(1)
4-279-074-11(1)
Quick Setup Guide
BDV-L800
©2011 Sony Corporation Printed in Malaysia
English
1
Setting up the speakers
1. Connect the speaker cords to the subwoofer.
Rear of the front speaker Rear panel of the subwoofer Rear of the front speaker
2
Connect your TV and other components
1. Connect a High Speed HDMI cable to your TV.
Depending on the jacks on your TV, select the video and audio connection method.
4. Bring together the cables (except the FM wire antenna (aerial)), guide them through the slot at the right of the main unit,
behind the clamp (), and through the slot at the bottom of the main unit.
Thread the FM wire antenna (aerial) through the small indentation at the rear of the main unit.
HDMI
FM wire antenna (aerial)
Red (Front right speaker (R))
White
(Front left speaker (L))
2. Remove the panel cover from the main unit.
Press the panel cover at () gently, then slide it out to the side.
High Speed HDMI cable*
* Not supplied
2. Connect a High Speed HDMI cable to your set-top box, game console or digital satellite receiver.
HDMI
5. Attach the panel cover to the rear of the main unit.
Put the left edge of the lower part of the panel cover on (), align the bottom projection of the panel cover with (), and then slide it inward until it clicks into place.
FM wire antenna (aerial)
3. Insert the wireless transceivers into the main unit and subwoofer.
Wireless transceiver
High Speed HDMI cable*
* Not supplied
3. Plug the connector of the AC adapter into the DC IN 14V connector on the rear of the main unit.
Thread the AC power cord (mains lead) through the gap on the main unit by securing it behind the tabs, guide it through the
slot at the left of the main unit, behind the clamp (), and through the slot at the bottom of the main unit.
6. Attach the stand cover to the rear of the main unit.
Align both edges of lower part of the stand cover with the guides on the stand (), and then slide the stand cover down gently.
Wireless transceiver
3
Perform “Easy Setup”
Do not insert a disc before performing the “Easy Setup”.
1. Insert batteries into the remote.
2. Connect the AC power cords (mains leads) of the main unit and subwoofer.
3. Press on the main unit to turn the system on.
After the subwoofer turns on, the LINK/STANDBY indicator () turns green and the wireless transmission is activated.
4. Turn on the TV, and switch the input selector on your TV so that system screens like the ones below appear on the TV screen.
Starting up “Easy Setup” screen
4. Position the speakers.
Tabs
5. Perform basic settings by following the on-screen instructions
in “Easy Setup” using /// and .
1
4
7
2
5
8
0
3
6
9
///,
[Easy Setup is now complete.] appears when “Easy Setup” is complete.