Edelbrock 9300 Automobile Parts Installation instructions

Intake Manifold Gaskets & Cylinder Head Gasket Kits

®

INSTALLATION SUPPLEMENT

• We recommend the use of Edelbrock Gasgacinch (Part #9300) on the intake manifold mounting surface of the cylinder head, and on the cylinder head side of the Intake Manifold Gaskets, in order to hold the gasket in place on the cylinder head and to ensure a proper seal. Follow the instructions on the Gasgacinch can for the proper application procedure. DO

NOT USE Gasgacinch on cylinder head gaskets.

• Intake Manifold End seals are not included with Intake Manifold Gaskets. In applications that normally use intake manifold end seals, use a 1/4” bead of RTV silicone in place of end seals (unless otherwise noted in the installation instructions for the individual intake manifold being used). Make sure the bead overlaps the corners of the intake gaskets.

• Using a thin film of RTV silicone around any water jacket openings in the gasket (on the intake manifold side only) will help ensure a proper seal around the water jacket openings.

Edelbrock Corporation

2700 California Street • Torrance, CA 90503

Tech Line: 1-800-416-8628

Tech E-Mail: [email protected]

©2004 Edelbrock Corp.

Rev. 8/04

Cyl. Head Gasket Kits & Intake Gaskets

Brochure No. 63-0287

Intake Manifold Gaskets & Cylinder Head Gasket Kits

®

INSTALLATION SUPPLEMENT

• We recommend the use of Edelbrock Gasgacinch (Part #9300) on the intake manifold mounting surface of the cylinder head, and on the cylinder head side of the Intake Manifold Gaskets, in order to hold the gasket in place on the cylinder head and to ensure a proper seal. Follow the instructions on the Gasgacinch can for the proper application procedure. DO

NOT USE Gasgacinch on cylinder head gaskets.

• Intake Manifold End seals are not included with Intake Manifold Gaskets. In applications that normally use intake manifold end seals, use a 1/4” bead of RTV silicone in place of end seals (unless otherwise noted in the installation instructions for the individual intake manifold being used). Make sure the bead overlaps the corners of the intake gaskets.

• Using a thin film of RTV silicone around any water jacket openings in the gasket (on the intake manifold side only) will help ensure a proper seal around the water jacket openings.

Edelbrock Corporation

2700 California Street • Torrance, CA 90503

Tech Line: 1-800-416-8628

Tech E-Mail: [email protected]

©2004 Edelbrock Corp.

Rev. 8/04

Cyl. Head Gasket Kits & Intake Gaskets

Brochure No. 63-0287