OMEGA DPG5000 pressure gauge User's Guide

Below you will find brief information for Pressure Gauge DPG5000. This document describes the DPG5000 series pressure gauges. Features such as zero trimming and auto-tare are discussed, as well as optional peak hold, analog output, 4-20 mA transmitter and external power options. Re-calibration is required after replacing the 9-volt battery.

PDF Download
Document
OMEGA DPG5000 Pressure Gauge User's Guide | Manualzz

Advertisement

Advertisement

Advertisement

Key features

  • Zero Trimming
  • Auto-Tare Feature
  • Peak-Hold Feature
  • Analog Output
  • 4-20 mA Transmitter Option
  • External Power

Frequently asked questions

You can adjust the zero by turning the trimpot marked "Z" just to the left of the On/Off push button. An ideal zero is indicated by a reading of 000 with an intermittently flashing “-” sign.

When the gauge is turned on the display flashes for the first 4 seconds. If the On/Off button is pushed and held during this period, any existing reading will be re-set to zero. This allows the user to “TareOut” a starting weight in hydraulic weighing applications.

Remove the single screw at the top of the battery door. Remove the old battery, unplug the cable connector and replace with Eveready type 216 or equivalent. Replace the battery door and secure with the self-tapping screw.

This procedure requires a known pressure source of at least ±0.1% accuracy. Ensure the Gauge is at 0 psig (or vacuum if absolute), and adjust the zero. Apply full scale pressure to the pressure port and adjust the span (“S”) pot until the display reads the correct pressure. Re-check the zero and re-adjust the zero (“Z”) pot if required. Repeat until no further adjustment is required.
Preparing document for printing…
0%