Fellowes 225CI/225I Paper Shredder User Manual

POWERSHRED 225Ci/225i
®
Please read these instructions before use.
Do not discard: keep for future reference.
Quality Office Products Since 1917
ENGLISH
Models 225Ci/225i
H.
A.
B.
I.
J.
C.
L.
D.
E.
F.
K.
KEY
A.SafeSense® Technology B.Paper/card entry
C.CD entry
D.Door
E. Basket (paper)
F. Basket (CD)
G.Casters (4)
H.Disconnect power switch
1. OFF
2. ON
I. Sheet capacity indicator
J. See safety instructions
K. Shipping bolts (wing nuts)
To be removed prior
to operation
L. Control Panel and LEDs
1. Reverse
2. ON/OFF
3. Forward
4. Auto
5. Door open (red)
6. Bin full (red)
7. Remove paper (red)
8. SafeSense® indicator (yellow)
G.
CAPABILITIES
Will shred: Paper, credit cards, CD/DVD, staples and small paper clips
Will not shred: Adhesive labels, continuous form paper, transparencies, newspaper,
cardboard, large paper clips, folders, X-rays or plastic other than noted above
Paper shred size:
Cross-Cut (225Ci)................................5/32 inches x 1-1/2 inches (3.9mm x 38mm)
Strip Cut (225i)......................................................................... 7/32 inches (5.8mm)
Maximum:
Sheets per pass.....................................................................................................20*
CDs/Cards per pass.................................................................................................1*
Paper entry width.......................................................................... 9 inches (230mm)
*8.5”x11”, 20lb., (75g) paper at 120V, 60 Hz, 6Amps; heavier paper, humidity or
other than rated voltage may reduce capacity. Recommended
daily usage rates: 5000 sheets; 200 cards; 10 CDs.
Fellowes SafeSense® shredders are designed to be operated in office environments ranging
between 50 – 80 degrees Fahrenheit (10 – 26 degrees Celsius) and 40 – 80% relative humidity.
IMPORTANT SAFETY INSTRUCTIONS — Read Before Using!
15
15
15
2
• Keep away from children and pets. Keep hands away from paper
entry. Always set to off or unplug when not in use.
• Keep foreign objects – gloves, jewelry, clothing, hair, etc. – away
from shredder openings. If object enters top opening, switch to
Reverse ( ) to back out object.
• Never use aerosol products, petroleum based lubricants or other
flammable products on or near shredder. Do not use canned air
on shredder.
• Do not use if damaged or defective. Do not disassemble shredder.
Do not place near or over heat source or water.
• Operation, maintenance, and service requirements are covered in
the instruction manual. Read the entire instruction manual before
operating shredders.
• This shredder has a Disconnect Power Switch (H) that must be in the ON (I)
position to operate shredder. In case of emergency, move switch to OFF (O)
position. This action will stop shredder immediately.
• Avoid touching exposed cutting blades under shredder head.
• Use only designated entry for CDs/cards. Keep fingers away from CD entry.
• Do not put foreign objects in paper entry.
• Shredder must be plugged into a properly grounded wall outlet or socket of
the voltage and amperage designated on the label. The grounded outlet or
socket must be installed near the equipment and easily accessible. Energy
converters, transformers, or extension cords should not be used with
this product.
• FIRE HAZARD – Do NOT shred greeting cards with sound chips or batteries.
• For indoor use only.
BASIC SHREDDING OPERATION
3
2
1
5
4
6
C-2
25
C-2
25
or
C-2
25
or
AUTO
AUTO
Plug in and put disconnect Press ( ) ON to activate
power switch in ON
(I) position
Feed paper/card straight
into paper entry and
release
When finished
shredding set to
OFF ( )
Hold CD/card at edge, and feed into center of
entry and release
Do nothing and
shredder will go
automatically to sleep
mode after 2 minutes
of inactivity
www.fellowes.com features an extensive on-line support section with a number of self-service options
Advanced product features
Jam Proof System
Eliminates paper jams and powers
through tough jobs
Sleep Mode
Energy saving feature shuts down automatically
after 2 minutes of no shredding activity
Patented SafeSense® Technology
Stops shredding immediately when hands
touch the paper entry
JAM PROOF SYSTEM OPERATION*
Eliminates paper jams and powers through tough jobs.
Advanced Jam Prevention- Electronically
measures paper thickness to prevent paper jams:
1
2
Up to RED: Too many
sheets have been inserted.
3
Remove several sheets until
indicator is below red.
Continue 100% Jam
Proof Shredding
Up to YELLOW: Productivity
is optimized.
Up to GREEN: More sheets
can be added.
If a misfeed
occurs:
All indicators light up and
shredder pauses for 3-6 seconds
If
illuminates after paper has been
reversed, press reverse and remove paper.
Otherwise, regular shredding will resume.
Wait for flashing to stop after automatic correction
is complete. Regular shredding will resume.
*100% Jam Proof when used in accordance with user manual
SAFESENSE® TECHNOLOGY OPERATION
SLEEP MODE OPERATION
Stops shredding immediately when hands touch the paper opening.
Energy saving feature shuts down the shredder after
2 minutes of inactivity
WHEN IN SLEEP MODE
SET-UP AND TESTING
2
1
3
4
2
1
3
C-2
25
C-2
25
C-2
25
C-2
25
AUTO
AUTO
Turn the shredder ON
( ) to activate SafeSense®
or
C-2
25
Touch test area and
look for the SafeSense®
indicator to illuminate
SafeSense® is active and
working properly
If hand is held on SafeSense®
area more than 2 seconds
shredder will shut off
In sleep mode
To get out of sleep mode
touch control panel
AUTO
insert paper
3
ENGLISH
Models 225Ci/225i
PRODUCT MAINTENANCE
Cleaning Auto-Start Infrared Sensors
Paper detection sensors are designed for maintenance free operation. However, on rare occasions the sensors may become blocked by paper dust causing the motor to run
even if there is no paper present
(Note: two paper detection sensors are located in the center of the paper entry).
TO CLEAN THE SENSORS
1
2
4
3
C-2
25
C -2
2 5
AUTO
AUTO
Turn off and unplug
shredder
Locate Auto-start
infared sensor
AUTO
Dip cotton swab in
rubbing alcohol
Using cotton swab, wipe
away any contamination
from the paper sensors
OILING SHREDDER
All cross-cut shredders require oil for peak performance. If not oiled, a machine may experience diminished sheet capacity, intrusive
noise when shredding and could ultimately stop running. To avoid these problems, we recommend you oil your shredder each time you
empty your waste bin.
FOLLOW OILING PROCEDURE BELOW AND REPEAT TWICE
2
1
C-2
25
AUTO
AUTO
*Apply oil across entry
Press and hold forward
( ) 2-3 seconds
*Only use a non-aerosol vegetable oil in long nozzle container such as Fellowes 35250
PREVENTIVE MAINTENANCE & ACCESSORIES
TROUBLESHOOTING
A
B
C
D
15
A.Door Open Indicator: The shredder will not run if the cabinet door is open. When illuminated, close the
door to resume shredding.
B. Bin Full Indicator: When illuminated, the shredder waste bin is full and needs to be emptied. Use Fellowes
waste bag 36054.
C. Remove Paper Indicator: When illuminated, press reverse ( ) and remove paper.
Reduce paper quantity to an acceptable amount and refeed into paper entry.
D.SafeSense® Indicator: If hands are too close to the paper entry, the SafeSense® indicator will illuminate
and the shredder will stop shredding. If SafeSense® is active for 3 seconds, the shredder will automatically
turn off and the user must press the power button on the control panel to resume shredding.
Self Cleaning Cycle: Shredder periodically cycles in forward and reverse lasting 3-6 seconds (225Ci only).
Go to Support Section at www.fellowes.com or see back page of manual for useful telephone numbers.
4
POWERSHRED 225Ci/225i
®
Questions or Concerns?
www.fellowes.com
Troubleshooting
Registration
Manuals
Customer Service & Support
Troubleshooting
Replacement parts
General questions
Canada+1-800-665-4339
Mexico+1-800-234-1185
United States
+1-800-955-0959
LIMITED PRODUCT WARRANTY
Limited Warranty: Fellowes, Inc. (“Fellowes”) warrants the parts of the machine to be free of
defects in material and workmanship and provides service and support for 2 years from the date
of purchase by the original consumer. Fellowes warrants the cutting blades of the machine to
be free from defects in material and workmanship for the lifetime of the shredder.If any part is
found to be defective during the warranty period, your sole and exclusive remedy will be repair
or replacement, at Fellowes’ option and expense, of the defective part. This warranty does not
apply in cases of abuse, mishandling, failure to comply with product usage standards, shredder
operation using an improper power supply (other than listed on the label), or unauthorized
repair. Fellowes reserves the right to charge the consumers for any additional costs incurred by
©2012 Fellowes, Inc. Part No. 406777
Fellowes to provide parts or services outside of the country where the shredder is initially sold
by an authorized reseller. ANY IMPLIED WARRANTY, INCLUDING THAT OF MERCHANTABILITY OR
FITNESS FOR A PARTICULAR PURPOSE, IS HEREBY LIMITED IN DURATION TO THE APPROPRIATE
WARRANTY PERIOD SET FORTH ABOVE. In no event shall Fellowes be liable for any consequential
or incidental damages attributable to this product. This warranty gives you specific legal rights.
The duration, terms, and conditions of this warranty are valid worldwide, except where different
limitations, restrictions, or conditions may be required by local law. For more details or to obtain
service under this warranty, please contact us or your dealer.