I N S TA L L AT I O N

I N S TA L L AT I O N
I N S TA L L AT I O N
& OPERATION
MANUAL
SL100IMP
SLIM LINE SIREN
SPEAKER,
MOUNT
SL100IMP
SLIM LINE SIREN SPEAKER,
MOUNT
CONTENTS:
Introduction .................................. 2
Installation & Mounting ................. 2
Parts List ...................................... 3
Warranty ...................................... 4
IMPORTANT:
Read all instructions and warnings before installing and using.
INSTALLER:
INSTALLER: This manual must be delivered to the end user of this equipment.
Introduction
The SL100IMP is a high output siren speaker designed to mount behind the grill of the 2000 Impala. This
highly effective warning device employs a mathematically designed speaker for maximum sound volume
whether used as a siren or public address system.
!
WARNING!
Sirens are an integral part of an effective audio/visual emergency warning system. However,
sirens are only short range secondary warning devices. The use of a siren does not insure that
all drivers can or will observe or react to an emergency warning signal, particularly at long
distances or when either vehicle is traveling at a high rate of speed. Sirens should only be used
in a combination with effective warning lights and never relied upon as a sole warning signal.
Never take the right of way for granted. it is your responsibility to be sure you can proceed safely
before entering an intersection, driving against traffic, or responding at a high rate of speed.
The effectiveness of this warning device is highly dependent upon correct mounting and wiring.
Read and follow the manufacturer's instruction before installing or using this device. The
vehicle operator should check the equipment daily to insure that all features of the device
operate correctly.
To be effective, sirens must produce high sound levlels that potentially can inflict hearing
damage. installers should be warned to wear hearing protection, clear bystanders from the
area and not to operate the siren indoors during testing. Vehicle operators and occupants
should assess their exposure to siren noise and determine what steps, such as consultation
with professionals or use of hearing proection should be implemented to protect their hearing.
This equipment is intended for use by authorized personnel only. It is the user's responsibility
to understand and obey all laws regarding emergency warning devices. The user should check
all applicable city, state and federal laws and requlations.
Public Safety Equipment, Inc., assumes no liability for any loss resulting from the use of this
warning device.
Proper installation is vital to the performance of the siren and the safe operation of the
emergency vehicle. It is important to recognize that the operator of the emergency vehicle is
under psychological and physiological stress caused by the situation. The siren system should
be installed in such a manner as to: A) Not reduce the acoustical performance of the system.
B) Limit as much as practical the noise level in the passenger compartment of the vehicle. C)
Place the controls within convenient reach of the operator so that he can operate the system
without losing eye contact with the roadway,
Emergency warning devices often require high electrical voltage and/or currents. Properly
protect and use caution around live electrical connections. Grounding or shorting of electrical
connections can cause high current arcing, which can cause personal injury and/or severe
vehical damage, including fire.
PROPER INSTALLATION COMBINED WITH OPERATOR TRAINING IN THE PROPER
USE OF EMERGENCY WARNING DEVICES IS ESSENTIAL TO INSURE THE SAFETY OF
EMERGENCY PERSONNEL AND THE PUBLIC.
Installation & Mounting
For easier installation, remove the speaker from the bracket. The bracket mounts to the top of the radiator
wall.
1 . Remove the access panel in front of the radiator.
2 . Locate the three center holes in the front of radiator cross support.
3 . Attach speaker bracket to cross support at hole locations with
three SMS 5/16 X ¾” ZC HEX HD Screws.
4. Connect speaker wiring to siren amplifier following siren installations.
Reinstall access panel.
2
MOUNT WITH 3 SMS 5/16 X 3/4" ZC HEX HD
SCREWS PART NO. 15736
BRACKET PART NO. S82947
SIREN SPEAKER PART NO. 3473
3
WARRANTY
This product was tested and found to be operational at the time of manufacture. Provided this product is
installed and operated in accordance with the manufacturer's recommendations, Public Safety Equipment
guarantees all strobe reflector assemblies and all other parts and components for a period of 1 year from the date
of purchase or delivery, whichever is later. Units demonstrated to be defective within the warranty period will be
repaired or replaced at the factory service center at no cost.
Use of a lamp or other electrical load of a wattage higher than installed or recommended by the factory, or
use of inappropriate or inadequate wiring or circuit protection causes this warranty to become void. Failure or
destruction of the product resulting from abuse or unusual use and/or accidents is not covered by this warranty.
Use of non-PSE components and assemblies may cause damage to the system and/or personal injury, and voids
all warranties on PSE systems and components.
PSE shall in no way be liable for other damages including consequential, indirect or special damages
whether loss is due to negligence or breach of warranty.
PSE MAKES NO OTHER EXPRESS OR IMPLIED WARRANTY INCLUDING, WITHOUT LIMITATION, WARRANTIES OF FITNESS OR MERCHANTABILITY, WITH RESPECT TO THIS PRODUCT.
PRODUCT RETURNS
In order to provide you with faster service, if you are going to return a product for
repair or replacement*, please contact our factory to obtain a Return Goods Authorization
Number (RGA number) before you ship the product to Code 3, Inc. Write the RGA number
clearly on the package near the mailing label. Be sure you use sufficient packing materials
to avoid damage to the product being returned while in transit.
*Code 3, Inc. reserves the right to repair or replace product at its discretion. Code 3, Inc. assumes no responsibility or liability for expenses
incurred for the removal and/or reinstallation of products requiring service and/or repair.
Problems or Questions? Call The Electronics Technical Assistance HOTLINE - (314) 996-2800
www.code3pse.com
Public Safety Equipment, Inc.
10986 N. Warson Road
St. Louis, Missouri 63114-2029—USA
Ph. (314) 426-2700 Fax (314) 426-1337
Code 3 is a registered trademarks of Public Safety Equipment, Inc.
Revision 1, 08/06 - Instruction Book Part No. T15800
©2000 Public Safety Equipment, Inc. Printed in USA
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement