17/11/2011

Ins-30074 Net2 USB/RS485 plug-in converter

Paxton

Technical Support

01273 811011

[email protected]

Technical help is available: Monday - Friday from 07:00 - 19:00 (GMT)

Saturday from 09:00 - 13:00 (GMT)

Documentation on all Paxton products can be found on our website - http://www.paxton.co.uk/

RS485 Network connection

This module is designed to assist in the fault finding and testing of individual ACU's by removing the need for a wired data line connection. Analysis can be easily done by taking a laptop PC to the ACU and connecting directly into its communications port.

No additional 'end of line' resistors are required.

Pull off the screw terminal block from the network port on the ACU and replace it with this module. Connect the module to the USB port on the PC and run the Net2 software.

No further configuration is required. The Net2 software will look for the USB device. This

Net2 device will NOT show as a serial port in the PC software.

Software - Requires Net2 v4.13 or later

This device requires the PC to have a Paxton USB driver loaded. Please contact Technical

Support if software or further assistance is required.

Net2 classic control unit

Screen or spare cores from network cable

White/Green 1

Green 2

White/O r ang e 3

O r ang e 4

Net2 classic http://paxton.info/107

PLACE SERIAL

123456

0889

+12V

0V

N.C.

12V

Red LED

Com

N.C.

Amber LED Remove Net2 data cable plug

Data/D0 and replace with this module.

Media Detect

Com

0V

Alarm Output

12V

0V

Red LED

Contact

Amber LED

0V

Green LED

Exit

Data/D0

0V

Clock/D1

T amper

Media Detect

0V

PSU

Net2 plus control unit

Expansion

Net2 plus

PLACE SERIAL

NUMBER

LABEL HERE

RS485 Network

CA T5 Cable Coding

Tx Rx

0V

IMPORTANT: Ensure that the module is only connected to the RS485 data port.

The PCB may be damaged if connected to another port in error.