NEW MODEL Designer Collection Orizzonte The art of ventilation LUXURY STYLING stainless steel styling artistic design, impeccable fit & finish 3 halogen bulbs with a dimmmer hidden dishwasher-safe grease filters Easy Cube™ Mounting System 18” mounting height for sleek cabinet design ° ° ° ° ° ° HIGH PERFORMANCE TECHNOLOGY ° Comfort-Panel™ perimetric suction system ° 600 cfm internal PRO™ blower model ° pre-installed Silent Kit™ sound-proofing STATE OF THE ART CONTROLS push-button (LED) electronic controls on panel 4 pre-set speeds plus Intensive Power Boost 24-hour kitchen anti-pollution mode 30 minute delayed shut-down mode grease filter saturation indicator ° ° ° ° ° DUCTING OPTIONS ° top 6 “ round venting ° convertible to ductless Faber has redefined the rangehood with the new Orizzonte, a patented stainless steel angled ventilation panel that hangs on the wall behind the cooking surface. Size/Color/Model # 36 x 30 Stainless (NEW) a c c e s s o r i e s 630006242 High Ceiling Chimney Kit Ductless Conversion Kit One 40” upper chimney to replace 16 1/8” upper chimney that came with hood Includes: • Lower Chimney with holes for ducting • Ductless Diverter Assembly • Vent Grates • Charcoal Filter Stainless 620000362 Stainless 620000363 Replacement Charcoal Filter 620000041 p.o. box 435 • Wayland, MA 01778 • tel: (508) 358-5353 • fax: (508) 358-5730 • e-mail: [email protected] • www.faberonline.com Dimensional Diagrams Ducted MIN. 32" - MAX. 38 1/8" MIN. 26 3/8" - MAX. 37 3/8" Ductless Pre-Planning Your Installation - Important: Consult the installation instructions before you begin installing this rangehood. The suggested height to install the hood above the cooktop is 18” . The Orizzonte chimneys are adjustable and designed to meet varying ceiling heights. The chimneys can be adjusted for ceilings between 7' 10 3/16" - 8' 9 3/16" for ducted installations and between 8’ 3 3/16” - 8’ 9 15/16” for ductless installations. For shorter ceilings, have the chimney cover(s) cut at a sheet metal shop. For higher ceiling installations, the High Ceiling Chimney Kit includes a new 40” upper chimney which would replace the 16 1/8” upper chimney that came with the hood. Pre-Planning Your Installation - Important: Consult the installation instructions before you begin installing this rangehood. Make your ductrun as straight and short as possible. The ductrun should not exceed 35 equivalent feet if ducted with the required minimum of 6” round duct. Count 45º angles as 3 feet, 90º elbows as 5 feet, and 90º flat elbows as 12 feet. For best results, use no more than three 90° elbows. Make sure that there is a minimum of 24” of straight duct between elbows if more than one is used. Do not install two elbows together. If you must elbow right away, do it as far away from the hood’s exhaust opening as possible. WARNING! Ductless Installations* For installations where ductwork is impossible or highly impractical, a Ductless Conversion Kit is available. A charcoal filter, which attaches under the blower assembly, absorbs smoke and odors. A ductless diverter assembly directs the air out to a lower chimney with vent grates cut into the sides. * it is highly recommended that professional style cooking always be vented to the outside. Rev. 06/08 Product specifications are subject to change without notification. Consult the installation instructions before you begin installing this rangehood.
* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project