User`s guide | DVDO VS4 Switch User Manual

DVDO VS4 HDMI Switch
User’s Guide
How to install, set up, and use your new DVDO product
TABLE OF CONTENTS
Table of Contents ............................... 1
Introduction....................................... 1
Installation and Set-Up ....................... 2
Remote Control Operation.................. 3
Automatic Source Selection ................. 3
Technical Specifications ...................... 4
Safety Information .............................. 5
Warranty ........................................... 6
INTRODUCTION
Welcome to the DVDO Family!
Thanks for buying the DVDO VS4 Four-Input HDMI Switch/Repeater.
It is our pleasure to bring you the VS4, which we are sure will deliver
years of reliable and enjoyable performance.
We look forward to helping you in any way that we can.
Should you need assistance, you can contact us via email,
or by calling our toll-free support line.
Email Help@DVDO.com
Toll-free in the USA 1-866-423-2826
From outside the USA 1-408-379-3836
Thanks again for your purchase of the VS4,
and welcome again to the DVDO Family!
The DVDO Team
September 2006
Campbell, California
1
INSTALLATION AND SETUP
The VS4 package contains the VS4 switch unit, a power supply and two infrared
remote control units.
Remove and unwrap the components from the package. The infrared remote controls each contain a clear plastic battery protection tab. This tab must be removed
from the remote control units before use.
Connect the power supply to the VS4 unit as shown in the picture below.
Plug the power supply into a power outlet.
Connect HDMI cables (not included) from the HDMI or DVI source(s) to the VS4
inputs.
Connect an HDMI cable from the VS4 output to an HDMI or DVI display or to another HDMI receiving device, such as an AV receiver.
2
REMOTE CONTROL OPERATION
The VS4 comes with two remote controls. The “Simple” remote can be used to
turn the VS4 unit on or off as well as select between the input sources.
The “Professional” remote control enables discrete command functions
of the product.
Simple IR
remote control
unit
Professional IR
remote control
unit with discrete
commands
The discrete IR commands available on the Professional remote control unit are:
- Power On/Off toggle
- Input 1, 2, 3, or 4 direct select
- Input Select Up
- Input Select Down
- Auto Input Select
- Discrete Power On
- Discrete Power Off
- Front Panel Display On
- Front Panel Display Off
AUTOMATIC SOURCE SELECTION
The VS4 HDMI switch can automatically detect when an input device is poweredon or powered-off. Using this information, the VS4 will automatically select the first
input device which is powered-on. To make use of this feature, keep at most one
input device powered-on at any given time. This will allow the VS4 to automatically select the appropriate input device.
3
TECHNICAL SPECIFICATIONS
Inputs
► 4 HDMI inputs accept HDMI, HDMI/HDCP, DVI and DVI/HDCP at TV
resolutions including 480i, 480p, 720p, 1080i, 1080p and computer
resolutions from VGA to UXGA (165MHz)
► RS-232 control port
Output
► 1 HDMI output: Passes the signal from the selected input
Controls
► “Consumer” infrared remote control or manual controls on front panel
► “Professional” infrared remote control with direct access codes and
discrete codes for various functions
► Automatic input source detection and non-volatile memory retention of
last input source selected
► RS-232 automation/control interface
Power
► Universal AC mains input:
• 100 - 240 VAC @ 50 - 60 Hz
• Consumption < 5W
Physical
► Dimensions 8.4” x 5.5” x 1.6” ( 21.6 cm x 14 cm x 4.1 cm )
Weight
► Shipping - 3 lbs ( 1.4 kg )
Unit - 1.5 lb ( 0.7 kg )
4
SAFETY INFORMATION
Safeguards
►
►
►
►
►
To reduce the risk of electric shock,
do not expose this product to rain or
moisture.
Avoid excessive humidity, sudden temperature changes or temperature extremes.
►
If the wall plug does not fit into your
local power socket, hire an electrician
to replace your obsolete outlet.
Keep this product away from wet locations such as bathtubs, sinks, laundries,
wet basements and swimming pools.
►
Do not modify the wall plug. Doing so
will void the warranty and safety features.
Use only accessories recommended by
DVDO to avoid fire, shock or other hazards.
►
Unplug this product before cleaning.
Use a damp cloth for cleaning. Do not
use cleaning fluids or aerosols, which
could enter the unit and cause damage,
fire or electrical shock. These substances may also mar the finish of the
product.
►
Never open or remove unit panels or
make any adjustments not described in
this manual. Attempting to do so could
expose you to dangerous electrical
shock or other hazards. It may also
cause damage to your VS4.
►
Do not attempt to service this unit. Instead, disconnect it and contact your
Authorized DVDO Reseller or contact
DVDO directly.
This equipment should be installed
near the socket outlet and the device
should be easily accessible in case it
requires disconnection.
Precautions
►
FCC Regulations state that any unauthorized changes or modifications to
this equipment not expressly approved
by the manufacturer could void the
user’s authority to operate this equipment.
►
Operate this product using only the
included external power supply. Use
of other power supplies could impair
performance, damage the product, or
cause fires.
►
►
5
In the event of an electrostatic discharge, this device may automatically
turn off. If this occurs, press the power
button to turn the device back on.
Protect and route power cords so they
will not be stepped on or pinched by
anything placed on or against them.
Be especially careful at plug-ins, or
cord exit points from this product.
Compliance Certification
This product complies to the following domestic and international regulations and
standards:
Electromagnetic Compatibility EMC Directive
FCC - Part 15, EN 55022, EN 55024
Safety UL 60950-1, CSA 60950-1, EN
60950-1, IEC 60950-1, CB Scheme
WARRANTY
LIMITED ONE-YEAR WARRANTY
DVDO by Anchor Bay Technologies warrants only to the initial
purchaser of this product for a period of one year from purchase from an Authorized DVDO Reseller, that the product will
be free of electrical and mechanical defects that materially affect the product’s operation as described in this User’s Manual. DVDO’s sole obligation shall be, at its sole option, to repair or replace the product with equivalent or better, or to refund the net original purchase price.
DISCLAIMER OF WARRANTY
ALL IMPLIED WARRANTIES OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE ARE LIMITED TO ONE
YEAR FROM PURCHASE; ALL OTHER EXPRESS OR IMPLIED
CONDITIONS, REPRESENTATIONS AND WARRANTIES, INCLUDING ANY IMPLIED WARRANTY OF NONINFRINGEMENT, ARE DISCLAIMED. Some jurisdictions do not
allow limitations on how long an implied warranty lasts, so the
above limitation may not apply to you. This warranty gives you
specific legal rights, and you may also have other rights, which
vary by jurisdiction.
LIMITATION OF LIABILITY
TO THE EXTENT NOT PROHIBITED BY LAW, IN NO EVENT
WILL DVDO OR ITS SUPPLIERS BE LIABLE FOR ANY LOST
REVENUE, PROFIT OR DATA, OR FOR SPECIAL, INDIRECT,
CONSEQUENTIAL, INCIDENTAL, OR PUNITIVE DAMAGES,
HOWEVER CAUSED REGARDLESS OF THE THEORY OF LIABILITY, ARISING OUT OF OR RELATED TO THE USE OF OR
INABILITY TO USE THE PRODUCT, EVEN IF DVDO, INC.
HAS BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. IN NO EVENT WILL DVDO’S LIABILITY TO YOU,
WHETHER IN CONTRACT, TORT (INCLUDING NEGLIGENCE), OR OTHERWISE, EXCEED THE AMOUNT PAID BY
YOU FOR THE PRODUCT. The foregoing limitations will apply even if any warranty or remedy provided to you fails its essential purpose. Some jurisdictions do not allow the exclusion
or limitation of incidental or consequential damages, so the
above limitation or exclusion may not apply to you.
Disclaimer
This document is provided for
technical information for the
user. It does not create any
warranty with respect to the
product, and does not modify
or enhance the terms of the
warranty that may accompany
this product. DVDO reserves
the right to modify the information in this document as necessary. DVDO holds no responsibility for any errors that may
appear in this document. Customers should take appropriate
action to ensure their use of the
product does not infringe upon
any patents. DVDO respects
valid patent rights of third parties.
Trademarks
‘HDMI’ and the HDMI logo are
trademarks of HDMI Licensing
LLC. All other product names or
marks referenced herein are
trademarks or registered trademarks of their respective owners.
DVDO by Anchor Bay Techologies Inc.
300 Orchard City Drive, M/S 131
Campbell, California 95008
Toll Free 1-866-423-3836
Web www.DVDO.com
Email Help@DVDO.com
6
DVDO by Anchor Bay Techologies Inc.
300 Orchard City Drive, M/S 131
Campbell, California 95008
Toll Free 1-866-423-3836
Web www.DVDO.com
Email Help@DVDO.com
7
Download PDF

advertising