Fellowes 1000 Paper Shredder User Manual

®
Powershred
®
Factory Serviced
Paper Shredders
Operating Instructions
Powerhouse 1000
Powerhouse 2000
Important Safety Instructions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .3
Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .3
Parts Identification . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .3
Caution/Operation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .4
Specifications . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .5
Warranty . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .6
Contact For Service . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .8
2
Important Safety Instructions
Installation
1.Read all instructions before use.
Unpack your new shredder from its shipping
2.Save these instructions for later use.
container.
3.Follow all warnings and instructions marked on the
Place the shredder on a table top, desk or the
product.
optional shredder stand. Be sure the selected work
4.Unplug this product from the wall outlet before
surface is strong enough to support the weight of
cleaning. Clean with a damp cloth using a mild soap
and water solution. (Do not use abrasives or petroleum the shredder.
based cleaners.)
To attach the wire form feed guide, tilt the shredder
5.Place this product as close as possible to power source
back until the front feet lift off the table. Angle the
for quick and easy unplugging. Do not block the power
wire form feed guide so one “U” curve fits around
supply receptacle; it must be possible to conveniently
one of the metal tabs. Wrap the other side’s “U”
unplug the power cord.
curve around the other metal tab. Set the shredder
6.Do not use this product near water.
down so the front edge of the guide extends one7.This product should never be placed near or over a
half in front of the machine, with the rest of the
radiator or heat source.
8.Operate from the type of power source indicated on the guide between the shredder and the table.
marking label. If you are not sure of the type of power
Holding the bag support rod horizontally, pull the
available, consult your dealer or local electricity board.
bag up through the center of the rod and wrap the
9.Do not allow anything to rest on the power cord. Do
edges of the bag over the rod. To attach the rod to
not place this product where people may walk on the
the machine, squeeze the ends of the rod together
cord.
enough (approximately 1-1/2”) to fit between the
10. If an extension cord is used with this product, make
back feet on the shredder base. From the back of
sure that the total of the ampere ratings on the
products plugged into the extension cord do not exceed the machine, slide the rod under the shredder until
the extension cord ampere rating. Also, make sure that
it stops. Release the rod to allow it to snap into
the total of all products plugged into the wall outlet
place, with the ends resting against the shredder
does not exceed 15 amps.
feet. Make sure the bag does not block output from
11. Do not attempt to service this product yourself, as
the shredder.
opening or removing covers may expose you to
dangerous live parts or other risks, and will void the
When shredding continuous forms, feed paper
warranty.
between the guide and the shredder into the
12. Unplug this product and refer servicing to qualified
shredder throat.
personnel under the following conditions:
A) When the power cord or plug is damaged or
Parts Identification
frayed.
B) If liquid has been spilled on the product.
C) If the product has been exposed to rain.
D) If the product does not operate normally
when the operating instructions are followed.
Front
E) If the product has been dropped or
the casing has been damaged.
13. Keep out of the reach of children.
14. This shredder should be operated
Wire Form
only with an operator in attendance. Feed Guide
Bag Support Rod
Front Feet
Back Feet
Bag
3
Caution
Never insert hand, fingers or any
foreign objects into the feed
opening.
Serious injury may result.
Keep all loose articles of clothing,
ties, jewelry, long hair or other
loose objects away from feed
opening.
Injury may result.
Always turn off and unplug the
machine before moving, servicing,
cleaning or conducting any activity
other than normal operation.
Serious injury may result.
Operation
Read operating instructions before
putting shredder into
operation.
Insert plug into power outlet.
Prepare paper to be shredded, making sure not to
exceed the recommended sheet capacity. Paper
clips will not harm the cutting system, but the
added thickness may decrease sheet capacity (see
specifications for recommended sheet capacities).
Switching shredder ON/FORWARD.
Press rocker switch to position (I)
(the switch will lock into place.)
The cutting system is now running
in the forward mode. Insert the
paper into throat opening and the
cutting system will pull the paper
in.
4
Switching shredder OFF.
Lightly press rocker switch
towards (R) The switch will reset
to the OFF position (0) and the
cutting system will stop.
Switching shredder to REVERSE.
Press rocker switch to position (R)
and hold. The cutting system is
now running in the reverse
direction. Release the switch and
it will automatically reset to (0)
0FF.
If a Jam Occurs
The cutting system may jam if the recommended
capacity is exceeded (see specifications). When this
occurs, depress the switch to the REVERSE position
(R). This will back out the jammed material. The
operator should tear out and remove excess
jammed paper, if necessary, and then commence
shredding in smaller quantities so as not to further
jam the machine.
Technical Specifications
Model
Powerhouse 1000
Powerhouse 2000
Cutting Style
Strip
Strip
Shred Size
Inches
Millimeters
1/4
5.99
1/4
5.99
Sheet Capacity
8-1/2 x 11” 20 lb.
12
16
Speed 115V, 60Hz
22 FPM
22 FPM
Entry Width
Inches
Millimeters
15
(381)
15
(381)
Motor Power 120V
1/8 hp
2x1/8hp
Input voltage
(Depending on
country)
120V 50/60Hz
120V 50/60Hz
220-240v/50Hz
220-240v/50Hz
Dimensions
Inches
Millimeters
11-1/4 H x 22-3/16 W x 14-11/16 D
285 H x 564 W x 373 D
11-1/4 H x 22-3/16 W x 14-11/16 D
285 H x 564 W x 373 D
41
18.5
46
21
Reorder bag number
36051
36051
Stand
38915
38915
Weight
Pounds
Kilograms
5
Supplies
• Bags for cut material (Packed in dispenser carton, 50
bags to a roll. Contact Fellowes or your local Fellowes
dealer for the stock number of the bag that fits your
machine.)
Fellowes Factory Serviced
Powershred Limited
Warranty
Ninety (90) days on all parts and labor
5 years parts and labor on cutting cylinders
Fellowes warrants this product to be free from
defects in material and workmanship for a period of
ninety (90) days from the date of purchase by the
original consumer. At it’s option, Fellowes will repair
or replace without charge for material or labor, any
component found to be defective during the
warranty period. Additionally, the cutting cylinders
are warranted for 5 years from the original
purchase date and will be replaced without charge
for material or labor if found by Fellowes to be
defective.
6
Warranty Exclusions
The parties agree that the buyer’s sole and
exclusive remedy against Fellowes shall be for the
repair or replacement of defective parts as provided
herein. The buyer agrees that no other remedy
(including, but not limited to, incidental or
consequential damages for lost profits, lost sales,
injury to property or any other incidental or
consequential loss) shall be available to him. This
warranty shall NOT apply and is void under the
following circumstances:
1. When this product or any part thereof has been
subjected to accident, alteration, abuse, or misuse.
2. When the original Model and Serial Number Plate has
been altered, effaced or removed.
3. When repair or service covered under this warranty
(other than routine maintenance as described in the
Owner’s Manual) has been performed by personnel
without the express written consent of Fellowes.
4. When the product has been used pursuant to any
verbal or written rental, lease or loan agreement.
This warranty described herein shall be
in lieu of any other warranty, expressed
or implied, including, but not limited to,
any implied warranty of merchantability
or fitness for a particular purpose. Any
representations or promises inconsistent
with or in addition to this warranty are
unauthorized and shall not be binding
upon Fellowes.
Contact For Service:
United States
Australia
Canada
United Kingdom
Japan
Benelux
Italy
Germany
France
1-800-955-0959
(In Melbourne) (03) 9330-3211
(Outside Melbourne) 1-800-331-177
1-800-665-4339
01302-885 331
+81-3-5496-2401
+31-(0)347-377988
+39-071730041
+49-5131-49770
+33-(0)4-72-08-25-45
1789 Norwood Avenue • Itasca, Illinois 60143-1095
630-893-1600 • Customer Service 1-800-955-0959
http://www.fellowes.com
®
Australia
Benelux
Tullamarine, Vic Vianen, NL
Canada
Markham, Ont.
France
Rennes, I-V
Germany
Garbsen, Han.
Italy
Camerano, AN
Japan
Tokyo
Poland
Warsaw
United Kingdom
Doncaster, S. Yorks.
© 2000 Fellowes Printed in U.S.A. Part No. 34274