INSTALLATION

INSTALLATION
Take out the Chip Dump from t he packaging and locate the unit on a firm
level surface. Remove coating from the unit.
When this appliance is to be positioned in close proximity to a wall,
partitions, kitchen furniture, decorative finished, etc., it is recommended that
they be made of non-c ombustible material, if not, they shall be clad with a
suitable non-combustible heat-insulating material, and that the closet
attention be paid to fire prevention regulations.
ELECTRIC COUNTER TOP CHIP DUMP
Once the Chip Dump has been placed in position by consulting International
Standards and regulations. The Unit is ready to operate.
OPERATION
Plug in the Power, switch on the switch, The element starts heating and the
green light is on. When not using, just simply switch off the switch and pull
off the power.
SAFETY
If the power cord is damaged, it must be replaced by qualified technician.
DO NOT TOUCH THE UP HEATER WHEN THE UNIT IS
WORKING, BECAUSE IT IS TOO HOT!
MAINTENANCE
Clean using warm soapy water after each use.
Do not immerse completely in water to clean.
The appliance is not to be cleaned with a water jet.
HELP
If the Chip Dump does not work, please check the following:
1.The power supply is correct and switched on.
2.The positions of switches are correct.
3.The elements are clear.
USER’S GUIDE
BASIC SPECIFICATION
Model
Voltage
Power
PA10620
110V/60Hz
8 50W
ELECTRICAL DIAGRAM
Dimension
335(W) X 565(D) X 505(H)
EXPLOSION GRAPH
L
N
220- 240V
i ndi cat or l i ght
LI GHT
swi t ch
i ndi cat or l i ght
el ement
saf et y gr i l l
ELEMENT
pl ug & l ead
ELEMENT
body
POWER SWI TCH
pan
pl at e
f oot
I NDI CATOR LI GHT
E

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project