Grizzly Industrial G4816, G4817, G4818, G4819 bandsaw Instructions
Below you will find brief information for bandsaw G4816, bandsaw G4817, bandsaw G4818, bandsaw G4819. This instruction manual will guide you through the process of installing ball bearing guides on your bandsaw. It covers important steps like removing the blade, installing the new guides, and adjusting them to ensure safe and efficient operation.
Advertisement
Advertisement
Advertisement
Key features
- Ball bearing guides
- Precise blade adjustment
- Improved blade life
- Safe and efficient operation
- Easy installation
- Adjustable bearing guides
- Eccentric shaft for fine-tuning
- Thumb screws for secure fastening
- Hex bolts for tight spaces
Frequently asked questions
Follow steps 1-4 of the instructions, removing the old guides and installing the new ball bearing guides in their place.
Loosen the thumb screws, rotate the eccentric shaft until the bearing touches the blade, and then tighten the thumb screws. Repeat for both upper and lower guides.
Replace the thumb screws with hex bolts, making sure not to overtighten.
The backup bearing is mentioned in your bandsaw manual. Refer to those instructions for detailed steps on how to reset it.