Chamberlain GA420D Safety Gate User Manual

ChannelPlus Video Hubs
The H838 video hubs distribute antenna or cable signals to up to eight
io n
s
CAT
V
B i-D
f o r ir e c ti
Pa y o n a
-P er l A m
-V i e p w
w & / IR
C ab E n g
le M ine
ode
ms
televisions. The hubs provide two video modulator inputs to
create new channels and have built-in IR engines to
support 5V IR targets.
r
ato
A rs
Mo
dul
3
Telephone Master Hub (4 lines x 6 phones)
ChannelPlus model H616
From
Telco
R
4
T
R
3
T
R
2
T
R
1
T
Out
Expanding the television outputs
Antenna or cable
(H838HHR)
Cable only
(H838BID)
B
+Pwr
Televisions
CATV
/Ant
IR
+12vdc
IR
Gnd
High Headroom Amp w/IR Engine
+12vdc
Telephones
RJ31X
High Headroom Amp w/IR Engine
Model H838HHR shown
Modulators
Expansion
Ports
2
Adaptor (included)
LED glows when
power is applied
1
You may connect as many as 8 more H838s to the outputs of a master H838 for a
total of 64 television outlets. The longest recommended coax run should not
exceed 150’. (That is a total of the coax from master to slave and from slave to TV.)
Typical Installation
350-086 power
supply (included)
modules attach from the top
1) Hook from the top
2) Swing into place
3) push button to lock
Gnd
2
v
G dc
n
IR d
1
Tel
evis
+
B
+P w
)
sions
televi
tsx8 H R
3inpu 838
Hideo ub( usmodelH
V n elPl
Cha
Two models are available.
The H838HHR has the isolation
required by the FCC for any
system that has modulators and
an antenna.
The H838BID has a 5-42MHz
reverse channel to support
bidirectional cable systems
(cable modems, pay-per-view
and interactive cable).
tm
OpenHouse
B
+Pwr
Modulators
Televisions
CATV
/Ant
A
Master H838
A
Connect modulators
to A or B inputs
Up to 8 televisions
IR
Gnd
+12vdc
High Headroom Amp w/IR Engine
B
+Pwr
Modulators
Modulator
CATV
/Ant
A
RG-6 Coaxial cable
Slave H838
IR
Gnd
High Headroom Amp w/IR Engine
+12vdc
The H838 hub work like a zero-loss splitter. The signals
you put on the antenna/CATV input will appear on the
outputs with about 3dB of gain. Modulator inputs will
automatically appear on the outputs at an FCC legal level.
DVD, VCR, or Satellite
Televisions
ChannelPlus model
2181 allows the H838
to expand IR control
also. Use one 2181 for
each slave H838.
B
+Pwr
Modulators
Televisions
CATV
/Ant
A
IR repeating system
Slave H838
IR
Gnd
+12vdc
High Headroom Amp w/IR Engine
B
+Pwr
Modulators
IR information is only
available on port B
Televisions
CATV
/Ant
A
ChannelPlus
H542, H544,
H562, or H564
modulator
Model H933
IR target
Model H973
IR emitter
Typical remote control
To control your video devices, add a modulator with IR repeating, an IR target and
an IR emitter. Point a remote control at the target in the bedroom and IR pulses
are repeated by the emitter, controlling the DVD player in the den.
Any or all of the television ports may have targets connected.
Expanding the modulator inputs
Add a model H881 active combiner and a single modulator input becomes eight.
Specifications: typical @ 25°C ± 5° C
Gain:
H838HHR
CATV/Ant input to TV output
3dB
Modulator input to TV output
-10dB
TV output to CATV/Ant input
na
(5-42MHZ reverse channel)
Isolation
Modulator input to CATV/Ant
>80dB
Bandwidth
Forward
5-806MHz
Reverse
na
Max CATV/Antenna input
20dBmV
(64 channels)
Power supply (370-086 included)
15 VDC @ 300mA
H838BID
3dB
-10dB
-15dB
>35dB
54-806MHz
5-42MHz
20dBmV
15 VDC @ 300mA
Things To Watch For:
Herringbone interference on modulator channel (diagonal lines): You may have chosen a
channel number that is not completely vacant. Distant UHF stations may not be watchable, but
will cause interference if you try to create a new channel at the same frequency. Also, cable
companies often have extra signals where there should be none. Try moving the modulator
channel to another number. You may have to add a low pass filter to remove the cable company
noise. If the filter does not work, try adding a DC-block to remove common mode interference.
Herringbone interference on many channels, including modulator channels (disappears
when you remove the CATV/antenna feed): The RF amplifier can be overloaded by
abnormally strong signals. Often, you can cure the problem with a simple attenuator. Use a
variable attenuator and try to find a signal level where the interference just disappears.
Sometimes, the problem is one station is far stronger than the rest. In this case, attenuating all
of the signals with a simple attenuator may cause the desired stations to be weak (snowy). You
must reduce the strength of the only offending station. A common FM trap will help if the
problem is a nearby FM tower. If the problem is a nearby TV station, often the station
management can provide suitable filters.
FCC Requirements:
THIS PRODUCT COMPLIES WITH FCC REQUIREMENTS.
A SYSTEM USING THIS DEVICE WILL COMPLY WITH FCC REQUIREMENTS.
USE ONLY VIDEO MODULATORS THAT COMPLY WITH PART 15
OF THE FCC RULES AND HAVE 25dBmV MAX OUTPUT LEVELS. FAILURE TO
DO SO MAY VOID THE USER’S AUTHORITY TO OPERATE THIS EQUIPMENT.
THE H838HHR IS SUITABLE FOR USE WITH AN ANTENNA OR WITH
CATV SYSTEMS.
THE H838BID IS SUITABLE FOR USE WITH CATV SYSTEMS.
600-147 Rev C
Multiplex Technology, Inc., Brea, CA 92821
TM
Compatible
ChannelPlus Enclosures, Modules,
Accessories & Wall Plates
Service center
enclosures
A full line of OpenHouse compatible
enclosures, from simple, inexpensive
mounting plates to high capacity in-wall
cabinets. AC outlets can be mounted
inside the cabinets using a UL listed
accessory.
Good ...
Typical room Media center Home office Better …
Typical room Media center Home office Best …
Typical room Media center Home office -
phone, TV, ethernet, satellite receiver
phone, TV, ethernet, satellite receiver, AV modulators, hi-speed data
phone, TV, ethernet, satellite receiver, cable modem, hi-speed data
phone, TV, ethernet
phone, TV, ethernet, satellite receiver, AV modulators
phone, TV, ethernet, cable modem
phone, TV
phone, satellite receiver, AV modulators
phone, TV, cable modem
2 RG-6
Best
Better
Starter systems
RF splitters and telephone punch
downs. When it is time to upgrade,
just snap this module out and
replace with one of more of the
more sophisticated units.
IN
OUT
OUT
IN
IN
OUT
OUT
IN
OUT
IN
532-230 5MHz to 1000MHz
SPLITTER
From
Telco
R
COMBINER
Telephones
R
T
R
1
T
2
Combo Hub (2 lines x 6 phones, 1input x 4 televisions)
ChannelPlus model H801
Data Hub (8 cables, TIA-568A) Category 5 Compliant
ChannelPlus model H628
Data hubs
Termination blocks for the CAT-5 cables,
Ethernet hubs. Bring the Internet to any
room in the home. Or create a home data
network.
Telephone Master Hub (4 lines x 6 phones)
ChannelPlus model H616
Telephone hubs
Connections for 1-4 phone lines to
every room. Starter hub adds RJ31X jack for security system dialer.
From
Telco
Expansion
Ports
Telephones
RJ31X
R
T
R
3
T
R
2
T
R
1
T
4
Out
Wall plates
Good
2 Cat-5
3 RG-6
3 Cat-5
1 RG-6
2 Cat-5
3 Cat-5
3 RG-6
2 Cat-5
1 RG-6
3 RG-6
2 RG-6
2 Cat-5
3 RG-6
2 RG-6
1 Cat-5
1 Cat-5
1 Cat-5
Home Office
Media Center
Typical Room
The cables in an OpenHouse run from the various rooms of the house
directly to the service center location.(This is known as ‘home run’
wiring.) Two types of wire are used for communication and
entertainment: Cat-5, 4-UTP (4 U nshielded Twisted P airs) wire handles
data or 1 to 4 telephone lines. RG-6 coax handles television (antenna or
cable), satellite dish, cable modem, or AV modulator signals. (An AV
modulator creates new TV channels for front door camera, DVD player, a
VCR or a satellite receiver.)
We recommend the following pre-wire schemes . Run these wires from
the service center to the rooms indicated.
Wiring a house for OpenHouse
3 x 8 Video Hubs
H838HHR & H838BID
Wall plate systems for all rooms. The typical room gets TV
and telephone. The Home office wall plate adds data ports.
The media center wall plate adds satellite feeds.
ChannelPlus
Coax panels
Distribute antenna or cable TV to every
room of the house. Some models include
bi-directional amplifiers for interactive cable
systems. Some models include modulator
inputs and IR engines.
TM
AV modulators
(for service center)
Create a new TV channel for a front
door camera. Some models feature
Cat-5 input connections.
multiplex ®
technology, inc.
3001 Enterprise Street, Brea, CA 92821-6213, U.S.A.
* 800-999-5225 * FAX 714-996-4900 * www.channelplus.com
714-996-4100
AV modulators
(for media center)
Warranty
Multiplex Technology, Inc. warrants this product to be free from defects in materials and workmanship
for a period of one year from the date of purchase or MTI will repair, or at its option, replace the
defective product. To obtain warranty service, call MTI for a return material authorization (RMA)
number and return the product prepaid to Multiplex Technology, Inc., 3001 Enterprise Street, Brea, CA
92821, Attention: Customer Service. Please put the RMA number on the outside of the carton.
Any implied warranty arising from the sale of the product including implied warranties of
merchantability and fitness for purpose are limited to the warranty stated above. MTI shall not be
responsible for losses or damages or expenses, whether direct, consequential or incidental arising
from the use of or the inability to use this product. Some states do not allow limitations on how long the
implied warranty lasts or the exclusion or limitation or incidental or consequential damages, so the
above limitations and exclusions may not apply to you. This warranty gives you specific legal rights,
and you may have other rights which may vary from state to state.
®
select
A
B
C
model 5445 quad digital modulator
program
D
pll frequency control
Create new TV channels for DVD, VCR,
or a satellite receiver. These modulators
sit in the media center. Some offer true
MTS stereo.
IR Accessories
Control video devices from any room.
New ChannelPlus products are added all the time.
Visit our website to learn more: www.channelplus.com
Download PDF

advertising