Specifications | Franklin R536 QSG Network Router User Manual

Table of Contents
BLINK Mobile Hotspot R536 QSG
Care and Maintenance
2
Part 1. Getting to know the R536
1.1 Package Contents
2
1.2 Hardware Features of the R536
2
Part 2. Setting up the R536
2.1 Charging the battery
3
2.2 Battery Tips
4
Part 3. Using the R536
3.1 Connecting the R536
5
3.2 Opening the Browser Interface
5
Part 4. LED Overview, Technical Specifications, Regulatory and Safety Information,
Warranty, Trademarks & Copyright
Thank you for choosing the Blink R536.
Note
This manual briefly explains the preparation, installation process and safety
4.1 LED Overview
7
4.2 Technical Specification
7
4.3 Safety Information
7
4.4 Warranty
8
4.5 Trademarks
10
4.6 Copyright
10
precautions for using R536 router.
We recommend you read this manual before using the R536.
Ver.R536-TTQ01_EN
1
Care and Maintenance
Part 1. Getting to know the R536
It is normal for your wireless device to get warm when you use it.
1.1 Package Contents
Use your wireless device and accessories with care in clean environment.
Keep the wireless device away from open flame or dusty environments.
• Blink R536 Mobile Hotspot
Protect your device and accessories from water and vapor and keep them dry.
• QSG (Quick Start Guide)
Do not drop, throw or bend your device.
• USB Power Adapter
Clean your device with a piece of damp and soft antistatic cloth.
• Carrying Pouch
Do not use any chemical agents (such as alcohol and benzene), chemical
• Li-ion 1,350mAh battery
detergents or powder to clean the device.
Do not leave your device or accessories in significantly high or low
1.2 Hardware Features of the R536
temperature environments.
Use only manufacturer approved accessories and parts.
Contact an authorized service center in regard to device or accessories
abnormality.
Do not dismantle or tamper with the device or accessories. Dismantling or
tampering will these items will void the product’s warranty.
Power button
Micro USB port
2
Ver.R536-TTQ01_EN
Air-vent
2. Insert the battery by lining up the gold contact points on the battery with the gold
contact points in the device’s battery compartment. Then press down gently until
the battery is seated.
3. Replace the battery cover and gently press down while sliding the cover until it
locks into place.
Factory Reset Button
Part 2. Setting up the R536
4. Connect the micro USB end of the A/C Power Adapter to the micro USB port of
the device.
2.1 Charging the battery
1. The battery compartment is located on the bottom of the device.
Slide open the battery compartment door by firmly pressing in the direction of the
arrow below.
Ver.R536-TTQ01_EN
3
Note
When charging your battery, keep it near room temperature.
• You must have a fully charged battery the first time you use the R536.
Never expose batteries to temperatures below 32°F (0°C) or above 113°F (45°C).
• After the first use, you may use the device while it is connected to the A/C Never leave the device in an unattended vehicle due to uncontrollable temperatures
adapter.
that may be outside the recommended temperature range for this device.
• When using battery power, the device lasts up to 3 hours (when connected to a
single device only).
you notice a change in your battery life, it is probably time to purchase a new
• The battery will discharge at a faster rate as more devices are connected to it.
battery.
It is normal for batteries to gradually weaken and require longer charging times. If
2.2 Battery Tips
Warning
Use only Blink approved or Franklin Wireless approved batteries and chargers with
your device.
Failure to use a Blink approved or Franklin Wireless approved battery and charger
may increase the risk that your device will overheat, catch fire, and/or explode
resulting in property damage, serious bodily injury, and/or death.
Battery life can vary based on the network, signal strength, temperature, features,
and accessories you use.
If you connect your device to your computer using a USB data cable, the battery
will charge.
It normally takes at least 3 hours to fully charge the battery with an A/C adapter.
New batteries or batteries stored for a long time may take more time to charge.
4
Ver.R536-TTQ01_EN
Part 3. Using the R536
2. Select “BLINK XXXX” as your wireless network and enter the default network key,
“12345”.
3.1 Connecting the R536
Note
Note
For optimal performance it’s recommend that the R536 is oriented vertically in a The last 4 digits, ‘XXXX’ of the SSID are the last four digits of your MAC address. You
standing position (as shown to the below).
can find the MAC address of your R536 on the label under the battery.
3. Click Connect
3.2 Opening the Browser Interface
1. Open your web browser and enter http://192.168.5.1 or
http://WIMAX_AP.hotspot into the address window.
2. Click the Login button on the right top of the browser. The message will open to
require administrative ID & Password. The default ID and Password is admin/admin.
When you press the power button:
The R536 power LED should light up.
A solid green battery LED of indicates if the device is charged over 40%.
1. Turn on the R536 and ensure the WiFi is enabled on your PC or laptop. You can
view your available wireless networks by going through the control panel, network
connections or system tray (lower right hand corner of your screen).
Ver.R536-TTQ01_EN
5
3. The Browser Interface screen will open.
Type the administrative ID and password into the Login box and click ok.
Part 4. LED Overview, Technical Specifications, Regulatory and
Safety Information, Warranty, Trademarks & Copyright
6
Ver.R536-TTQ01_EN
4.1 LED Overview
4.2 Technical Specification
Your device has the following Power/Battery/WiMAX/WiFi LEDs.
LED Color
State
No Light
1
Power
No power
Solid
Flash : 4MB/ SDRAM : 16MB
RF Band
WIMAX 2.5GHz Support
WIMAX : 35Mbps downlink / 4Mbps uplink
Data Rate
Solid
Battery level over 40%
Operating temperature
Orange
Solid
Battery level under 40%
Humidity
Solid
Battery level under 20%
Storage Temperature
Slow Blinking
Turning on
Fast Blinking
Battery level under 5%
Wi-Fi : 54Mbps
0°C to 45°C
5 ~ 95%
-25°C to 45°C
Running time : 3Hrs (When fully charged)
Operating time
Standby time : 10Hrs
Connected but no activity
LED indicators
Power / Battery / WIMAX / WiFi
Solid
Not connected
Battery and charging
Li-ion 1,350mAh, 3.7V, Rechargeable
Blinking
Initializing
Power
AC Power Adapter 5V/2A
Blinking
Data activity
Solid
Ready
Blinking
Activity and the blinking
Red
Green
WiFi
Memory
Green
No Light
4
About 70.5g (battery included), 2.48 oz
Turning on
Battery
WiMAX
Weight
Slow blinking
Red
3
90mm x 50mm x 15mm (3.54 x 1.97 x 0.59 inch)
Power on
Blue
2
Size (H/W/D)
Blue
Blink
every 1 sec.
4.3 Safety Information
speed is up to data speed
Body Worn Operation
Power saving mode
Important safety information regarding radio frequency radiation (RF) exposure.
To ensure compliance with RF exposure guidelines the device must be used with a
minimum of 20cm separation from the body.
Ver.R536-TTQ01_EN
7
Failure to observe these instructions could result in your RF exposure exceeding the warranty extends to consumers who purchase the product in the Trnidad&Tobago
relevant guideline limits.
and it’s not transferable or assignable. This warranty does not apply to:
(a) Product subject to abnormal use or conditions, accident, mishandling, neglect,
Regulatory Information (FCC Statement)
unauthorized alteration, misuse, improper installation or repair or improper storage;
FCC Equipment Authorization ID: R2NSWR-8225
(b) Products whose mechanical serial number or electronic serial number has been
removed, altered, or defaced;
This device complies with Part 15 of the FCC Rules. Operation is subject to the (c) Damage from exposure to moisture, humidity, excessive temperature or extreme
following two conditions: (1) this device may not cause harmful interference, and environment conditions;
(2) this device must accept any interference received, including interference that (d) Damage resulting from connection to, or use of any accessory or other product
may cause undesired operation.
not approved or authorized by the company;
* This device should be installed and operated with a minimum distance of 20 cm (e) Defects in appearance, cosmetic, decorative or structural items such as framing
between the radiator and your body.
and non-operative parts;
(f) Product damaged from external causes such as fire, flooding, dirt, sand, weather
4.4 Warranty
conditions, battery leakage, blown fuse, theft or improper usage of any electrical
source.
Manufacturer’s Limited One-Year Warranty:
The Company disclaims liability for removal or reinstallation of the product, for
geographic coverage, for inadequate signal reception by the antenna or for
Franklin Wireless warrants to the original retail purchaser of this device, that communications range or operation of the cellular system as a whole.
should the product or any part thereof, during normal consumer usage conditions, When sending your wireless device to Franklin Wireless’ authorized distributions for
be defective in material or workmanship that results in product failure within the repair or service, please note that any personal data or software stored on the
first twelve (12) month period from the date of purchase, such defects will be device may be inadvertently erased or altered. Therefore, we strongly recommend
repaired or replaced, with a new or refurbished product at the Company’s you make a back up copy of all data and software contained on your device before
discretion, without charge for parts and labor directly related to the defect(s). This submitting it for repair or service. This includes all contact lists, downloads (i.e.
8
Ver.R536-TTQ01_EN
third-party software applications, games and graphics) and any other data added to No person or representative is authorized to assume for the Company any liability
your device. Franklin Wireless is not responsible for and does not guarantee other than expressed herein in connection with the sale of this product.
restoration of any third-party software, personal information or memory data Some states or provinces do not allow limitations on how long an implied warranty
contained in, stored on, or integrated with any wireless device, whether under lasts on the exclusion or limitation of incidental or consequential damage so the
warranty or not, returned to Franklin Wireless’ authorized distributors for repair or above limitation or exclusions may not apply to you. This Warranty gives you specific
service. To obtain repairs or replacement within the terms of this Warranty, the legal rights, and you may also have other rights, which vary from state to state or
product should be delivered with proof of Warranty coverage (e.g. dated bill of province to province.
sale), the consumer’s return address, daytime phone number and/or fax number
and complete description of the problem, transportation prepaid, to the Company Franklin’s Authorized Service Center Address:
at the address shown below or to the place of purchase for repair or replacement 5440 Morehouse Dr.STE 1000
processing. In addition, for reference to an authorized Warranty station in your San Diego, CA 92121
area, please call (800)959-3558 in the United States.
The extent of the company’s liability under this warranty is limited to the repair or
replacement provided above and, in no event, shall the company’s liability exceed
the purchase price paid by purchaser for the product.
Any implied warranties, including any implied warranty of merchant ability or
fitness for a particular purpose, shall be limited to the duration of this written
warranty. Any action for breach of any warranty must be brought within a period of
18 months from date of original purchase, but in no case shall the company be
liable for a special consequential or incidental damages for breach of this or any
other warranty, express or implied, whatsoever. The company shall not be liable for
the delay in pending service under this warranty or loss of use during the time the
produce is being repaired or replaced.
Ver.R536-TTQ01_EN
9
4.5 Trademarks
Blink and the logo are trademarks of Blink.
Franklin Wireless and the Franklin Wireless logo are trademarks of Franklin
Wireless.
Windows is a registered trademark of Microsoft Corporation.
4.6 Copyright
ⓒ2010 Franklin. Franklin and the logo are trademarks of Franklin.
ⓒ2010 Blink. Blink and the logo are trademarks of Blink
Other marks are the property of their respective owners.
10
Ver.R536-TTQ01_EN
Download PDF

advertising