Tandberg Data RDX QuikStor Installation Guide
Below you will find brief information for RDX QuikStor. RDX QuikStor is a storage device that can be used to backup and restore data on your computer. It can be mounted in your PC's internal bay and connected via a USB cable. The installation guide provides step-by-step instructions for mounting, connecting, and using the RDX QuikStor.
advertisement
Power USB
Internal USB version
Installation Guide
1 Turn off the computer
2 Mount the RDX QUIKSTOR in the
PC. The Eject/Power LED should
be on the lower right. Secure the
unit by using the four mounting
screws provided.
3 Connect the USB and power cables
to the RDX QuikStor
4 Connect the USB cable to the host
PC mother board or USB HBA.
Pin 1 location is marked on the
cable connector with a triangle ( ).
Consult your motherboard/
HBA manual for the Pin 1 location
on the mating USB connector
5 Turn on the computer
+5VDC
DATA-
DATA+
GND
Key
1
9
2
10
PIN SIGNAL PIN SIGNAL
1 VCC 2 VCC
3 USB0- 4 USB1-
5 USB0+ 6 USB1+
7 GND
9 Key
8 GND
10 USBOC
Warning:
• Connecting the USB Cable incorrectly
to the PC will result in damage.
• Verify PIN layout on the motherboard
versus cable connector PIN OUT.
Product Registration
Register this product at www.tandbergdata.com/register
©2007 RDX is a registered trademark of ProStor Systems, Inc.
Part No. 433822-01 www.tandbergdata.com
advertisement
Key Features
- Internal USB Connection
- Secure mounting
- Easy to install
- Data backup and restore
- Compact design
Frequently Answers and Questions
How do I connect the RDX QuikStor to my computer?
What is the purpose of the Eject/Power LED?
Where can I find information on the Pin 1 location on the USB connectors?
Related manuals
advertisement