Instruction manual | Fellowes 69Cb Paper Shredder User Manual

POWERSHRED 73Ci
®
Please read these instructions before use.
Do not discard: keep for future reference.
Quality Office Products Since 1917
A.
B.
C.
ENGLISH
F.
Model 73Ci
G.
KEY
A.See safety instructions
B.Paper entry
C.SafeSense® Technology
D.Pullout bin
E.Casters
F. Disconnect power switch
1. OFF
2. ON
D.
G. Control Panel and LEDs
1. Reverse (blue)
2. ON/OFF (blue)
3. Forward (blue)
4. Bin full (red)
5. Bin open (red)
6. SafeSense® indicator (yellow)
7. Remove Paper (red)
8. Overheat (red)
G.
E.
• Control panel features multi-touch back-lit controls
• When shredder is off, control panel will not be visible
CAPABILITIES
Will shred: Paper, credit cards, staples, small paper clips and CD/DVDs
Will not shred: Adhesive labels, continous form paper, transparencies, newspaper,
cardboard, large paper clips, laminates, file folders, X-rays or plastic other than noted
above
Paper shred size:
Cross-Cut....................................................................5/32 in. x 1-1/2 in. (4mm x 38mm)
Maximum:
Sheets per pass............................................................................................................ 12*
CDs/Cards per pass........................................................................................................ 1*
Paper entry width............................................................................................9” (230mm)
*8.5”x11”, 20lb., (75g) paper at 120V, 60 Hz, 4Amps; heavier paper, humidity
or other than rated voltage may reduce capacity. Recommended daily usage rates:
300 sheets, 25 credit cards; 10 CD/DVDs
12 sheets per pass.
Fellowes SafeSense® shredders are designed to be operated in home and office environments ranging
between 50 – 80 degrees Fahrenheit (10 – 26 degrees Celsius) and 40 – 80% relative humidity.
IMPORTANT SAFETY INSTRUCTIONS — Read Before Using!
15
15
• Operation, maintenance, and service requirements are covered in the instruction
manual. Read the entire instruction manual before operating shredders.
• Keep away from children and pets. Keep hands away from paper entry. Always set
to off or unplug when not in use.
• Keep foreign objects – gloves, jewelry, clothing, hair, etc. – away from shredder
openings. If object enters top opening, switch to Reverse ( ) to back out object.
• Never use aerosol products, petroleum based lubricants or other flammable
products on or near shredder. Do not use canned air on shredder.
• Do not use if damaged or defective. Do not disassemble shredder.
Do not place near or over heat source or water.
15
• This shredder has a Disconnect Power Switch (F) that must be in the ON ( )
position to operate shredder. In case of emergency, move switch to OFF (O)
position. This action will stop shredder immediately.
• Avoid touching exposed cutting blades under shredder head.
• Shredder must be plugged into a properly grounded wall outlet or socket of the
voltage and amperage designated on the label. The grounded outlet or socket
must be installed near the equipment and easily accessible. Energy converters,
transformers, or extension cords should not be used with this product.
• FIRE HAZARD – Do NOT shred greeting cards with sound chips or batteries.
• For indoor use only.
• Unplug shredder before cleaning or servicing.
Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. NOTE: This equipment
has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Increase the separation between the equipment and receiver. • Consult the dealer or an experienced radio/TV technician for help.
BASIC SET UP
CASTER INSTALLATION
1
2
3
4
5
17
AUTO
BASIC SHREDDING OPERATION
PAPER OR CD/CARD
Continuous operation:
10-minute maximum
NOTE: Shredder runs briefly
after each pass to clear entry.
Continuous operation beyond
10-minutes will trigger
20-minute cool down period.
1
2
3
4
5
or
Plug in and put disconnect power switch in ON (I) position
Press ( )ON to
activate (blue)
Feed paper straight into
paper entry and release
Hold CD/card at edge,
feed right side of entry
and release
When finished
shredding set
to OFF ( )
ADVANCED PRODUCT FEATURES
Jam Proof System
Eliminates paper jams and powers
through tough jobs.
Energy Saving System
Optimal energy efficiency
100% of the time – in use
and out of use.
Patented SafeSense® Technology
Stops shredding immediately when
hands touch the paper opening
JAM PROOF SYSTEM OPERATION*
Eliminates paper jams and powers through tough jobs.
1
Advanced Jam Prevention- Electronically
measures paper thickness to prevent paper jams:
Up to RED: Too many
sheets have been inserted.
2
3
Remove several sheets until
indicator is below red.
Continue 100% Jam
Proof Shredding
Up to YELLOW: Productivity
is optimized.
Up to GREEN: More sheets
can be added.
If a misfeed
occurs:
All indicators light up and
shredder pauses for 3-6 seconds
Wait for flashing to stop after automatic correction
is complete. Regular shredding will resume.
If
illuminates after paper has been
reversed, press reverse and remove paper.
Otherwise, regular shredding will resume.
*100% Jam Proof when used in accordance with user manual
ENERGY SAVING SYSTEM
SAFESENSE® TECHNOLOGY
Stops shredding immediately when hands
touch the paper opening.
SET-UP AND TESTING
1
2
3
Optimal energy efficiency 100% of the
time – in use and out of use.
• Saves energy in four ways: energy-efficient electronics, jam prevention, standby mode and
sleep mode.
• Sleep Mode shuts down shredder after 2 minutes of inactivity.
WHEN IN SLEEP MODE
1
Turn the shredder ON
( ) to activate SafeSense®
Touch test area and
look for the SafeSense®
indicator to illuminate
2
3
or
SafeSense is active and
working properly
®
In sleep mode
For more information about all of Fellowes Advanced Product Features go to www.fellowes.com
To get out of sleep mode
touch control panel
insert paper
ENGLISH
Model 73Ci
PRODUCT MAINTENANCE
OILING SHREDDER
CLEANING AUTO-START INFRARED SENSORS
All cross-cut shredders require oil for peak performance. If not oiled, a
machine may experience diminished sheet capacity, intrusive noise when
shredding, and could ultimately stop running. To avoid these problems, we
recommend you oil your shredder each time you empty your waste bin.
Paper detection sensors are designed for maintenance free operation. However, on rare occasions the sensors
may become blocked by paper dust causing the motor to run even if there is no paper present.
(Note: two paper detection sensors are located in the center of the paper entry).
FOLLOW OILING PROCEDURE BELOW AND REPEAT TWICE
1
TO CLEAN THE SENSORS
2
1
*Apply oil across entry Press and hold forward
( ) 2-3 seconds
Turn off and unplug
shredder
2
3
4
Locate Auto-start
infared sensor
Dip cotton swab in
rubbing alcohol
Using cotton swab, wipe
away any contamination
from the paper sensors
*Only use a non-aerosol vegetable oil in long
nozzle container such as Fellowes 35250
Go to Support Section at www.fellowes.com or see back page of manual for useful telephone numbers.
15
TROUBLESHOOTING
Overheat Indicator: When the Overheat Indicator is illuminated, the shredder has exceeded its maximum operating temperature and needs to cool down. This
indicator will remain illuminated and the shredder will .not operate for the duration of the recovery time. See Basic Shredding Operation for more information about
the continuous operation and recovery time for this shredder.
Bin Open: The shredder will not run if the bin is open. When illuminated, close the bin to resume shredding.
Bin Full: When illuminated, the shredder waste bin is full and needs to be emptied. Use Fellowes waste bag 36052.
Remove Paper: When illuminated, press reverse (
) and remove paper. Reduce paper quantity to an acceptable amount and refeed into paper entry.
SafeSense® Indicator: If hands are too close to the paper entry, the SafeSense® indicator will illuminate and the shredder will stop shredding. If SafeSense®
is active for 3 seconds, the shredder will automatically turn off and the user must press the power button on the control panel to resume shredding.
LIMITED PRODUCT WARRANTY
Limited Warranty: Fellowes, Inc. (“Fellowes”) warrants the parts of the machine to be free of
defects in material and workmanship and provides service and support for 1 year from the date
of purchase by the original consumer. Fellowes warrants the cutting blades of the machine to
be free from defects in material and workmanship for 5 years from the date of purchase by the
original consumer. If any part is found to be defective during the warranty period, your sole and
exclusive remedy will be repair or replacement, at Fellowes’ option and expense, of the defective
part. This warranty does not apply in cases of abuse, mishandling, failure to comply with product
usage standards, shredder operation using an improper power supply (other than listed on the
label), or unauthorized repair. Fellowes reserves the right to charge the consumers for any
additional costs incurred by Fellowes to provide parts or services outside of the country where the
shredder is initially sold by an authorized reseller. ANY IMPLIED WARRANTY, INCLUDING THAT OF
MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE, IS HEREBY LIMITED IN DURATION
TO THE APPROPRIATE WARRANTY PERIOD SET FORTH ABOVE. In no event shall Fellowes be liable
for any consequential or incidental damages attributable to this product. This warranty gives you
specific legal rights. The duration, terms, and conditions of this warranty are valid worldwide,
except where different limitations, restrictions, or conditions may be required by local law. For
more details or to obtain service under this warranty, please contact us or your dealer.
POWERSHRED 73Ci
®
Questions or Concerns?
www.fellowes.com
Troubleshooting
Registration
Manuals
Customer Service & Support
Troubleshooting
Replacement parts
General questions
Canada+1-800-665-4339
Mexico+1-800-234-1185
United States
©2012 Fellowes, Inc. Part No. 406883
+1-800-955-0959
Download PDF

advertising