Mitsubishi Electric GT14 50UCOV USB environmental protection cover, GT1455 QTBD(E), GT1450 QLBD(E) GOT User manual

USB Environmental Protection Cover GT14-50UCOV
The USB environmental protection cover GT14-50UCOV protects the
USB connector on the front face of GT1455-QTBD(E) and GT1450QLBD(E) (hereinafter referred to as "GOT") from dust, water, and oil.
The GOT is installed with the USB environmental protection cover at
factory shipment.
Replace when damage and deterioration are caused.
1. External Dimensions
34.7(1.37")
9.8
(0.39")
4.4
(0.18")
Unit: mm (inch)
2. Mounting Precautions
Make sure to turn off power of the GOT main unit before installing/
uninstalling the USB environmental protection cover.
For installation method of this product or cautions of use, refer to the
manual of the GT14 main unit offered separately.
Mar. 2012
JY997D44301C
MITSUBISHI ELECTRIC
CORPORATION
Made in Japan
3. USB Environmental Protection Cover Replacement
Procedure
1) Turn the GOT power off.
2) Disconnect the USB cable from the
GOT if one is connected.
3) Open the USB environmental protection
c ov er equipped w ith the GOT and
remove the mounting screws.
4) Remove the old USB
environmental protection cover from the
GOT to replace it with the new USB
environmental protection cover.
5) Fix the projection of the new USB
environmental protection cover to
be fitted into the hole of the GOT,
tighten the mounting screw in the
specified torque range, then install it
to the GOT.
Tighten the mounting screws in the
specified torque range.
Not doing so may cause a damage
or a drop.
Tightening torque 0.36 to 0.48 N•m
USB environmental
protection cover
Open
Mounting
screw
">