DeLonghi HS15F Fan User Manual

ELECTRIC CONVECTOR HEATER
INSTRUCTIONS FOR USE
SAVE THESE INSTRUCTIONS
CONVECTEUR ÉLECTRIQUE
MODE D’EMPLOI
CONSERVEZ CE MODE D’EMPLOI
TERMOCONVECTOR ELECTRICO
INSTRUCCIONES PARA EL USO
REPASE Y GUARDE ESTAS INSTRUCCIONES
LEA CUIDADOSAMENTE ESTE INSTRUCTIVO
ANTES DE USAR SU APARATO
TERMOCONVETTORE
ISTRUZIONI PER L’USO
CONSERVARE QUESTE ISTRUZIONI
MODEL/MODELE/MODELO/MODELLO
HS15F
Register this product on-line and receive a free trial issue of Cook's Illustrated.
Visit www.delonghiregistration.com.
Visit www.delonghi.com for a list of service centers near you. (U.S. Only)
Enregistrez ce produit en ligne et recevez un numéro gratuit de Cook's
Illustrated. Visitez www.delonghiregistration.com.
Visitez www.delonghi.com pour y voir une liste des centres de réparation proches de chez vous. (É.-U. uniquement)
Registre este producto en línea y reciba un ejemplar gratis de Cook's Illustrated.
Visite www.delonghiregistration.com.
Visite www.delonghi.com para ver la lista de centros de servicios cercanos a
usted. (Solamente en los Estados Unidos)
Registra questo prodotto "on-line" per ricevere una copia omaggio della rivista
Cook's Illustrated. Visita www.delonghiregistration.com.
Visita www.delonghi.com per una lista dei centri di servizio a te piu vicini. (Solo negli Stati Uniti).
ELECTRONIC CHARACTERISTICS/CARACTÉRISTIQUES ÉLECTRONIQUES
CARACTERISTICAS ELECTRICAS/CARATTERISTICHE ELETTRICHE
120V˜60Hz 1500W
A
B
C
C
D
D
DESCRIPTION
A. Thermostat
B. Switches
C. Front Foot
D. Screw
DESCRIPTION DE L’APPAREIL
A. Thermostat
B. Interrupteurs
C. Pied
D. Vis
DESCRIPCIÓN DEL APARATO
A.
B.
C.
D.
Termostato
Teclas
Pie
Tornillo
DESCRIZIONE
A. Termostato
B. Interruttori
C. Piedino
D. Vite
IMPORTANT SAFEGUARDS
When using electrical appliances, basic precautions should always be followed to reduce risk
of fire, electric shock, and injury to persons, including the following:
1. Read all instructions before using this heater.
2. This heater is hot when in use. To avoid burns, do not let bare skin touch hot surfaces. Use
handle when moving this heater. Keep combustible materials, such as furniture, pillows,
bedding, papers, clothes, and curtains at least 3 feet (0,9 m) from the front and top of the heater
and keep them away from the sides and rear.
3. Extreme caution is necessary when any heater is used by or near children or invalids and
whenever the heater is left operating and unattended.
4. Always unplug heater when not in use.
5. Do not operate any heater with a damaged cord or plug or after the heater malfunctions,
has been dropped or damaged in any manner. Return heater to authorized service
facility for examination, electrical or mechanical adjustment, or repair.
6. Do not use outdoors.
7. This heater is not intended for use in bathrooms, laundry areas and similar indoor locations.
Never locate heater where it may fall into a bathtub or other water container.
8. Do not run cord under carpeting. Do not cover cord with throw rugs, runners, or the like.
Arrange cord away from traffic area and where it will not be tripped over.
9. To disconnect heater, turn controls to off, then remove plug from outlet.
10. Connect to properly polarized outlets only.
11. Do not insert or allow foreign objects to enter any ventilation or exhaust opening as this may
cause an electric shock, fire, or damage the heater.
12. To prevent a possible fire, do not block air intakes or exhaust in any manner. Do not use on
soft surfaces, like a bed, where openings may become blocked.
13. A heater has hot or arcing or sparking parts inside. Do not use it in areas where
gasoline, paint, or flammable liquids are used or stored.
14. Use this heater only as described in this manual. Any other use not recommended by the
manufacturer may cause fire, electric shock, or injury to persons.
15. To prevent overload and blown fuses, be sure that no other appliance is plugged into the same
outlet (receptacle) or into another outlet (receptacle) wired into the same circuit.
16. It is normal for the heater’s plug and cord to feel warm to the touch. A plug or cord which
becomes hot to the touch or becomes distorted in shape may be a result of a worn electrical
outlet (receptacle). Worn outlets or receptacles should be replaced prior to further use of the
3
heater. Plugging heater into a worn outlet /receptacle/ may result in overheating of the power
cord or fire.
17. Do not use an extension cord because the extension cord may overheat and cause a risk
of fire. However, if you have to use an extension cord, the cord shall be Ul listed No. 1 4 AWG
minimum size and rated not less than 1 875 watts, ISAMP at 125 V and has to be used only
for supplying power to this heater.
18. Be sure that the plug is fully inserted into an appropriate receptacle. Please remember that
receptacles also deteriorate due to aging and continuous use: check periodically if signs
overheating or deformations are evidenced by the plug. Do not use the receptacle and CALL
your electrician.
19. Check that neither the appliance nor the power cable have been damaged in any way
during transportation.
20. Before connecting to electric power outlet, check your electrical power supply. It must be
120 volts A.C. (alternating current). The outlet may be 15 amp. or 20 amp. The circuit must
be of adequate size and must be protected by fuse or circuit breacker. DO NOT place heater
directly beneath electrical receptacle and DO NOT place heater against paper board or low
density fiberboard.
DO NOT touch hot surfaces.
DO NOT immerse cord, plug or heater in water or othet liquid, or pour this will cause
dangerous electrical conditions and potential electrical shock.
DO NOT obstruct the top or bottom air openings.
Dust and lint on the heating element can obstruct the free flow of air. DO NOT operate when
so obstructed.
Operating with air openings obstructed could cause a dangerous condition.
22. Make sure that no pieces of polystyrene or other packaging material have been left into the
appliance. It may be necessary to pass over the appliance with a wacuum cleaner.
23. When switching on the appliance for the first time, allow it to run at full power for about 1
hours to get rid of the unpleasant smell. Make sure that the room in which the appliance is
located is well ventilated during this operation.
24. It is not advisable for the appliance to be positioned where it is exposed to draughts which
might prevent it from working properly.
SAVE THESE INSTRUCTIONS
4
HOW TO USE YOUR HEATER
Required Tools (not included): 1 Screwdriver PH 2 x 100 (Phillips type)
Estimated assembly time: 5 minutes
FEET ASSEMBLING
Remove the feet from the packing.
Fit the feet to the appliance as follows:
1 Insert the anchor pins (A) into the slots and turn the foot until it clicks into position (fig. 1).
2 Fasten the feet in position using the screw (fig. 2).
A
fig. 1
fig. 2
BE CAREFUL
Operate the heater in upright position only.
Any other position could create hazard situation!
The appliance is fitted with a tilt-swich which turns the appliance off if it should fall over. To
restart the appliance, simply place it upright again.
LOCATION
Place heater on floor beneath coldest window in the room or any desired location. Your heater
will minimize the effect of cold drafts.
The heater must not be located immediately below a socket-outlet.
SWITCHING HEATER ON
The heater must be connected to a properly polarized A/C 120 V household outlet in perfect
working conditions.
Keep loose clothing or bedding, furniture and flammable material away from the wall outlet
where the heater plug is fitted in.
Turn the thermostat knob clockwise to the highest setting and push one
or both switches on. Pilot lights will go on, indicating that unit is operating.
REMINDER
To completely shut unit off, both switches must be placed in "0" position
(lights off).
THERMOSTAT OPERATING
The thermostat operates on room air temperature and not heater temperature. Counter clockwise direction - lower number, lower temperature.
Clockwise direction - higher number, higher temperature.
Switch your heater on as shown in the previous paragraph. When your
room reaches a comfortable temperature, turn thermostat knob back
gradually until you hear a "click" and not further.
Keep thermostat at this temperature, the heater switches on automatically
until the room again reaches the set temperature. Room comfort is thus
maintained with minimum use of electricity.
0
5
MODEL WITH FAN
Proceed as follows:
- as warm ventilation during cold months, by pushing on the fan switch (see figure), along
with one or both switches. Your fan will propel the heat
instantly.
- as cold ventilation simply turning clockwise the thermostat
knob to its maximum position and without pushing on the
switches, but the fan switch. Your fan will refresh room-air
circulation.
MAINTENANCE AND SERVICE
Disconnect electric and allow the heater to cool. Wipe with a soft
damp cloth, do not use detergents and abrasives.
Should the heater not be in use over a certain lenght of time, keep
it in a dry place. This appliance has been built to give many years
of trouble free service.
In case of malfunction or doubt, do not try to repair the heater
yourself. Call nearest Service Centre (see attached list of Service
Centers).
6
limited warranty
This warranty applies to all products with De’Longhi or Kenwood brand names.
What does the warranty cover?
We warrant each appliance to be free from defects in material and workmanship. Our obligation
under this warranty is limited to repair at our factory or authorized service center of any defective
parts or part thereof, other than parts damaged in transit. In the event of a products replacement
or return, the unit must be returned transportation prepaid. The repaired or new model will be
returned at the company expense.
This warranty shall apply only if the appliance is used in accordance with the factory directions,
which accompany it, and on an Alternating current ( AC ) circuit.
How long does the coverage last?
This warranty runs for one year (1) from the purchase date found on your receipt and applies only
to the original purchaser for use.
What is not covered by the warranty?
The warranty does not cover defects or damage of the appliance, which result from repairs or
alterations to the appliance outside our factory or authorized service centers, nor shall it apply to
any appliance, which has been subject to abuse, misuse, negligence or accidents. Also,
consequential and incidental damage resulting from the use of this product or arising out of any
breach of contract or breach of this warranty are not recoverable under this warranty. Some states
do not allow the exclusion or limitation of incidental or consequential damage, so the above
limitation may not apply to you.
How do you get service?
If repairs become necessary, see contact information below:
U.S. Residents:
Please contact our toll free hotline at 1-800-322-3848 or log onto our website at www.delonghi.com.
For all accessories, spare parts or replacement parts, please contact our parts division at 1-800865-6330.
Residents of Canada: Please contact our toll free hotline at 1-888-335-6644 or log onto our
website at www.delonghi.com.
Residents of Mexico: Please refer to the Limited Warranty statement for Mexico.
Please refer to the back page of the manual for De’Longhi addresses.
The above warranty is in lieu of all other express warranties and representations. All implied
warranties are limited to the applicable warranty period set forth above. This limitation does not
apply if you enter into an extended warranty with De’Longhi. Some states do not allow limitations
on how long an implied warranty lasts, so the above exclusions may not apply to you. De’Longhi
does not authorize any other person or company to assume for it any liability in connection with the
sale or use of its appliance.
How does state law apply?
This warranty gives you specific legal rights, and you may also have other rights, which vary from
state to state.
7
Download PDF

advertising