AudioWind Electronics-Salon Model: PCB-SP1(A-230)

AudioWind Electronics-Salon  Model: PCB-SP1(A-230)
AudioWind
Electronics-Salon
Positive Voltage Regulator PCB
Model: PCB-SP1(A-230)
PCB Size and Wring Diagram:
DC INPUT:
Positive DC voltage input.
GND (0V):
DC input ground (0V).
AC1 INPUT:
AC input 1.
AC2 INPUT:
AC input 2.
GND (0V):
DC output ground (0V).
DC OUTPUT:
Regulated positive DC voltage output.
Schematic for LM317:
Note: We recommend that you use normal brightness LED, R2 use 1.5K OHM 1/2W is
suitable.
Schematic for 78xx IC:
Note:
J1 is a copper jumper wire or 0 OHM resistor.
We recommend that you use normal brightness LED.
For 7805, R2 use 470 OHM 1/2W.
For 7806, R2 use 470 OHM 1/2W.
For 7808, R2 use 1K OHM 1/2W.
For 7809, R2 use 1K OHM 1/2W.
For 7810, R2 use 1K OHM 1/2W.
For 7812, R2 use 1.5K OHM 1/2W.
For 7815, R2 use 1.8K OHM 1/2W.
For 7818, R2 use 2.2K OHM 1/2W.
For 7824, R2 use 3K OHM 1/2W.
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement