Specialty Liquid Coffee Dispenser Features Specialty Liquid Coffee Dispenser

Specialty Liquid Coffee Dispenser Features Specialty Liquid Coffee Dispenser
ECID# 27986
Specialty Liquid
Coffee Dispenser
Project
Date
Features
Specialty Liquid Coffee Dispenser
• Dispenses two coffees from liquid concentrate plus milk and chocolate powders
(20:1 to 50:1 products)
• Accommodates two .5 gallon (.1.9 litre) liquid coffee bibs and
two 8-pound (3.63kg) hoppers
• Bib size: 5” w x 9.25” H x 4.875” D (12.7cm W x 23.5cm H x 12.4cm D)
• Set up for portion-control to fill cups with a 7.25” (18.4cm) cup clearance
• Serves seven set drinks, all in a 19.7” (50cm) footprint
• Four gallon (15.14 litre) hot water tank
• Front of machine access for easy machine set up, calibration and service
• Spring loaded auger drive system for easy hopper installation
• Key lock on door prevents tampering
SLCA-7
Dimensions: 32.8” H x 19.7” W x 23.4” D
(83.3cm H x 50cm W x 59.4cm D)
Related Products
EQHP-10L
Product No. : 39000.0001
3/16” Replacement Tube Kit
Product No.: 39329.1000
Adapter Tube Package
Product No.: 37500.0201
Graduated Cylinder Kit
Product No.: 34843.1001
Model
8” Adjustable Legs
Product No.: 00506.0000
Agency Listing
SLCA-7
4/13
D5.5
Dimensions & Specifications
Model
Product
Number
Dispense Rate
1.7 oz. (.05L)
Product Ratios†
Volts
Amps
SLCA-7
38900.0305
20:1 - 50:1
120
15
Heater Total
Watts Watts
1700
1800
Capacity*
Cubic
Measure
43 cups/hr.
10.9 ft3
140 lbs.
.31 M3
63.5 kg
Shipping Cord
Weight Attached
Yes
†
Other ratios may be available based on tube options. Please contact your BUNN Sales Representative.
*Capacity measured with a 12 oz. (.35L) cup.
Electrical: 120V requires 2-wires plus ground service rated 120V, single phase, 60 Hz.
Plumbing: 20-100 psi (138-689 kPa) from a 1/4" or larger supply line. Unit requires a 1 gpm (3.79 lpm) line flow capacity. A shut-off
valve should be installed in the line before the unit. Install a regulator in line when pressure is greater than 100 psi
(689 kPa) to reduce pressure to 50 psi (344 kPa). Supplied with 1/4" male flare fitting.
Bunn-O-Matic® Corporation - 1400 Stevenson Drive Springfield, Illinois 62703 • 800-637-8606 • 217-529-6601 • Fax 217-529-6644 • www.bunn.com
BUNN® practices continuous product research and improvement. We reserve the right to change specifications and product design without notice. Such
revisions do not entitle the buyer to corresponding changes, improvements, additions or replacements for previously purchased equipment.
All dimensions shown in inches.
4/13 © Bunn-O-Matic Corporation
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement