D I N U. S . A 10/07 WP F O R M N O. 1 0 2 G - 8 R e v. 3
advertisement
* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project