White-Rodgers 1F86-344 thermostat Installation and operation instructions

Below you will find brief information for thermostat 1F86-344. This thermostat is non-programmable, it includes simultaneous heat and cool setpoint storage, backlit display, temperature range from 45°F to 90°F, and a few other features. To use this thermostat, first you need to disconnect the power of the old thermostat. Then, identify each wire attached and detach carefully. After that, follow the provided wiring diagrams to connect the new thermostat and set the thermostat base to the wall.

PDF Download
Document
White-Rodgers 1F86-344 Installation Instructions | Manualzz

Advertisement

Advertisement

Advertisement

Key features

  • Simultaneous Heat/Cool Setpoint Storage
  • Pre-set Temperature Control
  • Backlit Display
  • LCD Displays Setpoint and Room Temperature
  • °F/°C Convertibility
  • Filter Replacement Run Time
  • Compressor Lockout
  • Temperature Display Adjustment

Frequently asked questions

This thermostat can be used with standard heat/cool or heat only systems, electric heat systems, gas or oil fired systems, gas systems with intermittent ignition devices (I.I.D.) and/or vent dampers, hydronic (hot water or steam) systems, single-stage heat pump systems (no auxiliary heat), and millivolt systems.

The electrical rating is 8 to 30 VAC 50/60 Hz. or D.C., 0.05 to 1.0 Amps (Load per terminal), and 1.5 Amps Maximum Total Load (All terminals combined).

To reset the thermostat, press and hold the 'up' and 'down' buttons, then move the SYSTEM switch from OFF to HEAT at the same time.
ALP: {x-default=https://manualzz.com/doc/2096637/white-rodgers-1f86-344-thermostat-installation-and-operat..., en=https://manualzz.com/doc/en/2096637/white-rodgers-1f86-344-thermostat-installation-and-operat..., es=https://manualzz.com/doc/es/2096637/white-rodgers-1f86-344-thermostat-installation-and-operat...}
Preparing document for printing…
0%