Casio 5298 Watch User Manual

Casio 5298 Watch User Manual
MA1202-EA
Ú#!3)/#/-054%2#/,4$
Operation Guide 5298
 Your watch may differ somewhat from the one shown in the illustration.
 Some models may use a combination of hands and rotating disks to indicate
information. The word “hand” in this section is used to mean both analog hands
and rotating disks.
Elapsed time
24 Hour Hand
Minute Hand
Hour Hand
Using the Stopwatch
The stopwatch measures elapsed time in 1-second increments up to 29 minutes,
59 seconds.
A
Stopwatch Minute Hand
A
A
A
A
B
Start
Stop
Re-start
Stop
Reset
Important!
Click 2
Do not operate the stopwatch with the crown pulled out.
Click 1
Note
An elapsed time operation will stop automatically at the end of 30 minutes.
Second Hand
B
Crown
Stopwatch Second Hand
Correcting the 0 Positions of the Hands
Day Indicator
Perform the following procedure if the stopwatch hands do not return to their 0 (zero)
positions when you reset the stopwatch.
Stopwatch functions
To adjust the time setting
When the second hand is at
12 o’clock, pull the Crown out to
Click 2.
Pull the Crown out to Click 2.
To change the day indicator setting
Pull the Crown out to Click 1.
Rotate the Crown to set the day.
Rotate the Crown to change the
time setting.
Push the Crown back in.
After all of the hands are the way you want, push the Crown back in.
Note
Push the Crown back in.
Note
 Take care that you set the correct AM
or PM time.
 When changing the time, move the
minute hand four or five minutes past
your final setting, and then back it up
to the setting you want.
Use A (clockwise) and B (counterclockwise) to move the
Stopwatch Second Hand and Stopwatch Minute Hand to 12 o'clock.
 Holding down either button will move the second hand at high speed, until you
release the button.
 The Stopwatch Minute Hand is syncronized with the Stopwatch Second Hand .
 The day indicator setting uses a 31day month. Make adjustments for
months of shorter lengths.
 Avoid changing the day indicator
setting between the hours of 9
p.m. and 1 a.m. Otherwise, the day
indicator may not change correctly at
midnight.
Important!
Timekeeping stops while the crown is pulled out. Correct the current time setting after
performing the above operation.
Specifications
Crown Operations
Some water-resistant models (100 meters, 200 meters)
have a screw-in crown. When you need to perform a crown
operation, rotate it towards you to unscrew it. Then pull
the crown out. Avoid applying undue force when pulling.
The watch loses its water resistance while the crown is
unscrewed. After performing a crown operation, fully screw
the crown back in.
Crown
Accuracy: ±20 seconds average per month
Stopwatch: Measuring Capacity: 29'59" (30 minutes)
Measuring Unit: 1 second
Measurement: Elapsed time
Battery: One silver oxide battery (Type: SR621SW)
Battery Life: Approximately 2 years (30 minutes stopwatch operation per day)
Loosen
If your watch has a rotary bezel...
You can rotate the bezel to align its ▼ mark with the
minute hand. Then you will be able to tell how much
time has elapsed since aligning the ▼ mark.
Start
Elapsed time
Current
1
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement