Crosley Radio CR52 Stereo System User Manual

WARNING:
TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE THIS APPLIANCE TO RAIN
OR MOISTURE. DO NOT REMOVE COVER. PILOT LAMPS SOLDERED IN PLACE. NO
USER SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE
PERSONNEL.
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
AM/FM RADIO WITH
CASSETTE PLAYER
CAUTION:
TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE
COVER (OR BACK). NO USER - SERVICEABLE PARTS INSIDE. REFER
SERVICING TO QUALIFIED SERVICE PERSONNEL.
The lighting flash with arrowhead symbol, within an equilateral
triangle, is intended to alert user to the presence of uninsulated
"dangerous voltage" within the product's enclosure that may be
of sufficient magnitude to constitute risk of electric shock to
persons.
The exclamation point within an equilateral triangle is intended
to alert user to the presence of important operating and
maintenance (servicing) instruction in the literature accompanying
the appliance.
SPECIFICATION
FREQUENCY RANGE
POWER CONSUMPTION
POWER SOURCE
ANTENNAS
SPEAKER
:
:
:
:
:
:
:
FM 88 - 108.5 MHz
AM 525 - 1710 KHz
15W
AC 120V-60Hz
External antenna for FM
Built-in ferrite bar for AM
3”DYNAMIC TYPE
•DESIGN AND SPECIFICATION SUBJECT TO CHANGE WITHOUT NOTICE.
Model: CR52
910-989900-004
IMPORTANT SAFETY INSTRUCTION
PLEASE READ CAREFULLY ALL THE FOLLOWING IMPORTANT SAFEGUARDS
THAT ARE APPLICABLE TO YOUR EQUIPMENT
1. Read Instructions - All the safety and operating instructions should be read before
the product is operated.
2. Retain instructions - The safety and operating instructions should be retained for
future reference.
3. Heed Warnings - All warnings on the product and in the operating Instructions
shouldbe adhered to.
4. Follow Instructions - All operating and use instructions should be followed.
5. Cleaning - Unplug this product from the wall outlet before cleaning. Do not use liquid
cleaners or aerosol cleaners. Use a damp cloth for cleaning.
6. Attachments - Do not use attachments not recommended by the product manufacturer
as they may cause hazards.
7. Water and Moisture - Do not use this product near water - for example, near a bath
tub, wash bowl, kitchen sink, or laundry tub; in a wet basement; or near a swimming
pool; and the like.
8. A product and cart combination should be moved with care. Quick stops, excessive
force, and uneven surfaces may cause the product and cart combination to overturn.
9. Ventilation - Slots and openings in the cabinet are providedfor
ventilation and to ensure reliable operation of the productand
to protect it from overheating, and these openings must not be
blocked or covered, The openings should never be blocked by
placing the product on a bed, sofa, rug, or other similar surface.
This product should not be placed in a built - in installation such
as a bookcase orrack unless proper ventilation is provided or
the manufacturer's instructions have been adhered to.
10. Power Sources - This product should be operated only from the type of power
sourceindicated on the marking label, if you are not sure of the type of power supply
to your home. Consult your product dealer or local power company. For products
intended tooperate from battery power, or other sources, refer to the operating
instructions.
11. Grounding or Polarization - This product may be equipped with a polarized alternatingcurrent line plug (a plug having one blade wider than the other). This plug will fit into
the power outlet only one way. This is a safety feature. If you are unable to insert
the plug fully into the outlet try reversing the plug, If the plug
should still fail to fit, contactyour electrician to replace
your obsolete outlet. Do not defeat the safety purpose
AC
Polarized Plug
of the polarized plug.
12. Power - Cord Protection - Power - supply cords should be routed so that they are
not likely to be walked on or pinched by items placed upon or against them, paying
particular attention to cords at plugs, convenience receptacles, and the point where
they exit from the product.
13. Lightning - For added protection for this product during a lightning storm, or when
it is left unattended and unused for long periods of time, unplug it from the wall
outlet and disconnect the antenna or cable system. This will prevent damage to
the product dueto lightning and power - line surges.
14. Power Lines - An outside antenna system should not be located in the vicinity of
overhead power lines or other electric light or power circuits, or where it can fall
into such power lines or circuits. When installing an outside antenna system, extreme
care should be taken to keep from touching such power lines or circuits as contact
with them might be fatal.
15. Overloading - Do not overload wall outlets, extension cords, or integral convenience
receptacles as this can result in a risk of fire or electric shock.
16. Object and Liquid Entry - Never push objects of any kind into this product through
openings as they may touch dangerous voltage points or short - out parts that
could result in a fire or electric shock. Never spill liquid of any kind on the product.
17. Servicing - Do not attempt to service this product yourself as opening or removing
covers may expose you to dangerous voltage or other hazards. Refer all servicing
to qualified service personnel.
18. Damage Requiring Service - Unplug this product from the wall outlet and refer
servicing to qualified service personnel under the following conditions;
a. When the power-supply cord or plug is damaged.
b. If liquid has been spilled, or objects have fallen into the product.
c. If the product has been exposed to rain or water.
d. If the product does not operate normally by following the operating instructions.
Adjust only those controls that are covered by the operating instructions as
an improper adjustment of other controls may result in damage and will often
require extensive work by a qualified technician to restore the product to its
normal operation.
e. If the product has been dropped or damaged in any way.
f. When the product exhibits a distinct change in performance - this indicates
a need for service.
19. Replacement Parts - When replacement parts are required, be sure the service
technician has used replacement parts specified by the manufacturer or have
the same characteristics as the original part. Unauthorized substitutions may
result in fire, electric shock, or other hazards.
20. Safety Check - Upon completion of any service or repairs to this product, ask
the service technician to perform safety checks to determine that the product
is in proper operating condition.
21. Wall or ceiling Mounting - The product should be mounted to a wall or ceiling
only as recommended by the manufacturer.
22. Heat - The product should be situated away from heat sources such as radiators.
Heat registers, stoves, or other products(including amplifiers) that produce heat.
WARNING:Changes or modifications to this unit not expressly approved by the party
responsible for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not occur
in a particular installation. If this equipment does cause harmful intereference to radio
or television reception, which can be determined by turning the equipment off and on
, the user is encouraged to try to correct the interference by one or more of the following
measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an circuit different from that to which the receiver
is connected.
- Consult the dealer or an experienced radio TV technician for help.
Power Source
TROUBLE SHOOTING GUIDE
Radio Operation
* The AC power cord is not connected to a power outlet.
* The unit is not turned on : rotate the VOLUME knob from the OFF position
past the “click’’ to turn on the unit.
Unwind the AC power cord at the back of the unit and connect it to a power
outlet.
The unit is not functioning
1. Select the desired band by switching the BAND selector (10).
2. Adjust the volume level by turning the VOLUME (3) Control.
3. Select the desired station by turning the TUNING KNOB (2). Make sure the selected
band do match up with the station selected.
The unit is provided with a wire antenna for Fm reception. Move the wire until the
reception is clear. Do not connect the Fm antenna to any external antenna. Am reception
would be improved by relocating the unit.
Cassette Operation
1. Turn the unit on, insert a tape through the CASS DOOR (5). The tape will slide into
the cassette mechanism and start playing. The radio function will be off automatically
once the tape is in the slot.
2. Adjust the volume level by turning the VOLUME (3) Control.
3. For fast forwarding, press the EJECT / F.F. (4) half way in. By press the(4) again, will
stop the fast forwarding and return the cassette to the playing mode.
4. To stop and eject the cassette, press the EJECT / F.F. (4) in completely. The radio
operation will resume.
5. When one side of the tape finish playing, the cassette will stop and the radio will
resume.
NOTE: Remove the tape from the unit when is not in use or when listening to the radio.
Time set
Turn the Time Setting knob (8), located at the back of the unit, anticlockwise to set the
time.
NOTE: The clock will not function when the AC power is not connected.
POLARIZED ELECTRICAL PLUG
INSTRUCTIONS
This product is equipped with a polarized alternating current line plug (a plug having
one blade wider than the other). This plug will fit into the power outlet only one way.
This is a safety feature, If you are unable to insert the plug fully into the outlet, try
reversing the plug. If the plug should still fail to fit, contact you electrician to replace
your obsolete outlet. Do not defeat the purpose of the polarized plug.
10
4
9
5
3
7
2
Features
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
Speaker
Tuning Knob
Volume Control
Eject / F.F Button
Cassette Door
Power Connection Plug
Fm Antenna
Time Setting Knob
Clock display
Am / Fm Band Switch
* The function switch is not in the correct position. Turn function switchinsert to
RADIO.
* Adjust the VOLUME knob.
* Rotate the TUNING knob to find a radio station.
Cassette tape cannot be inserted
External Antenna
8
No radio
1
6
* The cassette tape is inserted in the wrong position.
No cassette playback
* The cassette tape is not pushed all the way in.
* Adjust the volume knob.
* The cassette has reached the end of the side being played. Open cassette tape
door, take out tape, flip over the cassette and reinsert.
www.crosleyradio.com