JBL Venue Series Stereo System User Manual

®
JBL VENUE™
TOUR, MONITOR, ARENA,
STAGE, STADIUM, VOICE,
BALCONY
OWNER’S GUIDE
JBL VENUE™
For more than 60 years, JBL has been providing audio equipment for concert
halls, recording studios and movie theaters around the world and has become
the hands-down choice of leading recording artists and sound engineers.
With the JBL Venue Series, innovative technologies such as titanium-laminatedome tweeters, EOS™ waveguides and PolyPlas™ transducer reinforcement are
available to you. Enjoy!
UNPACKING THE SPEAKERS
If you suspect damage from transit, report it immediately to your dealer. Keep
the shipping carton and packing materials for future use.
NOTE: A JBL powered subwoofer will add impact and realism to both
music and film soundtracks. Contact your JBL dealer for recommendations
on subwoofer models for your application.
JBL Subwoofer
(optional)
Left
Front
Channel
Right
Front
Channel
Center
Channel
PLACEMENT
NEVER drag the speaker to move it, as this will damage the spikes, the
feet and/or the wood cabinet itself. Always lift the speaker and carry it to its
new location.
CAUTION: Floorstanding (tower) loudspeakers have a high center
of gravity and may become unstable and tip over during events such as
earthquakes, or if rocked, tipped or improperly positioned. If this is a concern,
these speakers should be anchored to the wall behind them, using the same
procedures and hardware customary for anchoring bookcases and wall
units. The customer is responsible for proper installation and proper selection
of hardware.
Couch
Left
Surround
Channel
Left Rear
Channel
Center Rear
Channel
Right
Surround
Channel
Right Rear
Channel
STEREO
Before deciding where to place your speakers, survey your room and think
about placement, keeping the following points in mind, using Figure 1 as a
guide:
• For best results, place the speakers 6'– 8' (1.5m–2.5m) apart.
• Position each speaker so that the tweeter is approximately at ear level.
Figure 2. This overhead view shows a typical home theater plan. Left/right rear
channels are for a 7-channel system. The center rear channel is for a 6-channel system.
JBL Subwoofer
(optional)
• Generally, bass output will increase as the speaker is moved closer to a wall
or corner.
• Refer to “Home Theater” below if you also plan to use the speakers for
home theater reproduction.
Left
Channel
Right
Channel
Right Rear
Channel
Left Rear
Channel
Listening Position
Figure 1. Experiment with speaker placement to obtain the best bass level and stereo
imaging in your room.
HOME THEATER
For front-channel use, place one speaker on the left and another on the right,
along either side of the television monitor. Since the speakers are magnetically
shielded, you can place them near the TV without worrying about the field distorting the TV picture.
For surround-channel use, place speakers on bookshelves or stands alongside
the listening position. Tour and Balcony are also wall-mountable. Final placement depends on room acoustics, availability of space and your listening preference (Figures 2 and 3).
In 6- or 7-channel configurations, place the rear channel(s) behind the listening
position, as shown in Figures 2 and 3.
2
Center Rear
Channel
Figure 3. This figure shows an alternate layout, which may be more suitable for some
rooms. Left/right rear channels are for a 7-channel system. The center rear channel is
for a 6-channel system.
INSTALLING FEET
Balcony, Tour, Monitor, Arena
The supplied self-adhesive rubber feet may be attached to the bottom corners
of your speakers to protect your furniture.
Place pads here
Place pads here
WALL-MOUNTING
Tour
The Venue Series Tour may be wall-mounted. The customer is responsible for
proper selection and use of mounting hardware (available through hardware
stores), to properly and safely wall-mount the speakers. These products are not intended for ceiling mounting.
Adjustable wall-mounting brackets are included.
Balcony
Important Safety Notes
• Proper selection of mounting hardware and installation of the wall brackets
are the responsibility of the customer.
Figure 4. This figure shows how to connect bare wires to the terminals.
• This product is not intended for ceiling mounting.
Two No. 8 round-head or pan-head screws should be used per loudspeaker.
The screw head should be between 5/16 inch (8mm) and 1/4 inch (6.3mm) in
diameter, and the screw should be at least 2 inches (50mm) in length.
STANDARD CONNECTION
When installing screws in any wall, always use properly selected wall
anchors. Attach two of the four self-adhesive rubber pads that came with the
Balcony loudspeaker to the back of the enclosure in the two bottom corners
so that the cabinet is spaced evenly from the wall. Select a suitable mounting
location on a wall. (The ceiling is not a suitable mounting location.)
Drill two pilot holes, appropriately sized for the specific self-tapping screw or
wall anchor that you will be using. The holes should be 8 inches (203mm)
apart. See Figure 1. The holes should be 3/4" (19mm) below where you want
the top of the enclosure to be positioned. Use a carpenter’s level to ensure
that the holes are even and that the speaker will mount on the level.
Install the two screws into either a wooden wall stud or anchor, and tighten
them until the back of each screw head is about 1/8 inch (3mm) from the wall.
See Figure 2. Install the loudspeaker by slowly moving the cabinet toward the
screws so that the screw heads clear the larger circular portion of the two
keyholes. Once both screw heads have entered the keyholes, the loudspeaker
should gently be lowered onto the screw shafts. Check that the loudspeaker is
firmly locked onto the screws by gently pulling the speaker down and forward.
See Chart
1/8"
(3mm)
WIRING THE SYSTEM
IMPORTANT: Make sure all equipment is
turned off before making any connections.
For speaker connections, use a high-quality speaker wire with polarity coding.
The side of the wire with a ridge or other coding is usually considered positive
polarity (i.e., +).
NOTE: If desired, consult your local JBL dealer about speaker wire and
connection options.
The speakers have coded terminals that accept a variety of wire connectors.
The most common connection is shown in Figure 4.
To ensure proper polarity, connect each + terminal on the back of the amplifier
or receiver to the respective + (red) terminal on each speaker, as shown in
Figure 5. Connect the – (black) terminals in a similar way. See the owner’s
guides that were included with your amplifier, receiver and television to
confirm connection procedures.
Figure 5. Wiring diagram shows polarity connections for one channel of a stereo or
home theater system.
FINAL ADJUSTMENTS
Check the speakers for playback, first by setting the system volume control
to a minimum level, and then by applying power to your audio system. Play a
favorite music or video segment and increase the system volume control to
a comfortable level.
NOTE: You should hear balanced audio reproduction across the entire frequency spectrum. If not, check all wiring connections or consult the authorized JBL dealer from whom you purchased the system for more help.
The amount of bass you hear and the stereo-image quality will be affected by a
number of different factors, including the room’s size and shape, the construction materials used to build the room, the listener’s position relative to the
speakers, and the position of the speakers in the room.
Listen to a variety of music selections and note the bass level. If there is too
much bass, move the speakers away from nearby walls. Conversely, if you
place the speakers closer to the walls, there will be more bass output.
CARE OF YOUR SPEAKER SYSTEM
Each JBL Venue Series enclosure has a wood-grain-vinyl finish that does not
require any routine maintenance. When needed, use a soft cloth to remove
any fingerprints or dust from the enclosure or grille.
NOTE: Do not use any cleaning products or polishes on the cabinet
or grille.
IMPORTANT: Do not reverse polarities
(i.e., + to – or – to +) when making connections. Doing so will cause poor imaging
and diminished bass response.
3
SPECIFICATIONS
TOUR
MONITOR
ARENA
STAGE
Frequency Response (–3dB)
70Hz – 20kHz
68Hz – 20kHz
50Hz – 20kHz
47Hz – 20kHz
Max. Recommended Amplifier Power*
100W
125W
125W
150W
Power Handling (Continuous/Peak)
50W/100W
60W/240W
70W/280W
80W/320W
Sensitivity (2.83V/1m)
86dB
86dB
88dB
90dB
Nominal Impedance
8 Ohms
8 Ohms
8 Ohms
8 Ohms
Crossover Frequency
3000Hz
3000Hz
4000Hz
600Hz, 3500Hz
Low-Frequency Transducer
4" (102mm) PolyPlas,™
shielded
5" (130mm) PolyPlas,™
shielded
6" (170mm) PolyPlas,™
shielded
6" (170mm) PolyPlas,™
shielded
Midrange Transducer
NA
NA
NA
4" (100mm) PolyPlas,™
shielded
High-Frequency Transducer
3/4" (19mm) Titaniumlaminate dome, shielded,
EOS™ waveguide
3/4" (19mm) Titaniumlaminate dome, shielded,
EOS™ waveguide
3/4" (19mm) Titaniumlaminate dome, shielded,
EOS™ waveguide
3/4" (19mm) Titaniumlaminate dome, shielded,
EOS™ waveguide
Dimensions With Grille (H x W x D)
9-1/2" x 6-3/4" x 5-5/8"
241mm x 171mm x 143mm
10-7/8" x 6" x 8-5/8"
275mm x 153mm x 219mm
15" x 9" x 11-1/4"
381mm x 229mm x 286mm
34-3/4" x 9" x 13-1/8"
883mm x 229mm x 333mm
Weight per Speaker
4.6 lb/2.1kg
7 lb/3.2kg
15 lb/6.8kg
31.2 lb/14.5kg
STADIUM
VOICE
BALCONY
Frequency Response (–3dB)
36Hz – 20kHz
70Hz – 20kHz
65Hz – 20kHz
Max. Recommended Amplifier Power*
225W
150W
100W
Power Handling (Continuous/Peak)
110W/440W
75W/300W
50W/200W
Sensitivity (2.83V/1m)
91dB
90dB
86dB
Nominal Impedance
8 Ohms
8 Ohms
8 Ohms
Crossover Frequencies
300Hz, 4000Hz
3500Hz
Low-Frequency Transducers
Dual 8" (200mm) PolyPlas,
shielded
Dual 5" (130mm) PolyPlas,
shielded
4" (100mm) PolyPlas,™
shielded
Midrange Transducer
4" (100mm) PolyPlas,™
shielded
NA
NA
High-Frequency Transducer
3/4" (19mm) Titaniumlaminate dome, shielded,
EOS™ waveguide
3/4" (19mm) Titaniumlaminate dome, shielded,
EOS™ waveguide
3/4" (19mm) Titaniumlaminate dome, shielded,
EOS™ waveguide
Dimensions With Grille
(H x W x D)
40-1/4" x 9-7/8" x 15-3/4"
1022mm x 251mm x 400mm
6-1/2" x 20-1/4" x 9-5/8"
165mm x 514mm x 244mm
10" x 10-1/8" x 6"
254mm x 257mm x 152mm
Weight per Speaker
43.5 lb/19.8kg
9.6 lb/4.4kg
8 lb/3.6kg
™
2000Hz
™
All features and specifications are subject to change without notice.
JBL and Harman International are trademarks of Harman International Industries,
Incorporated, registered in the United States and/or other countries. Venue, Pro Sound
Comes Home, EOS and PolyPlas are trademarks of Harman International Industries,
Incorporated.
* The maximum recommended amplifier power rating will ensure proper system headroom
to allow for occasional peaks. We do not recommend sustained operation at these
maximum power levels.
Declaration of Conformity
We, Harman Consumer Group International
2, route de Tours
72500 Château du Loir
France
declare in own responsibility that the products described
PRO SOUND COMES HOME™
in this owner’s manual are in compliance with technical
®
JBL Consumer Products, 250 Crossways Park Drive, Woodbury, NY 11797 USA
8500 Balboa Boulevard, Northridge, CA 91329 USA
2, route de Tours, 72500 Château du Loir, France
516.255.4JBL (4525) (USA only) www.jbl.com
standards:
EN 61000-6-3:2001
EN 61000-6-1:2001
© 2005 Harman International Industries, Incorporated. All rights reserved.
Part No. 406-000-05323-E
Laurent Rault
Harman Consumer Group International
Château du Loir, France 11/05