Channel Vision IR-5000 IR repeater, IR-3002 IR emitters User guide

How IR repeating works

The IR receiver is wired to the IR hub which routes the signal to IR emitters ew at la y> to au se rn ea

1

3

6

2

4

5

8

7 er

9

0

Vo rn ea

Tu er at

TM io n

Vis

Channe

A

B

-5

00

Point an

IR remote control at the IR receiver

And the emitter repeats the IR signal

CD player in front of the component.

Be sure the emitter is attached directly over the component’s IR receiver.

To locate the IR receiver, shine a flashlight into the unit and look for the sensor.

CHANNEL VISION

Limited Warranty

Channel Vision Technology will repair or replace any defect in material or workmanship which occurs during normal use of this product with new or rebuilt parts, free of charge in the USA, for two years from the date of original purchase.

This is a no hassle warranty with no mail in warranty card needed. This warranty does not cover damages in shipment, failures caused by other products not supplied by Channel Vision Technology, or failures due to accident, misuse, abuse, or alteration of the equipment. This warranty is extended only to the original purchaser, and a purchase receipt, invoice, or other proof of original purchase date will be required before warranty repairs are provided.

Mail in service can be obtained during the warranty period by calling (800) 840-

0288 toll free. A Return Authorization number must be obtained in advance and can be marked on the outside of the shipping carton.

This warranty gives you specific legal rights and you may have other rights

(which vary from state to state). If a problem with this product develops during or after the warranty period, please contact Channel Vision Technology, your dealer or any factory-authorized service center.

500-149 rev B

Specifications

Specifications: (typical)

Power Supply Voltage:

IR Freq. range supported:

IR pickup range:

IR receiver head dimensions:

IR emitter outputs:

Color:

8 - 12 VDC

30 kHz - 60 kHz

40 ft. @ 38kHz, 25 ft. @ 56kHz

0.65” x 0.35” x 0.25”

4

Black

Specifications subject to change without notice.

The IR-5000 includes these items:

Power supply

1 - hole mount

2 - IR-3002 emitters

1 - tabletop mount

4 - IR emitter holsters

1 - IR receiver holster

IR receiver head

36”

Features:

!

!

Plasma Proof IR receiver

4 IR emitters

!

Status LEDs for power and IR signal indication

!

Versatile mounting accessories included

LED Status indicators:

Power and IR data

DC Power input

4 IR emitter outputs

Mounting the IR emitter

CD player

Remove the backing from the tape and attach the

IR emitter holster over the IR sensor of the device you wish to control.

Snap IR emitter into the holster as shown.

Mounting the IR receiver: Option 2 - Using the hole mount

Drill a 3/4” hole .

Push the IR receiver head through the hole.

Insert the IR receiver head into the IR receiver hole mount.

Push the IR receiver hole mount and IR receiver head back into the hole.

Mounting the IR receiver: Option 1 - Using the holster

Mount the IR receiver to the TV or on a surface within line of sight of your remote control.

Remove the backing from the tape and attach the

IR receiver holster in the desired location.

Snap IR receiver head into the holster as shown.

Mounting the IR receiver: Option 3 - Using the tabletop mount

Push the IR receiver head through the hole in the tabletop mount.

Insert the IR receiver head into the IR receiver hole mount.

Push the IR receiver hole mount and IR receiver head back into the hole in the tabletop mount.

To secure the mount, remove the backing from the foam tape on the bottom of the unit and attach the mount to any flat surface.